參數資料
型號: ORT8850
英文描述: Field-Programmable System Chip (FPSC) Eight-Channel x 850 Mbits/s Backplane Transceiver
中文描述: 現場可編程系統芯片(促進文化基金)8通道x 850 Mbits /秒背板收發器
文件頁數: 24/112頁
文件大?。?/td> 2417K
代理商: ORT8850
24
Agere Systems Inc.
Data Sheet
August 2001
Eight-Channel x 850 Mbits/s Backplane Transceiver
ORCA
ORT8850 FPSC
Backplane Transceiver Core Detailed
Description
(continued)
Framer Block
The framer block takes byte-wide data from the HSI,
and outputs a byte-aligned, byte-wide data stream and
8 kHz sync pulse. The framer algorithm determines the
out-of-frame/in-frame status of the incoming data and
will cause interrupts on both an errored frame and an
out-of-frame (OOF) state. The framer detects the A1/
A2 framing pattern and generates the 8 kHz frame
pulse. When the framer detects OOF, it will generate
an interrupt. Also, the framer detects an errored frame
and increments an A1/A2 frame error counter. The
counter can be monitored by a processor to compile
performance status on the quality of the backplane.
Because the ORT8850 is intended for use between it
and another ORT8850 or other devices via a back-
plane, there is only one errored frame state. Thus, after
two transitions are missed, the state machine goes into
the OOF state and there is no severely errored frame
(SEF) or loss-of-frame (LOF) indication.
B1 Calculate
Each Rx block receives byte-wide scrambled
77.76 MHz data and a frame sync from the framer.
Since each HSI is independently clocked, the Rx block
operates on individual streams. Timing signals required
to locate overhead bytes to be extracted are generated
internally based on the frame sync. The Rx block pro-
duces byte-wide (optionally) descrambled data and an
output frame sync for the alignment FIFO block. The
frame sync signals are also sent to the FPGA logic for
use when the alignment FIFO block is bypassed.
The B1 calculation block computes a BIP-8 (bit inter-
leaved parity 8 bits) code, using even parity over all bits
of the previous STS-12 frame before descrambling;
this value is checked against the B1 byte of the current
frame after descrambling. A per-stream B1 error
counter is incremented for each bit that is in error. The
error counter may be read via the CPU interface.
Descrambling.
The streams are descrambled using a
frame synchronous descrambler with a sequence
length of 127 with a generating polynomial of 1 + x
6
+
x
7
. The A1/A2 framing bytes, the section trace byte
(J0) and the growth bytes (Z0) are not descrambled.
The descrambling function can be disabled by soft-
ware.
Sampler.
This block operates on the byte-wide data
directly from the HSI macro. The HSI external interface
always runs at 622 Mbits/s (STS-12), or 850 Mbits/s,
but it can be connected directly to a 155 Mbits/s STS-3
stream or a 51.84 Mbits/s STS-1 stream. If connected
to either a 155 Mbits/s or 51.84 Mbits/s stream, each
incoming data is received either 4 or 12 times respec-
tively. This block is used to return the byte stream to
the expected STS-12 format. The mode of operation is
controlled by a register and can either be STS-12
(pass-through), STS-3 (every fourth bit), or STS-1
(every twelfth bit). The output from this block is not bit-
aligned (i.e., an 8-bit sample does not necessarily con-
tain an entire SONET byte), but it is in standard
SONET STS-12 format (i.e., four STS-3s or 12 STS-
1s) and is suitable for framing.
AIS-L Insertion.
Alarm indication signal (AIS) is a con-
tinuous stream of unframed 1s sent to alert down-
stream equipment that the near-end terminal has
failed, lost its signal source, or has been temporarily
taken out of service. If enabled in the AIS_L force reg-
ister, AIS-L is inserted into the received frame by writ-
ing all ones for all bytes of the descrambled stream.
AIS-L Insertion on Out-of-Frame.
If enabled via a
register, AIS-L is inserted into the received frame by
writing all ones for all bytes of the descrambled stream
when the framer indicates that an out-of-frame condi-
tion exists.
Internal Parity Generation
Even parity is generated on all data bytes and is routed
in parallel with the data to be checked before the pro-
tection switch MUX at the parallel output.
相關PDF資料
PDF描述
ORT8850H Field-Programmable System Chip (FPSC) Eight-Channel x 850 Mbits/s Backplane Transceiver
ORT8850L Field-Programmable System Chip (FPSC) Eight-Channel x 850 Mbits/s Backplane Transceiver
OS1001 Interface IC
OS1010 Optoelectronic
OS1011 SINGLE 1.8V, 200 KHZ OP, E TEMP, -40C to +125C, 8-PDIP, TUBE
相關代理商/技術參數
參數描述
ORT8850-FPSC-EV 功能描述:可編程邏輯 IC 開發工具 ORCA ORT8850 FPSC Eval Brd RoHS:否 制造商:Altera Corporation 產品:Development Kits 類型:FPGA 工具用于評估:5CEFA7F3 接口類型: 工作電源電壓:
ORT8850H 制造商:AGERE 制造商全稱:AGERE 功能描述:Field-Programmable System Chip (FPSC) Eight-Channel x 850 Mbits/s Backplane Transceiver
ORT8850H-1BM680C 功能描述:FPGA - 現場可編程門陣列 16192 LUT 297 I/O RoHS:否 制造商:Altera Corporation 系列:Cyclone V E 柵極數量: 邏輯塊數量:943 內嵌式塊RAM - EBR:1956 kbit 輸入/輸出端數量:128 最大工作頻率:800 MHz 工作電源電壓:1.1 V 最大工作溫度:+ 70 C 安裝風格:SMD/SMT 封裝 / 箱體:FBGA-256
ORT8850H-1BM680I 功能描述:FPGA - 現場可編程門陣列 16192 LUT 297 I/O RoHS:否 制造商:Altera Corporation 系列:Cyclone V E 柵極數量: 邏輯塊數量:943 內嵌式塊RAM - EBR:1956 kbit 輸入/輸出端數量:128 最大工作頻率:800 MHz 工作電源電壓:1.1 V 最大工作溫度:+ 70 C 安裝風格:SMD/SMT 封裝 / 箱體:FBGA-256
ORT8850H-1BMN680C 功能描述:FPGA - 現場可編程門陣列 16192 LUT 297 I/O RoHS:否 制造商:Altera Corporation 系列:Cyclone V E 柵極數量: 邏輯塊數量:943 內嵌式塊RAM - EBR:1956 kbit 輸入/輸出端數量:128 最大工作頻率:800 MHz 工作電源電壓:1.1 V 最大工作溫度:+ 70 C 安裝風格:SMD/SMT 封裝 / 箱體:FBGA-256