- 您現在的位置：買賣IC網 > PDF目錄98080 > SII3114CTU PCI BUS CONTROLLER, PQFP176 PDF資料下載
參數資料
| 型號： | SII3114CTU |
| 元件分類： | 總線控制器 |
| 英文描述： | PCI BUS CONTROLLER, PQFP176 |
| 封裝： | TQFP-176 |
| 文件頁數： | 104/127頁 |
| 文件大小： | 564K |
| 代理商： | SII3114CTU |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁當前第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁第115頁第116頁第117頁第118頁第119頁第120頁第121頁第122頁第123頁第124頁第125頁第126頁第127頁
SiI3114 PCI to Serial ATA Controller
Data Sheet
Silicon Image, Inc.
SiI-DS-0103-D
70
2007 Silicon Image, Inc.
Serial ATA SActive
Address Offset: 10CH / 18CH / 30CH / 38CH
Access Type: Read/Write 1/Clear
Reset Value: 0x0000_0000
31 30 29 28 27 26 25 24 23 22 21 20 19 18 17 16 15 14 13 12 11 10 09 08 07 06 05 04 03 02 01 00
SActive bits
The bits of this register may be written with a 1, but are cleared if the corresponding bits of the second dword of a
FIS are set when the SDevice Bits FIS is received. All 32 bits may be cleared by writing 0x0000_0000 to the
register; individual bits may not be cleared except by the hardware.
SMisc
Address Offset: 140H / 1C0H / 340H / 3C0H
Access Type: Read/Write
Reset Value: 0x0000_0000
31 30 29 28 27 26 25 24 23 22 21 20 19 18 17 16 15 14 13 12 11 10 09 08 07 06 05 04 03 02 01 00
FIS_Done
Transmit
_FIS
Transmit
_OK
IFIS_OK
Int
rlckFIS
R
e
ject
_IF
Accept_IF
R
x_IFIS
S
DB
pterr
Scr_dis
Cont_dis
VS_Lock_Abort
fpdmawr
dmainen
dmaouten
Transmit
_B
IST
devdrvn
nienf
is_dis
srst
C
o
mW
ake
pm_f
iscf
g
pm_locken
re
ffi
s
m
ode
P
M
CHG
P
MMO
DE
Reserved
PM
R
E
Q
This register contains bits for controlling Serial ATA power management, ComWake, loopback modes, and FIS
transfers.
Bit [31]: FIS_Done (R/W) – This bit is used to indicate to the link logic that all the data for the Transparent
FIS has been transferred and that the link can proceed to close out the FIS. This is used in Transparent
FIS transmission. Please refer to the “FIS Support” section on page 85 for more details.
Bit [30]: Transmit_FIS (W)– This bit is used to signal the link logic to start the process of transmitting a
Transparent FIS. Please refer to the “FIS Support” section on page 85 for more details.
Bit [29]: Transmit_OK (R)– This bit is used in Transparent FIS transmission. It is used by the link to signal
to the host that the current Transparent FIS has been successfully transferred to the device, and that R_OK
has been received.
Bit [28]: IFIS_OK (R)– This bit is used in the reception of Interlocked FISes. This bit is set by the link logic
to inform the host that the current Interlocked FIS has been successfully received with no errors.
Bit [27]: IntrlckFIS (R)– This bit is set to indicate to the host driver that the link has detected an the arrival
of an interlocked FIS and that the host should set up the DMA engine to start transfer of data
Bit [26]: Reject_IFIS (W)– This bit is set by the host driver to indicate to the link that the current Interlocked
FIS should be rejected. The link logic will respond to the device with an R_ERR when the complete FIS has
been received.
Bit [25]: Accept_IFIS (W)– This bit is set by the host driver to indicate to the link that the current interlocked
FIS should be accepted. The link logic will respond to the device with R_OK
Bit [24]: Rx_IFIS (W)– This bit is set by the host driver to inform the link/transport logic that the host has
set up the DMA engine to transfer the incoming Interlocked FIS and that the DMA cycles can begin
Bit [23]: SDB (R) – This bit indicates that a Set Device Bits FIS has been received
Bit [22]: pterr (R) – This bit indicates that a Protocol Error has occurred. An interrupt will be generated if bit
20 of SIEN is set.
Bit [21]: Scr_dis (R/W)– This bit disables the scrambling of data on the serial ATA bus. This is used only for
debugging purposes and should not be changed by the user
相關PDF資料 |
PDF描述 |
|---|---|
| SII3124ACBHU | PCI BUS CONTROLLER, PBGA364 |
| SII3512ECTU128 | PCI BUS CONTROLLER, PQFP128 |
| SII3531ACNU | PCI BUS CONTROLLER, QCC48 |
| SIO10N268-NU | MULTIFUNCTION PERIPHERAL, PQFP128 |
| SIS300 | GRAPHICS PROCESSOR, PBGA365 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| SII3124A | 制造商:SILICONIMAGE 制造商全稱:SILICONIMAGE 功能描述:PCI-X to Serial ATA Controller |
| SII3124ACBHU | 制造商:SILICONIMAGE 制造商全稱:SILICONIMAGE 功能描述:PCI-X to Serial ATA Controller |
| SII3132 | 制造商:SILICONIMAGE 制造商全稱:SILICONIMAGE 功能描述:PCI Express to 2-Port Serial ATA II Host Controller |
| SII3132CNU | 制造商:Silicon Image Inc 功能描述:PCI Express to Serial ATA Controller 88-Pin QFN |
| SII3512 | 制造商:SILICONIMAGE 制造商全稱:SILICONIMAGE 功能描述:PCI to Serial ATA Controller |
發布緊急采購，3分鐘左右您將得到回復。