- 您現在的位置：買賣IC網 > PDF目錄383804 > SCANPSC110FSC (FAIRCHILD SEMICONDUCTOR CORP) SCAN Bridge Hierarchical and Multidrop Addressable JTAG Port (IEEE1149.1 System Test Support) PDF資料下載
參數資料
| 型號： | SCANPSC110FSC |
| 廠商： | FAIRCHILD SEMICONDUCTOR CORP |
| 元件分類： | 微控制器/微處理器 |
| 英文描述： | SCAN Bridge Hierarchical and Multidrop Addressable JTAG Port (IEEE1149.1 System Test Support) |
| 中文描述： | SPECIALTY MICROPROCESSOR CIRCUIT, PDSO28 |
| 封裝： | 0.300 INCH, MS-013, SOIC-28 |
| 文件頁數： | 10/25頁 |
| 文件大?。?/td> | 283K |
| 代理商： | SCANPSC110FSC |
www.fairchildsemi.com
10
S
Level 1 Protocol
(Continued)
FIGURE 7. Broadcast Addressing: Address Loaded into Instruction Register
FIGURE 8. Multi-Cast Addressing: Address Loaded into Instruction Register
Level 2 Protocol
Once the SCANPSC110F Bridge has been successfully
addressed and selected, its internal registers may be
accessed via Level-2 Protocol. Level-2 Protocol is compli-
ant to IEEE Std. 1149.1 TAP protocol with one exception: if
the SCANPSC110F is selected via the Broadcast or Multi-
Cast address, TDO
B
will always be 3-STATED. (The TDO
B
buffer must be implemented this way to prevent bus con-
tention.)
Upon being selected, (i.e., the SCANPSC110F Selection
controller transitions from the
Wait-For-Address
state to
one of the
Selected
states), each of the local scan ports
(LSP
1
, LSP
2
, LSP
3
) remains parked in one of the following
four TAP Controller states:
Test-Logic-Reset, Run-Test/
Idle, Pause-DR
, or
Pause-IR
and the active scan chain will
consist of: TDI
B
through the instruction register (or the
IDCODE register) and out through TDO
B
.
TDI
B
→
Instruction Register
→
TDO
B
The
UNPARK
instruction (described later) is used to insert
one or more local scan ports into the active scan chain.
Table 4 describes which local ports are inserted into the
chain, and in what order.
LEVEL 2 INSTRUCTION TYPES
There are two types of instructions (reference Table 5):
1. Instructions that insert a SCANPSC110F register into
the active scan chain so that the register can be cap-
tured or updated
(BYPASS, SAMPLE/PRELOAD,
EXTEST, IDCODE, MODESEL, MCGRSEL, LFSR-
SEL, CNTRSEL).
2. Instructions that configure local ports or control the
operation of the linear feedback shift register and
counter registers
(UNPARK, PARKTRL, PARKRTI,
PARKPAUSE, GOTOWAIT, SOFTRESET, LFSRON,
LFSROFF, CNTRON, CNTROFF).
These instructions,
相關PDF資料 |
PDF描述 |
|---|---|
| SCP-5453 | SOCKET,IC,16PIN,MACHINE TOOLED WIRE WRAP,0.3"WIDE,0.515"LEAD |
| SCP-6122 | POWER OPERATIONAL AMPLIFIER |
| SCS152 | HM Series Hermetically Sealed Basic Switch, Single Pole Double Throw Circuitry, 0.5 A at 28 Vdc, Integral Lever Actuator, Solder Termination |
| SCS152-IS | Small glass bead with axial leads |
| SCS152-IW | Small glass bead with axial leads |
相關代理商/技術參數 |
參數描述 |
|---|---|
| SCANPSC110FSCX | 功能描述:特定功能邏輯 SCAN JTAG Port RoHS:否 制造商:Texas Instruments 產品: 系列:SN74ABTH18502A 工作電源電壓:5 V 封裝 / 箱體:LQFP-64 封裝:Tube |
| SCANSTA101 | 制造商:NSC 制造商全稱:National Semiconductor 功能描述:Low Voltage IEEE 1149.1 STA Master |
| SCANSTA101_06 | 制造商:NSC 制造商全稱:National Semiconductor 功能描述:Low Voltage IEEE 1149.1 STA Master |
| SCANSTA101SM | 功能描述:接口 - 專用 RoHS:否 制造商:Texas Instruments 產品類型:1080p60 Image Sensor Receiver 工作電源電壓:1.8 V 電源電流:89 mA 最大功率耗散: 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:BGA-59 |
| SCANSTA101SM/NOPB | 功能描述:接口 - 專用 Low Vltg IEEE 1149.1 Sys Test Access RoHS:否 制造商:Texas Instruments 產品類型:1080p60 Image Sensor Receiver 工作電源電壓:1.8 V 電源電流:89 mA 最大功率耗散: 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:BGA-59 |
發布緊急采購，3分鐘左右您將得到回復。