- 您現在的位置：買賣IC網 > PDF目錄383876 > T7256A Compliance with the New ETSI PSD Requirement PDF資料下載
參數資料
| 型號： | T7256A |
| 英文描述： | Compliance with the New ETSI PSD Requirement |
| 中文描述： | 符合新的ETSI PSD的要求 |
| 文件頁數： | 106/116頁 |
| 文件大?。?/td> | 1056K |
| 代理商： | T7256A |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁當前第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁第115頁第116頁
Data Sheet
January 1998
T7256 Single-Chip NT1 (SCNT1) Transceiver
102
Lucent Technologies Inc.
Questions and Answers
(continued)
Miscellaneous
(continued)
A53:
(continued)
Therefore, it is apparent that the conditions under which power is measured must be clearly specified. The
methods Lucent has used to evaluate typical and worst-case power consumption are based on our commit-
ment to provide our customers with accurate and reliable data. Measurements are performed as part of the
factory test procedure using automated test equipment. Bench top tests are performed in actual T7256-
based systems to correlate the automated test data with an actual implementation. A conservative margin is
then added to the test results for publication in our data sheets.
The following table provides power-consumption data for several scenarios so that knowledgeable customers
can fairly compare transceiver solutions. A baseline scenario is presented in the Case 1 column, and then
adders are listed in the Cases 2—6 columns to account for the worst-case condition listed in each column so
that an accurate worst-case figure can be determined based on the conditions that are present in a particular
application. Note that the tests were run at 5 V, so changes in the supply voltage will change the power
accordingly.
Table 45. Power Consumption
* Some 2B1Q silicon vendors specify power using a configuration in which the IC is active and transmitting into a 135
termination,
with no far-end transmitter attached. This configuration would cause an increase of 9 mW over the Case 1 column, instead of the
35 mW shown here. This highlights the importance of specifying measurement conditions accurately when making comparisons
between chip vendors' power numbers.
This is a worst-case number representing the state of the S/T-interface where the most +0/–0 transitions occur. In a real application,
this will be a transient state, as INFO 4 will occur as soon as synchronization is achieved. The average power consumed during a typ-
ical INFO 4, assuming a 50% mix of 1s and 0s in the B and D channels, would be approximately half this number, or 13 mW.
See the preceding table for a comparison of power dissipation with negligible capacitive loading on CKOUT. The 40 pF figure chosen
here is intended to represent a worst-case condition.
Q54:
What would cause the STLED indicator to flash sporadically at an 11 Hz rate
A54:
If the T7256 S/T-interface is operating over a long loop that is outside the range specified in the I.430/T1.605
standard, the T7256 may go into a state where it is constantly going in and out of synchronization. This
causes it to cycle between ANSI states H7 and H8, producing STLED state changes between 1 Hz flashing
and always on. When the S/T-interface loses synchronization, it takes about 96 ms before synchronization
can be reacquired. This 96 ms cycle, coupled with the STLED switching from always on to 1 Hz flashing, can
appear as 11 Hz or sporadic flashing, depending on how frequently S/T synchronization is being lost.
Variables
Baseline
Case 1
>3 kft,
26 awg
INFO 4
with all 1s
data
3-stated
Adders
Case 4
—
Case 2
0 kft*
Case 3
—
Case 5
—
Case 6
—
Loop Configuration
S/T State
—
INFO 2
—
—
—
CKOUT, MHz
(40 pF load)
Temperature (
°
C)
TDM Highway
Typical Power Consumption (mW)
—
—
15.36
—
—
25
—
—
35
—
—
26
—
—
22
85
—
5
—
Inactive
254
Active
3
相關PDF資料 |
PDF描述 |
|---|---|
| T7288 | CEPT/E1 Line Interface(CEPT/E1 線接口) |
| T7290A | DS1/T1/CEPT/E1 Line Interface(DS1/T1/CEPT/E1 線接口) |
| T7295-1 | E3 Integrated Line Receiver(E3 集成線接收器) |
| T7295-6 | DS3/SONET STS-1 Integrated Line Receiver(DS3/SONET STS-1 集成線接收器) |
| T7296 | Integrated Line Transmitter(集成PCM線傳送器) |
相關代理商/技術參數 |
參數描述 |
|---|---|
| T7257 | 制造商:TE Connectivity 功能描述: |
| T-726 | 制造商:RHOMBUS-IND 制造商全稱:Rhombus Industries Inc. 功能描述:ADSL Line Interface Transformers |
| T7263 | 制造商:TE Connectivity 功能描述: |
| T7263A | 制造商:Toshiba America Electronic Components 功能描述:T7263A |
| T7264 | 制造商:TE Connectivity 功能描述: |
發布緊急采購，3分鐘左右您將得到回復。