參數資料
型號： USB-I2C/LIN-CONV-Z
廠商： Analog Devices Inc
文件頁數： 92/104頁
文件大?。?/td> 0K
描述： USB TO I2C/LIN CONV BOARD
標準包裝： 1
附件類型： 適配器板
適用于相關產品： ARM7TDMI?
ADuC7019/20/21/22/24/25/26/27/28/29
Data Sheet
Rev. F | Page 88 of 104
Table 186. T2CON MMR Bit Descriptions
Bit
Value
Description
31:11
Reserved.
10:9
Clock source.
00
External crystal.
01
External crystal.
10
Internal oscillator.
11
Core clock (41 MHz/2CD).
8
Count up. Set by user for Timer2 to count up.
Cleared by user for Timer2 to count down by
default.
7
Timer2 enable bit. Set by user to enable Timer2.
Cleared by user to disable Timer2 by default.
6
Timer2 mode. Set by user to operate in
periodic mode. Cleared by user to operate in
free-running mode. Default mode.
5:4
Format.
00
Binary.
01
Reserved.
10
Hr: min: sec: Hundredths (23 hours to 0 hour).
11
Hr: min: sec: Hundredths (255 hours to 0 hour).
3:0
Prescale.
0000
Source Clock/1 by default.
0100
Source Clock/16.
1000
Source Clock/256 expected for Format 2 and
Format 3.
1111
Source Clock/32,768.
Table 187. T2CLRI Register
Name
Address
Default Value
Access
T2CLRI
0xFFFF034C
0xFF
W
T2CLRI is an 8-bit register. Writing any value to this register
clears the Timer2 interrupt.
Timer3 (Watchdog Timer)
Timer3 has two modes of operation: normal mode and
watchdog mode. The watchdog timer is used to recover from
an illegal software state. Once enabled, it requires periodic
servicing to prevent it from forcing a processor reset.
Normal Mode
Timer3 in normal mode is identical to Timer0, except for the
clock source and the count-up functionality. The clock source
is 32 kHz from the PLL and can be scaled by a factor of 1, 16,
or 256 (see Figure 80).
04955-
037
32.768kHz
PRESCALER
/1, 16 OR 256
16-BIT
UP/DOWN
COUNTER
16-BIT
LOAD
TIMER3
VALUE
WATCHDOG
RESET
TIMER3 IRQ
Figure 80. Timer3 Block Diagram
Watchdog Mode
Watchdog mode is entered by setting Bit 5 in the T3CON MMR.
Timer3 decreases from the value present in the T3LD register to 0.
T3LD is used as the timeout. The maximum timeout can be
512 sec, using the prescaler/256, and full scale in T3LD. Timer3
is clocked by the internal 32 kHz crystal when operating in
watchdog mode. Note that to enter watchdog mode success-
fully, Bit 5 in the T3CON MMR must be set after writing to the
T3LD MMR.
If the timer reaches 0, a reset or an interrupt occurs, depending
on Bit 1 in the T3CON register. To avoid reset or interrupt, any
value must be written to T3CLRI before the expiration period.
This reloads the counter with T3LD and begins a new timeout
period.
When watchdog mode is entered, T3LD and T3CON are write-
protected. These two registers cannot be modified until a reset
clears the watchdog enable bit, which causes Timer3 to exit
watchdog mode.
The Timer3 interface consists of four MMRs: T3LD, T3VAL,
T3CON, and T3CLRI.
Table 188. T3LD Register
Name
Address
Default Value
Access
T3LD
0xFFFF0360
0x0000
R/W
T3LD is a 16-bit register load register.
Table 189. T3VAL Register
Name
Address
Default Value
Access
T3VAL
0xFFFF0364
0xFFFF
R
T3VAL is a 16-bit read-only register that represents the current
state of the counter.
Table 190. T3CON Register
Name
Address
Default Value
Access
T3CON
0xFFFF0368
0x0000
R/W
T3CON is the configuration MMR described in Table 191.
相關PDF資料
PDF描述
HBM10DSEI-S13 CONN EDGECARD 20POS .156 EXTEND
EBC35DCSD-S288 CONN EDGECARD 70POS .100 EXTEND
HBM15DRYN-S13 CONN EDGECARD 30POS .156 EXTEND
RBC17DRES-S13 CONN EDGECARD 34POS .100 EXTEND
HBM15DRYH-S13 CONN EDGECARD 30POS .156 EXTEND
相關代理商/技術參數
參數描述
USB-I2C-SS 功能描述:USB 接口集成電路 Driver-free USB to serl SPIslve intrfce RoHS:否 制造商:Cypress Semiconductor 產品:USB 2.0 數據速率: 接口類型:SPI 工作電源電壓:3.15 V to 3.45 V 工作電源電流: 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:WLCSP-20
USB-ICP-80C51ISP 功能描述:程序設計器 - 基于處理器 In-System Programmer for NXP 80C51ISP RoHS:否 制造商:Olimex Ltd. 產品:Programmers 工具用于評估:XMEGA, MegaAVR, tinyAVR 核心:AVR 接口類型:USB 工作電源電壓:1.8 V to 5.5 V
USB-ICP-LPC2K 功能描述:程序設計器 - 基于處理器 In-System Programmer for NXP ARM7 LPC2xxx RoHS:否 制造商:Olimex Ltd. 產品:Programmers 工具用于評估:XMEGA, MegaAVR, tinyAVR 核心:AVR 接口類型:USB 工作電源電壓:1.8 V to 5.5 V
USB-ICP-LPC9XX 功能描述:程序設計器 - 基于處理器 In-Circuit Programer for NXP LPC9xx RoHS:否 制造商:Olimex Ltd. 產品:Programmers 工具用于評估:XMEGA, MegaAVR, tinyAVR 核心:AVR 接口類型:USB 工作電源電壓:1.8 V to 5.5 V
USB-ICP-SAB9 功能描述:插座和適配器 Socket Adapter Brd USB-ICP-LPC9xx Drvr RoHS:否 制造商:Silicon Labs 產品:Adapter 用于:EM35x
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*