參數資料
型號： DS33ZH11+
廠商： Maxim Integrated Products
文件頁數： 109/172頁
文件大?。?/td> 0K
描述： IC MAPPER ETHERNET 100CSBGA
產品培訓模塊： Lead (SnPb) Finish for COTS
Obsolescence Mitigation Program
標準包裝： 7
應用： 數據傳輸
接口： 串行
電源電壓： 1.8V，2.5V，3.3V
封裝/外殼： 100-LFBGA，CSPBGA
供應商設備封裝： 100-CSBGA（10x10）
包裝： 托盤
安裝類型： 表面貼裝
DS33Z11 Ethernet Mapper
41 of 172
8.12.1 Full-Duplex Flow Control
In the software mode automatic flow control is enabled by default. The host processor can disable this
functionality with SU.GCR.ATFLOW. In hardware mode, the user must apply a logic high level to the AFCS pin to
enable automatic flow control. The flow control mechanism is governed by the high watermarks (SU.RQHT). The
SU.RQLT low threshold can be used as indication that the network congestion is clearing up. The value of
SU.RQLT does not affect the flow control. When the connection queue high threshold is exceeded the DS33Z11
will send a pause frame with the timer value programmed by the user. See Table 8-6 for more information. It is
recommended that 80 slots (80 by 64 bytes or 5120 bytes) be used as the standard timer value.
The pause frame causes the distant transmitter to “pause for a time” before starting transmission again. The
pause command has a multicast address 01-80-62-00-00-01. The high and low thresholds for the receive queue
are configurable by the user but it is recommended that the high threshold be set approximately 96 packets from
the maximum size of the queue and the low threshold 96 packets lower than the high threshold. The DS33Z11
will send a pause frame as the queue has crossed the high threshold and a frame is received. Pause is sent
every time a frame is received in the “high threshold state”. Pause control will only take care of temporary
congestion. Pause control does not take care of systems where the traffic throughput is too high for the queue
sizes selected. If the flow control is not effective the receive queue will eventually overflow. This is indicated by
SU.QCRLS.RQOVFL latched bit. If the receive queue is overflowed any new frames will not be received.
The user has the option of not enabling automatic flow control. In this case the thresholds and corresponding
interrupt mechanism to send pause frame by writing to flow control busy bit in the MAC flow control registers
SU.MACFCR.FCB, SU.GCR.JAME, and SU.MACFCR. This allows the user to set not only the watermarks but
also to decide when to send a pause frame or not based on watermark crossings.
On the receive side the user has control over whether to respond to the pause frame sent by the distant end (PCF
bit). Note that if automatic flow control is enabled the user cannot modify the FCE bit in the MAC flow control
register. On the Transmit queue the user has the option of setting high and low thresholds and corresponding
interrupts. There is no automatic flow control mechanism for data received from the Serial side waiting for
transmission over the Ethernet interface during times of heavy Ethernet congestion.
相關PDF資料
PDF描述
DS34C87TN/NOPB IC LINE DRIVER QUAD CMOS 16-DIP
DS34LV87TMX/NOPB IC LINE DVR QUAD CMOS DIF 16SOIC
DS34S132GN+ IC TDM OVER PACKET 676-BGA
DS34T102GN+ IC TDM OVER PACKET 484TEBGA
DS3501U+H IC POT NV 128POS HV 10-USOP
相關代理商/技術參數
參數描述
DS33ZH11+ 功能描述:網絡控制器與處理器 IC 10/100 ENETXPORT HMODE MAP IND RoHS:否 制造商:Micrel 產品:Controller Area Network (CAN) 收發器數量: 數據速率: 電源電流（最大值）:595 mA 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:PBGA-400 封裝:Tray
DS34 制造商:LUMILEDS 制造商全稱:LUMILEDS 功能描述:power light source Luxeon V Emitter
DS-3400D UK 制造商:TRUST 功能描述:DESKTOP WIRELESS OPTICAL TRUST
DS3404FP000 制造商:Thomas & Betts 功能描述:30A,PLG,3P4W,MG,404,3P480V
DS3404FP000/JG63 制造商:Thomas & Betts 功能描述:30A,CON,3P4W,MG,404,3P480V,JG63,SC
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*