- 您現在的位置：買賣IC網 > PDF目錄2000 > IDTSSTE32882KA1AKG (IDT, Integrated Device Technology Inc)IC REGISTERING CLK DRIVER 176BGA PDF資料下載
參數資料
| 型號： | IDTSSTE32882KA1AKG |
| 廠商： | IDT, Integrated Device Technology Inc |
| 文件頁數： | 1/75頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC REGISTERING CLK DRIVER 176BGA |
| 標準包裝： | 170 |
| 類型： | 時鐘緩沖器/驅動器，多路復用器 |
| PLL： | 是 |
| 主要目的： | 存儲器，DDR3，RDIMM |
| 輸入： | CMOS |
| 輸出： | CMOS |
| 電路數： | 1 |
| 比率 - 輸入:輸出： | 5:60 |
| 差分 - 輸入:輸出： | 是/是 |
| 頻率 - 最大： | 810MHz |
| 電源電壓： | 1.282 V ~ 1.575 V |
| 工作溫度： | 0°C ~ 70°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 176-TFBGA |
| 供應商設備封裝： | 176-CABGA（13.5x8） |
| 包裝： | 托盤 |
當前第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁
1.25V/1.35V/1.5V REGISTERING CLOCK DRIVER WITH PARITY TEST AND QUAD CHIP SELECT
1
SSTE32882KA1
7314/8
THE INFORMATION IN THIS DOCUMENT IS SUBJECT TO CHANGE WITHOUT NOTICE
DATASHEET
Advanced Information
1.25V/1.35V/1.5V REGISTERING CLOCK DRIVER WITH PARITY
TEST AND QUAD CHIP SELECT
SSTE32882KA1
Description
This 28-bit 1:2, or 26-bit 1:2 and 4-bit 1:1, registering clock
driver with parity is designed for 1.25V, 1.35V and 1.5V VDD
operation.
All inputs are 1.25,1.35V and 1.5V CMOS compatible, except the
reset (RESET) and MIRROR inputs which are LVCMOS. All
outputs are 1.25V,1.35V and 1.5V CMOS edge-controlled drivers
optimized to drive single terminated 25
Ω to 50Ω traces in DDR3
RDIMM applications, except the open-drain error (ERROUT)
output. The clock outputs (Yn and Yn) and control net outputs
QnCKEn, QnCSn and QnODTn are designed with a different
strength and skew to compensate for different loading and
equalize signal travel speed.
The SSTE32882KA1 has two basic modes of operation
associated with the Quad Chip Select Enable (QCSEN) input.
When the QCSEN input pin is open (or pulled high), the
component has two chip select inputs, DCS0 and DCS1, and two
copies of each chip select output, QACS0, QACS1, QBCS0 and
QBCS1. This is the "QuadCS disabled" mode. When the
QCSEN input pin is pulled low, the component has four chip
select inputs DCS[3:0], and four chip select outputs, QCS[3:0].
This is the "QuadCS enabled" mode. Through the remainder of
this specification, DCS[n:0] will indicate all of the chip select
inputs, where n=1 for QuadCS disabled, and n=3 for QuadCS
enabled. QxCS[n:0] will indicate all of the chip select outputs.
The SSTE32882KA1 includes a high-performance, low-jitter,
low-skew buffer that distributes a differential clock input (CK
and CK) to four differential pairs of clock outputs (Yn and Yn),
and to one differential pair of feedback clock outputs (FBOUT
and FBOUT). The clock outputs are controlled by the input
clocks (CK and CK), the feedback clocks (FBIN and FBIN), and
the analog power inputs (AVDD and AVSS). When AVDD is
grounded, the PLL is turned off and bypassed for test purposes.
The SSTE32882KA1 operates from a differential clock (CK and
CK). Data are registered at the crossing of CK going high, and
CK going low. The data is either driven to the corresponding
device outputs if exactly one of the DCS[n:0] input signals is
driven low.
Based on the control register settings, the device can change its
output characterisitics to match different DIMM net topologies.
The timing can be changed to compensate for different flight time
of signals within the target application. By disabling unused
outputs the power consumption is reduced.
The SSTE32882KA1 accepts a parity bit from the memory
controller on the parity (PAR_IN) input, compares it with the data
received on the DIMM-independent data inputs (DAn, DBAn,
DRAS, DCAS, and DWE), and indicates whether a parity error
has occurred on the open-drain ERROUT pin (active low). The
convention is even parity; i.e., valid parity is defined as an even
number of ones across the DIMM-independent data inputs
combined with the parity input bit. To calculate parity, all
DIMM-independent D-inputs must be tied to a known logic state.
