- 您現在的位置：買賣IC網 > PDF目錄45202 > MB9AF312MPMC 32-BIT, FLASH, 40 MHz, RISC MICROCONTROLLER, PQFP80 PDF資料下載
參數資料
| 型號： | MB9AF312MPMC |
| 元件分類： | 微控制器/微處理器 |
| 英文描述： | 32-BIT, FLASH, 40 MHz, RISC MICROCONTROLLER, PQFP80 |
| 封裝： | 0.50 MM PITCH, PLASTIC, LQFP-80 |
| 文件頁數： | 46/114頁 |
| 文件大?。?/td> | 1357K |
| 代理商： | MB9AF312MPMC |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁當前第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁
37
ATmega48PA/88PA/168PA [DATASHEET]
9223F–AVR–04/14
10.6
Power-save Mode
When the SM2...0 bits are written to 011, the SLEEP instruction makes the MCU enter Power-save mode. This mode is
identical to power-down, with one exception:
If Timer/Counter2 is enabled, it will keep running during sleep. The device can wake up from either timer overflow or output
compare event from Timer/Counter2 if the corresponding Timer/Counter2 interrupt enable bits are set in TIMSK2, and the
global interrupt enable bit in SREG is set.
If Timer/Counter2 is not running, power-down mode is recommended instead of power-save mode.
The Timer/Counter2 can be clocked both synchronously and asynchronously in power-save mode. If Timer/Counter2 is not
using the asynchronous clock, the Timer/Counter oscillator is stopped during sleep. If Timer/Counter2 is not using the
synchronous clock, the clock source is stopped during sleep. Note that even if the synchronous clock is running in power-
save, this clock is only available for Timer/Counter2.
10.7
Standby Mode
When the SM2...0 bits are 110 and an external crystal/resonator clock option is selected, the SLEEP instruction makes the
MCU enter standby mode. This mode is identical to power-down with the exception that the oscillator is kept running. From
standby mode, the device wakes up in six clock cycles.
10.8
Extended Standby Mode
When the SM2...0 bits are 111 and an external crystal/resonator clock option is selected, the SLEEP instruction makes the
MCU enter extended standby mode. This mode is identical to power-save with the exception that the oscillator is kept
running. From extended standby mode, the device wakes up in six clock cycles.
10.9
Power Reduction Register
The power reduction register (PRR), see Section 10.11.3 “PRR – Power Reduction Register” on page 40, provides a method
to stop the clock to individual peripherals to reduce power consumption. The current state of the peripheral is frozen and the
I/O registers can not be read or written. Resources used by the peripheral when stopping the clock will remain occupied,
hence the peripheral should in most cases be disabled before stopping the clock. Waking up a module, which is done by
clearing the bit in PRR, puts the module in the same state as before shutdown.
Module shutdown can be used in idle mode and active mode to significantly reduce the overall power consumption. In all
other sleep modes, the clock is already stopped.
10.10 Minimizing Power Consumption
There are several possibilities to consider when trying to minimize the power consumption in an AVR controlled system. In
general, sleep modes should be used as much as possible, and the sleep mode should be selected so that as few as
possible of the device’s functions are operating. All functions not needed should be disabled. In particular, the following
modules may need special consideration when trying to achieve the lowest possible power consumption.
10.10.1 Analog to Digital Converter
If enabled, the ADC will be enabled in all sleep modes. To save power, the ADC should be disabled before entering any
sleep mode. When the ADC is turned off and on again, the next conversion will be an extended conversion. Refer to Section
24. “Analog-to-Digital Converter” on page 213 for details on ADC operation.
10.10.2 Analog Comparator
When entering Idle mode, the analog comparator should be disabled if not used. When entering ADC noise reduction mode,
the analog comparator should be disabled. In other sleep modes, the analog comparator is automatically disabled. However,
if the analog comparator is set up to use the internal voltage reference as input, the analog comparator should be disabled in
all sleep modes. Otherwise, the internal voltage reference will be enabled, independent of sleep mode. Refer to
Section 23. “Analog Comparator” on page 210 for details on how to configure the analog comparator.
相關PDF資料 |
PDF描述 |
|---|---|
| MB9AF312LPMC | 32-BIT, FLASH, 40 MHz, RISC MICROCONTROLLER, PQFP64 |
| MB9AF311NPMC | 32-BIT, FLASH, 40 MHz, RISC MICROCONTROLLER, PQFP100 |
| MB9AF316NPMC | RISC MICROCONTROLLER, PQFP100 |
| MB9AF314NPMC | RISC MICROCONTROLLER, PQFP100 |
| MB9AF312NPF | RISC MICROCONTROLLER, PQFP100 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MB9AF314LAPMC1-G-JNE2 | 制造商:FUJITSU 功能描述: |
| MB9AF314LAPMC-G-JNE2 | 制造商:Fujitsu 功能描述:Bulk |
| MB9AF314LAQN-G-AVE2 | 功能描述:ARM? Cortex?-M3 FM3 MB9A310A Microcontroller IC 32-Bit 40MHz 256KB (256K x 8) FLASH 64-QFN Exposed Pad (9x9) 制造商:cypress semiconductor corp 系列:FM3 MB9A310A 包裝:托盤 零件狀態:有效 核心處理器:ARM? Cortex?-M3 核心尺寸:32-位 速度:40MHz 連接性:CSIO，I2C，LIN，UART/USART，USB 外設:DMA，LVD，POR，PWM，WDT I/O 數:51 程序存儲容量:256KB（256K x 8） 程序存儲器類型:閃存 EEPROM 容量:- RAM 容量:32K x 8 電壓 - 電源（Vcc/Vdd）:2.7 V ~ 5.5 V 數據轉換器:A/D 9x12b 振蕩器類型:內部 工作溫度:-40°C ~ 105°C（TA） 封裝/外殼:64-VFQFN 裸露焊盤 供應商器件封裝:64-QFN 裸露焊盤（9x9） 標準包裝:260 |
| MB9AF314LPMC1-ESE1 | 制造商:FUJITSU 功能描述: |
| MB9AF314LPMC1-GE1 | 制造商:FUJITSU 功能描述: |
發布緊急采購，3分鐘左右您將得到回復。