TM Family Datasheet Page 24 of 81 June 2009 – " />
參數資料
型號: PI7C9X20505GPBNDE
廠商: Pericom
文件頁數: 17/81頁
文件大?。?/td> 0K
描述: IC PCIE PACKET SWITCH 256BGA
產品變化通告: Copper Wire Change 26/Sept/2011
標準包裝: 90
系列: GreenPacket™
應用: 封裝開關,5 端口/5 線道
接口: PCI Express
封裝/外殼: 256-BGA
供應商設備封裝: 256-PBGA(17x17)
包裝: 托盤
安裝類型: 表面貼裝
PI7C9X20505GP
5Port-5Lane PCI Express Switch
GreenPacket
TM Family
Datasheet
Page 24 of 81
June 2009 – Revision 1.5
Pericom Semiconductor
6 EEPROM INTERFACE AND SYSTEM MANAGEMENT BUS
The EEPROM interface consists of two pins: EECLK (EEPROM clock output) and EEPD (EEPROM bi-directional
serial data). The Switch may control an ISSI IS24C04 or compatible parts using into 512x8 bits. The EEPROM is
used to initialize a number of registers before enumeration. This is accomplished after PRST# is de-asserted, at
which time the data from the EEPROM is loaded. The EEPROM interface is organized into a 16-bit base, and the
Switch supplies a 7-bit EEPROM word address. The Switch does not control the EEPROM address input. It can
only access the EEPROM with address input set to 0.
The System Management Bus interface consists of two pins: SMBCLK (System Management Bus Clock input) and
SMBDATA (System Management Bus Data input/ output).
6.1
EEPROM INTERFACE
6.1.1 AUTO MODE EERPOM ACCESS
The Switch may access the EEPROM in a WORD format by utilizing the auto mode through a hardware sequencer.
The EEPROM start-control, address, and read/write commands can be accessed through the configuration register.
Before each access, the software should check the Autoload Status bit before issuing the next start.
6.1.2 EEPROM MODE AT RESET
During a reset, the Switch will automatically load the information/data from the EEPROM if the automatic load
condition is met. The first offset in the EEPROM contains a signature. If the signature is recognized, the autoload
initiates right after the reset.
During the autoload, the Bridge will read sequential words from the EEPROM and write to the appropriate registers.
Before the Bridge registers can be accessed through the host, the autoload condition should be verified by reading
bit [3] offset DCh (EEPROM Autoload Status). The host access is allowed only after the status of this bit is set to '0'
which indicates that the autoload initialization sequence is complete.
6.1.3 EEPROM SPACE ADDRESS MAP
15 – 8
7 – 0
BYTE OFFSET
EEPROM Signature (1516h)
00h
Vendor ID
02h
Device ID
04h
Extended VC Count / Link Capability / Switch Mode Operation / Interrupt pin for Port 1 ~ 4
06h
Subsystem Vender ID
08h
Subsystem ID
0Ah
Max_Payload_Size Support / ASPM Support / Role_Base Error Reporting / RefClk ppm
Difference
0Ch
Reserved
0Eh
PM Data for Port 0
PM Capability for Port 0
10h
PM Data for Port 1
PM Capability for Port 1
12h
PM Data for Port 2
PM Capability for Port 2
14h
PM Data for Port 3
PM Capability for Port 3
16h
PM Data for Port 4
PM Capability for Port 4
18h
Reserved
1Ah
相關PDF資料
PDF描述
PI7C9X20508GPBNDE IC PCIE PACKET SWITCH 256BGA
PI7C9X440SLBFDE IC PCIE-TO-USB 2.0 CTRLR 128LQFP
PI7C9X442SLBFDE IC PCIE-TO-USB2.0 SWIDGE 128LQFP
PI7C9X7952AFDE IC PCIE-TO-UART BRIDGE 128LQFP
PI7C9X7954AFDE IC PCIE-TO-UART BRIDGE 128LQFP
相關代理商/技術參數
參數描述
PI7C9X20508GPANDE 制造商:Pericom Semiconductor Corporation 功能描述:5-PORT, 8-LANE, GREENPACKET- PCIE PACKET SWITCH - Rail/Tube
PI7C9X20508GPBEVB 制造商:Pericom Semiconductor Corporation 功能描述:EVAL BOARD - Boxed Product (Development Kits)
PI7C9X20508GPBNDE 功能描述:外圍驅動器與原件 - PCI 5port 8lane PCIe PacketSwitch RoHS:否 制造商:PLX Technology 工作電源電壓: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:FCBGA-1156 封裝:Tray
PI7C9X20508GPNDE 制造商:Pericom Semiconductor Corporation 功能描述:5-PORT, 8-LANE, GREENPACKET- PCIE PACKET SWITCH - Trays
PI7C9X2G303ELAEVB 制造商:Pericom Semiconductor Corporation 功能描述:Switch IC Development Tools Eval Kit for PI7C9X2G303ELA