The DIMM-dependent signals (DCKEn, DODTn, and DCSn) are
not included in the parity check computation.
To ensure defined outputs from the register before a stable clock
has been supplied, RESET must be held in the low state during
power-up.
The SSTE32882KA1 is available in a 176-ball BGA with
0.65mm ball pitch in a 11 x 20 grid. The device pinout supports
outputs on the outer two left and right columns to support easy
DIMM signal routing. Corresponding inputs are placed in a-way
that two devices can be placed back-to-back for four Rank
modules while the data inputs share the same vias. Each input and
output is located close to an associated no ball position or on the
outer two rows to allow low cost via technology combined with
the small 0.65mm ball pitch.
相關PDF資料 |
PDF描述 |
|---|---|
| ISD1750SYR | IC VOICE REC/PLAY 50SEC 28-SOIC |
| ISD5008EYI | IC VOICE REC/PLAY 4-8MIN 28-TSOP |
| ISL12008IB8Z | IC RTC I2C LO-POWER 8-SOIC |
| ISL12020MIRZ-T7A | IC RTC/CALENDAR TEMP SNSR 20DFN |
| ISL12022IBZ-T7A | IC RTC/CALENDAR TEMP SNSR 8SOIC |
相關代理商/技術參數 |
參數描述 |
|---|---|
| IDTSSTE32882KA1AKG8 | 制造商:Integrated Device Technology Inc 功能描述:IC REGISTERING CLK DRIVER 176BGA |
| IDTSSTUB32866BHLF | 功能描述:IC BUFFER 25BIT CONF REG 96LFBGA RoHS:是 類別:集成電路 (IC) >> 接口 - 專用 系列:- 特色產品:NXP - I2C Interface 標準包裝:1 系列:- 應用:2 通道 I²C 多路復用器 接口:I²C，SM 總線 電源電壓:2.3 V ~ 5.5 V 封裝/外殼:16-TSSOP（0.173"，4.40mm 寬） 供應商設備封裝:16-TSSOP 包裝:剪切帶 (CT) 安裝類型:表面貼裝 產品目錄頁面:825 (CN2011-ZH PDF) 其它名稱:568-1854-1 |
| IDTSSTUB32S869AHLF | 功能描述:IC REGISTERED BUFFER 150-TFBGA RoHS:是 類別:集成電路 (IC) >> 接口 - 信號緩沖器，中繼器，分配器 系列:- 標準包裝:160 系列:- 類型:轉發器 Tx/Rx類型:以太網 延遲時間:- 電容 - 輸入:- 電源電壓:2.37 V ~ 2.63 V 電流 - 電源:60mA 安裝類型:表面貼裝 封裝/外殼:64-TQFP 裸露焊盤 供應商設備封裝:64-TQFP-EP（10x10） 包裝:托盤 其它名稱:Q5134101 |
| IDTSSTUB32S869AHLFT | 功能描述:IC REGISTERED BUFFER 150-TFBGA RoHS:是 類別:集成電路 (IC) >> 接口 - 信號緩沖器，中繼器，分配器 系列:- 標準包裝:160 系列:- 類型:轉發器 Tx/Rx類型:以太網 延遲時間:- 電容 - 輸入:- 電源電壓:2.37 V ~ 2.63 V 電流 - 電源:60mA 安裝類型:表面貼裝 封裝/外殼:64-TQFP 裸露焊盤 供應商設備封裝:64-TQFP-EP（10x10） 包裝:托盤 其它名稱:Q5134101 |
| IDTSSTVF16857AGLF | 功能描述:IC DDR REGISTER 48-TSSOP RoHS:是 類別:集成電路 (IC) >> 接口 - 專用 系列:- 標準包裝:3,000 系列:- 應用:PDA，便攜式音頻/視頻，智能電話 接口:I²C，2 線串口 電源電壓:1.65 V ~ 3.6 V 封裝/外殼:24-WQFN 裸露焊盤 供應商設備封裝:24-QFN 裸露焊盤（4x4） 包裝:帶卷 (TR) 安裝類型:表面貼裝 產品目錄頁面:1015 (CN2011-ZH PDF) 其它名稱:296-25223-2 |
發布緊急采購，3分鐘左右您將得到回復。