- 您現在的位置：買賣IC網 > PDF目錄1956 > NCN6004AFTBR2G (ON Semiconductor)IC INTERFACE SAM/SIM DUAL 48TQFP PDF資料下載
參數資料
| 型號： | NCN6004AFTBR2G |
| 廠商： | ON Semiconductor |
| 文件頁數： | 17/40頁 |
| 文件大小： | 0K |
| 描述： | IC INTERFACE SAM/SIM DUAL 48TQFP |
| 標準包裝： | 1 |
| 應用： | PC，PDA |
| 接口： | 微控制器 |
| 電源電壓： | 1.8 V ~ 5.5 V |
| 封裝/外殼： | 48-TQFP 裸露焊盤 |
| 供應商設備封裝： | 48-TQFP（7x7） |
| 包裝： | 標準包裝 |
| 安裝類型： | 表面貼裝 |
| 其它名稱： | NCN6004AFTBR2GOSDKR |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁當前第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁
NCN6004A
http://onsemi.com
24
Since the output inductor L1 and the reservoir capacitor
C1 carry relative high peak current, low ESR devices must
be used to prevent the system from poor output voltage
ripple and low efficiency. Using ceramic capacitors, X5R or
X7R type, are recommended, splitting the 10
mF in two
separate parts when there is a relative long distance between
the CRD_VCC_x output pin and the card VCC input. On the
other hand, the inductor shall have an ESR below 1.0
W to
achieve the high efficiency over the full temperature range.
However, inductor with 2.0
W ESR can be used when a slight
decrease of the efficiency is acceptable at system level.
Ton Toff
CRD_VCC Charged
Charge CRD_VCC
Next CRD_VCC Charge
Q1 / Q4
Q2 / Q3
IL
(Time is not to scale)
CRD_VCC
CRD_VCC Voltage Regulated
Ipeak
V
ripple
Q5/Q6
Figure 16. Theoretical DC/DC Operating
When the CRD_VCC is programmed to zero volt, or when
the card is extracted from the socket, the active pull down Q5
rapidly discharges the output reservoir capacitor, making
sure the output voltage is below 0.40 V when the card slides
across the contacts.
Based on the experiments carried out during the
NCN6004A characterization, the best comprise, at time of
printing
this
document,
is
to
use
two
4.7
mF/10 V/ceramic/X7R capacitor in parallel to achieve
the CRD_VCC filtering. The ESR will not extend 50 m
W
over the temperature range and the combination of standard
parts provide an acceptable –20% to +20% tolerance,
together with a low cost. Table 6 shows a quick comparison
between the most common type of capacitors. Obviously,
the capacitor must be SMD type to achieve the extremely
low ESR and ESL necessary for this application.
Figure 17 illustrates the CRD_VCC ripple observed in the
NCN6004A demo board running with X7R ceramic
capacitors.
Table 6. Ceramic/Electrolytic Capacitors Comparison
Manufacturer
Type/Series
Format
Max Value
Tolerance
Typ. Z @ 500 kHz
MURATA
CERAMIC/GRM225
0805
10
mF/6.3 V
20% /+20%
30 m
W
MURATA
CERAMIC/GRM225
0805
4.7
mF/6.3 V
20% /+20%
30 m
W
VISHAY
Tantalum/594C/593C
1206
10
mF/16 V
450 m
W
VISHAY
Electrolytic/94SV
1812
10
mF/10 V
20%/+20%
400 m
W
Miscellaneous
Electrolytic Low Cost
1812
10
mF/10 V
35%/+50%
2.0
W
相關PDF資料 |
PDF描述 |
|---|---|
| NCN6804MNR2G | IC SMART CARD DUAL W/SPI 32-QFN |
| NCN7200MTTWG | IC MUX/DEMUX OCTAL 1X2 42WQFN |
| NCN8024DTBR2G | SMART CARD IC 5V/3V TSSOP |
| NCN8024RDWR2G | IC SMART CARD IC2 28SOIC |
| NCN8025MTTBG | IC SMART CARD I2C 16-QFN |
相關代理商/技術參數 |
參數描述 |
|---|---|
| NCN6010 | 制造商:ONSEMI 制造商全稱:ON Semiconductor 功能描述:SIM Card Supply and Level Shifter |
| NCN6010/D | 制造商:ONSEMI 制造商全稱:ON Semiconductor 功能描述:SIM Card Supply and Level Shifter |
| NCN6010_06 | 制造商:ONSEMI 制造商全稱:ON Semiconductor 功能描述:SIM Card Supply and Level Shifter |
| NCN6010D | 制造商:ONSEMI 制造商全稱:ON Semiconductor 功能描述:SIM Card Supply and Level Shifter |
| NCN6010DTB | 功能描述:轉換 - 電壓電平 2.7V Sim Card RoHS:否 制造商:Micrel 類型:CML/LVDS/LVPECL to LVCMOS/LVTTL 傳播延遲時間:1.9 ns 電源電流:14 mA 電源電壓-最大:3.6 V 電源電壓-最小:3 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:MLF-8 |
發布緊急采購，3分鐘左右您將得到回復。