參數資料
型號: MB9AF312MPMC
元件分類: 微控制器/微處理器
英文描述: 32-BIT, FLASH, 40 MHz, RISC MICROCONTROLLER, PQFP80
封裝: 0.50 MM PITCH, PLASTIC, LQFP-80
文件頁數: 36/114頁
文件大?。?/td> 1357K
代理商: MB9AF312MPMC
ATmega48PA/88PA/168PA [DATASHEET]
9223F–AVR–04/14
28
Figure 9-3. Crystal Oscillator Connections
9.5
Low Frequency Crystal Oscillator
The low-frequency crystal oscillator is optimized for use with a 32.768kHz watch crystal. When selecting crystals, load
capacitance and crystal’s equivalent series resistance, ESR must be taken into consideration. Both values are specified by
the crystal vendor. Atmel ATmega48PA/88PA/168PA oscillator is optimized for very low power consumption, and thus
when selecting crystals, see Table 9-7 for maximum ESR recommendations on 6.5pF, 9.0pF and 12.5pF crystals
Table 9-6.
Start-up Times for the Full Swing Crystal Oscillator Clock Selection
Oscillator Source / Power
Conditions
Start-up Time from Power-
down and Power-save
Additional Delay from
Reset
(VCC = 5.0V)
CKSEL0
SUT1...0
Ceramic resonator, fast rising
power
258CK
14CK + 4.1ms(1)
0
00
Ceramic resonator, slowly rising
power
258CK
14CK + 65ms(1)
0
01
Ceramic resonator, BOD
enabled
1KCK
14CK(2)
0
10
Ceramic resonator, fast rising
power
1KCK
14CK + 4.1ms(2)
0
11
Ceramic resonator, slowly rising
power
1KCK
14CK + 65ms(2)
1
00
Crystal Oscillator, BOD enabled
16KCK
14CK
1
01
Crystal Oscillator, fast rising
power
16KCK
14CK + 4.1ms
1
10
Crystal Oscillator, slowly rising
power
16KCK
14CK + 65ms
1
11
Notes: 1.
These options should only be used when not operating close to the maximum frequency of the device, and
only if frequency stability at start-up is not important for the application. These options are not suitable for
crystals.
2.
These options are intended for use with ceramic resonators and will ensure frequency stability at start-up.
They can also be used with crystals when not operating close to the maximum frequency of the device, and if
frequency stability at start-up is not important for the application.
C2
XTAL2 (TOSC2)
XTAL1 (TOSC1)
GND
C1
Table 9-7.
Maximum ESR Recommendation for 32.768kHz Crystal
Crystal CL (pF)
Max ESR [k
Ω](1)
6.5
75
9.0
65
12.5
30
Notes: 1.
Maximum ESR is typical value based on characterization
相關PDF資料
PDF描述
MB9AF312LPMC 32-BIT, FLASH, 40 MHz, RISC MICROCONTROLLER, PQFP64
MB9AF311NPMC 32-BIT, FLASH, 40 MHz, RISC MICROCONTROLLER, PQFP100
MB9AF316NPMC RISC MICROCONTROLLER, PQFP100
MB9AF314NPMC RISC MICROCONTROLLER, PQFP100
MB9AF312NPF RISC MICROCONTROLLER, PQFP100
相關代理商/技術參數
參數描述
MB9AF314LAPMC1-G-JNE2 制造商:FUJITSU 功能描述:
MB9AF314LAPMC-G-JNE2 制造商:Fujitsu 功能描述:Bulk
MB9AF314LAQN-G-AVE2 功能描述:ARM? Cortex?-M3 FM3 MB9A310A Microcontroller IC 32-Bit 40MHz 256KB (256K x 8) FLASH 64-QFN Exposed Pad (9x9) 制造商:cypress semiconductor corp 系列:FM3 MB9A310A 包裝:托盤 零件狀態:有效 核心處理器:ARM? Cortex?-M3 核心尺寸:32-位 速度:40MHz 連接性:CSIO,I2C,LIN,UART/USART,USB 外設:DMA,LVD,POR,PWM,WDT I/O 數:51 程序存儲容量:256KB(256K x 8) 程序存儲器類型:閃存 EEPROM 容量:- RAM 容量:32K x 8 電壓 - 電源(Vcc/Vdd):2.7 V ~ 5.5 V 數據轉換器:A/D 9x12b 振蕩器類型:內部 工作溫度:-40°C ~ 105°C(TA) 封裝/外殼:64-VFQFN 裸露焊盤 供應商器件封裝:64-QFN 裸露焊盤(9x9) 標準包裝:260
MB9AF314LPMC1-ESE1 制造商:FUJITSU 功能描述:
MB9AF314LPMC1-GE1 制造商:FUJITSU 功能描述: