Data Sheet
June 2002
TMXF28155 Supermapper
155/51 Mbits/s SONET/SDH x28/x21 DS1/E1
99
Agere Systems Inc.
8 TMUX Registers
(continued)
Table 106. TMUX_RAISINH_CTL, Receive Low-Speed Control Parameters (R/W)
(continued)
Table 107. TMUX_LOSDETCNT, Receive Low-Speed Control Parameters (R/W)
Address
Bit
Name
Function
Reset
Default
0
0x4001C
4
TMUX_RLAISMON_AISINH
Receive Line AIS Monitor AIS Inhibit.
Control bit,
when set to a logic 1, inhibits the associated alarm
from causing AIS generation; otherwise, the associ-
ated failure causes AIS generation on all STS-1/AU-3
outputs as well as the assertion of AUTO_AIS out-
puts.
TMUX_RLOF_AISINH
Receive Loss-of-Frame AIS Inhibit.
Control bit,
when set to a logic 1, inhibits the associated alarm
from causing AIS generation; otherwise, the associ-
ated failure causes AIS generation on all STS-1/AU-3
outputs as well as the assertion of AUTO_AIS out-
puts.
TMUX_ROOF_AISINH
Receive High-Speed Out of Frame AIS Inhibit.
Control bit, when set to a logic 1, inhibits the associ-
ated alarm from causing AIS generation; otherwise,
the associated failure causes AIS generation on all
STS-1/AU-3 outputs as well as the assertion of
AUTO_AIS outputs.
TMUX_RHSLOS_AISINH
Receive High-Speed Loss-of-Signal AIS Inhibit.
Control bit, when set to a logic 1, inhibits the associ-
ated alarm from causing AIS generation; otherwise,
the associated failure causes AIS generation on all
STS-1/AU-3 outputs as well as the assertion of
AUTO_AIS outputs.
TMUX_RILOC_AISINH
Receive Input Loss-of-Clock AIS Inhibit.
Control
bit, when set to a logic 1, inhibits the associated alarm
from causing the assertion of the AUTO_AIS outputs;
otherwise, the associated failure causes assertion of
all AUTO_AIS output signals.
3
0
2
0
1
0
0
0
Address
Bit
Name
Function
Reset
Default
00
000
0x4001D
15:14
13:11
RSVD
Reserved.
TMUX_FORCEC2DEF[2:0]
Force TMUX_RPLMP Defects.
These bits (one for
each STS-1 in an STS-3) will force TMUX_RPLMP
defects on certain conditions as shown in
Table 536
on page 385
(STS Signal Label Defect Conditions).
TMUX_LOSDETCNT[10:0]
Loss-of-Signal Detection Count.
Control bits are the
number of consecutive all-0s/1s patterns detected to
declare LOS state in the unscrambled STS-3/STM-1
(AU-4) input frame. A value of 0x02D equals 2.3 μs
while a value of 0x798 equals 100 μs.
10:0
0x02D