參數資料
型號: ST7285C
廠商: 意法半導體
英文描述: 8-BIT MCU FOR RDS WITH 48K ROM, 3K RAM, ADC, TWO TIMERS, TWO SPIs, I2C AND SCI INTERFACES
中文描述: 8位微控制器48,000鐵路發展策略光盤,3K內存,ADC,兩個定時器,2個SPI,I2C和脊髓損傷接口
文件頁數: 67/117頁
文件大?。?/td> 748K
代理商: ST7285C
67/117
ST7285C
RDS FILTER (
Cont’d)
4.7.2 Functional Description
The RDS filter is of classical Switched Capacitor
type, comprising: an anti-aliasing filter, the SC-fil-
ter proper and a smoothing filter connected in cas-
cade. The block diagram is given inFigure 33.
The Filter peripheral is composed of the following
functional blocks:
Prefilter
. The anti-aliasing filter consists of a 2
nd
order Sallen-Key filter. The phase response in
the passband is linear. The cut-off frequency is
located at about 360KHz. The prefilter includes
an operational amplifier with a gain of 80 dB.
SC Filter
. The SC filter is a 8
th
order bandpass
filter. It comprises 4 cascaded biquads. The bi-
quads all have the same scheme and differ only
in their capacitor values. The switches are con-
trolled by a clock generator which produces non-
overlapping clock phases.
Buffer
. The output of the SC-Filter cannot be
connected to resistive loads, since this would se-
verely reduce its gain. A buffer is therefore con-
nected between the SC filter and the smoothing
filter.
Smoothing filter
. The smoothing filter connect-
ed to the Sc-filter (through the Buffer) is a simple
RC low pass filter. The output is connected to
RDSFIL pin (external connection) and to the
Comparator.
Comparator
. The comparator is connected to
the smoothing filter and is able to detect zero-
crossing in less than 125ns. The digital output of
the comparator is connected via a port to the
RDS demodulator.
D/A Converter
. A maximum offset of 1mV is al-
lowed on the comparator’s inputs. The offset
compensation is achieved as follows:
in a software selectable test mode, the input of
the filter is switched to RDSREF (=2.5V). The D/
A converter register (RDSFi1) is set to zero and
then incremented by software until the compara-
tor changes its sign.
Test Mode Selector
. This function is controlled
via 4 bits in the filter control register (RDS Fi2). It
selects the various test modes. (see next point).
– ST7 interface registers.
These are described
below.
RDS Fi1
Address 005Ah:
Read/Write Register
b7 = reserved.
b6 =
COMP
Comparator output (read only).
b5-0 =
AD5-AD0
Offset
correction
(1LSB=2mV).
value
output
by
D/A
RDS Fi2
Address 005Bh
Read/Write Register
b7-5 = reserved.
b4 =
PDB
Power down bit (1 = Run; 0 = Power-down)
b3-0 =
TM3-TM0
Mode select. Only Modes shown in the table below
are valid; other modes are reserved.
When the internal filter is switched off, the RDS-
COMP pin can be used as an input and to feed the
demodulator from an external filter.
7
6
5
4
3
2
1
0
-
COMP
AD5
AD4
AD3
AD2
AD1
AD0
7
6
5
4
3
2
1
0
-
-
-
PDB
TM3
TM2
TM1
TM0
TM3
0
0
TM2
0
0
TM1
0
1
TM0
0
1
Mode
filter off (reset state)
normal operating mode
offset compensation
mode
1
1
0
1
相關PDF資料
PDF描述
ST72T85A5Q6 8-BIT MCU FOR RDS WITH 48K ROM, 3K RAM, ADC, TWO TIMERS, TWO SPIs, I2C AND SCI INTERFACES
ST730C08L3 PHASE CONTROL THYRISTORS
ST730C08L3L PHASE CONTROL THYRISTORS
ST730C12L0 PHASE CONTROL THYRISTORS
ST730C12L0L PHASE CONTROL THYRISTORS
相關代理商/技術參數
參數描述
ST7-28B56 功能描述:電源變壓器 SPLIT BOBBIN HORZ MOUNT XFMR RoHS:否 制造商:Triad Magnetics 功率額定值:12 VA 初級電壓額定值:115 V / 230 V 次級電壓額定值:12 V / 24 V 安裝風格:SMD/SMT 一次繞組:Dual Primary Winding 二次繞組:Dual Secondary Winding 長度:2.5 in 寬度:2 in 高度:1.062 in
ST72A 制造商:DGS 功能描述:
ST72C104G1B6 功能描述:8位微控制器 -MCU Flash 4K SPI RoHS:否 制造商:Silicon Labs 核心:8051 處理器系列:C8051F39x 數據總線寬度:8 bit 最大時鐘頻率:50 MHz 程序存儲器大小:16 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:1.8 V to 3.6 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:QFN-20 安裝風格:SMD/SMT
ST72C104G1M1 制造商:STMicroelectronics 功能描述:8-BIT MICROCONTROLLER - Bulk
ST72C104G1M6 功能描述:8位微控制器 -MCU Flash 4K SPI RoHS:否 制造商:Silicon Labs 核心:8051 處理器系列:C8051F39x 數據總線寬度:8 bit 最大時鐘頻率:50 MHz 程序存儲器大小:16 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:1.8 V to 3.6 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:QFN-20 安裝風格:SMD/SMT