- 您現在的位置：買賣IC網 > PDF目錄231501 > W972GG8JB-25 (WINBOND ELECTRONICS CORP) 256M X 8 DDR DRAM, 0.4 ns, PBGA60 PDF資料下載
參數資料
| 型號： | W972GG8JB-25 |
| 廠商： | WINBOND ELECTRONICS CORP |
| 元件分類： | DRAM |
| 英文描述： | 256M X 8 DDR DRAM, 0.4 ns, PBGA60 |
| 封裝： | 11 X 11.50 MM, ROHS COMPLIANT, WBGA-60 |
| 文件頁數： | 16/86頁 |
| 文件大?。?/td> | 1466K |
| 代理商： | W972GG8JB-25 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁當前第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁
W972GG8JB
Publication Release Date: Feb. 18, 2011
- 23 -
Revision A02
7.3.10 No-Operation Command
( CS ="L", RAS ="H", CAS ="H",
WE ="H", CKE, BA0, BA1, BA2, A0 to A14=Dont Care)
The No-Operation command simply performs no operation (same command as Device Deselect).
7.3.11 Device Deselect Command
( CS ="H", RAS , CAS ,
WE , CKE, BA0, BA1, BA2, A0 to A14=Dont Care)
The Device Deselect command disables the command decoder so that the RAS , CAS ,
WE and
Address inputs are ignored. This command is similar to the No-Operation command.
7.4
Read and Write access modes
The DDR2 SDRAM provides a fast column access operation. A single Read or Write Command will
initiate a serial read or write operation on successive clock cycles. The boundary of the burst cycle is
strictly restricted to specific segments of the page length.
The 32 Mbit x 8 I/O x 8 Bank chip has a page length of 1024 bits (defined by CA0 to CA9)
*. The page
length of 1024 is divided into 256 or 128 uniquely addressable boundary segments depending on
burst length, 256 for 4 bit burst, 128 for 8 bit burst respectively. A 4-bit or 8-bit burst operation will
occur entirely within one of the 256 or 128 groups beginning with the column address supplied to the
device during the Read or Write Command (CA0 to CA9). The second, third and fourth access will
also occur within this group segment. However, the burst order is a function of the starting address,
and the burst sequence.
A new burst access must not interrupt the previous 4 bit burst operation in case of BL = 4 setting.
However, in case of BL = 8 setting, two cases of interrupt by a new burst access are allowed, one
reads interrupted by a read, the other writes interrupted by a write with 4 bit burst boundary
respectively. The minimum CAS to CAS delay is defined by tCCD, and is a minimum of 2 clocks for
read or write cycles.
Note: Page length is a function of I/O organization and column addressing
32M bits × 8 organization (CA0 to CA9); Page Length = 1024 bits
7.4.1
Posted CAS
Posted CAS operation is supported to make command and data bus efficient for sustainable
bandwidths in DDR2 SDRAM. In this operation, the DDR2 SDRAM allows a CAS read or write
command to be issued immediately after the RAS bank activate command (or any time during the
RAS - CAS -delay time, tRCD, period). The command is held for the time of the Additive Latency (AL)
before it is issued inside the device. The Read Latency (RL) is controlled by the sum of AL and the
CAS Latency (CL). Therefore if a user chooses to issue a Read/Write command before the tRCDmin,
then AL (greater than 0) must be written into the EMR (1). The Write Latency (WL) is always defined
as RL -1 (Read Latency -1) where Read Latency is defined as the sum of Additive Latency plus CAS
Latency (RL = AL + CL). Read or Write operations using AL allow seamless bursts. (Example timing
waveforms refer to 10.11 and 10.12 seamless burst read/write operation diagram in Chapter 10)
7.4.1.1
Examples of posted CAS operation
Examples of a read followed by a write to the same bank where AL = 2 and where AL = 0 are shown
in Figures 14 and 15, respectively.
相關PDF資料 |
PDF描述 |
|---|---|
| WF512K32-150CJC | 512K X 32 FLASH 5V PROM MODULE, 150 ns, CQCC68 |
| W73B586A-09L | 32K X 18 CACHE SRAM, 9 ns, PQCC52 |
| WS512K32-100G4TM | 2M X 8 MULTI DEVICE SRAM MODULE, 100 ns, CQFP68 |
| WS512K32-35G4M | 2M X 8 MULTI DEVICE SRAM MODULE, 35 ns, CQFP68 |
| WS512K32-35G4Q | 2M X 8 MULTI DEVICE SRAM MODULE, 35 ns, CQFP68 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| W972GG8JB-25I | 制造商:Winbond Electronics Corp 功能描述:IC DDR2 SDRAM 2GBIT 2.5NS 制造商:Winbond Electronics Corp 功能描述:IC DDR2 SDRAM 2GBIT 2.5NS 80WBGA |
| W972GG8JB-3 | 制造商:Winbond Electronics Corp 功能描述:DRAM Chip DDR2 SDRAM 2G-Bit 256Mx8 1.8V 60-Pin WBGA 制造商:Winbond Electronics Corp 功能描述:IC DDR2 SDRAM 2GBIT 3NS |
| W9751G6IB-25 | 功能描述:IC DDR2-800 SDRAM 512MB 84-WBGA RoHS:是 類別:集成電路 (IC) >> 存儲器 系列:- 標準包裝:1,000 系列:- 格式 - 存儲器:EEPROMs - 串行 存儲器類型:EEPROM 存儲容量:4K (512 x 8) 速度:400kHz 接口:I²C，2 線串口 電源電壓:2.7 V ~ 5.5 V 工作溫度:-40°C ~ 85°C 封裝/外殼:8-SOIC（0.173"，4.40mm 寬） 供應商設備封裝:8-MFP 包裝:帶卷 (TR) |
| W9751G6JB | 制造商:WINBOND 制造商全稱:Winbond 功能描述:8M ? 4 BANKS ? 16 BIT DDR2 SDRAM |
| W9751G6JB-25 | 制造商:Winbond Electronics Corp 功能描述:512GB DDRII |
發布緊急采購，3分鐘左右您將得到回復。