- 您現在的位置：買賣IC網 > PDF目錄360998 > ISP1161ABM (NXP SEMICONDUCTORS) Full-speed Universal Serial Bus single-chip host and device controller PDF資料下載
參數資料
| 型號： | ISP1161ABM |
| 廠商： | NXP SEMICONDUCTORS |
| 元件分類： | 總線控制器 |
| 英文描述： | Full-speed Universal Serial Bus single-chip host and device controller |
| 中文描述： | UNIVERSAL SERIAL BUS CONTROLLER, PQFP64 |
| 封裝： | 7 X 7 MM, 1.40 MM HEIGHT, PLASTIC, MS-026, SOT-414-1, LQFP-64 |
| 文件頁數： | 43/134頁 |
| 文件大?。?/td> | 587K |
| 代理商： | ISP1161ABM |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁當前第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁第115頁第116頁第117頁第118頁第119頁第120頁第121頁第122頁第123頁第124頁第125頁第126頁第127頁第128頁第129頁第130頁第131頁第132頁第133頁第134頁
Philips Semiconductors
ISP1161A
Full-speed USB single-chip host and device controller
Product data
Rev. 03 — 23 December 2004
43 of 134
9397 750 13962
Koninklijke Philips Electronics N.V. 2004. All rights reserved.
Under the USBSuspend state, once pin H_WAKEUP goes HIGH, after 160
μ
s, the
internal clock will be up. If pin H_WAKEUP continues to be HIGH, then the internal
clock will be kept running, and the microprocessor can set the HC into
USBOperational state during this time.
If H_WAKEUP goes LOW for more than 1.14 ms, the internal clock stops, and the
HC goes back into USBSuspend state.
Wake-up by pin CS (software wake-up)
During the USBSuspend state, an external microprocessor issues a chip select
signal through pin CS. This method of access to ISP1161A internal registers is a
software wake-up.
Wake-up by USB devices
For a USB bus resume, a USB device attached to the root hub port issues a
resume signal to the HC through the USB bus, switching the HC from
USBSuspend state to USBResume state. This will also set the ResumeDetected
bit of the HcInterruptStatus register (03H - read, 83H - write).
No matter which method is used to wake up the HC from USBSuspend state, the
corresponding interrupt bits must be enabled before the HC goes into USBSuspend
state so that the microprocessor can receive the correct interrupt request to wake up
the HC.
10. HC registers
The HC contains a set of on-chip control registers. These registers can be read or
written by the Host Controller Driver (HCD). The Control and Status register sets,
Frame Counter register sets, and Root Hub register sets are grouped under the
category of HC Operational registers (32 bits). These operational registers are made
compatible to OpenHCI (Host Controller Interface) Operational registers. This allows
the OpenHCI HCD to be easily ported to ISP1161A.
Reserved bits may be defined in future releases of this specification. To ensure
interoperability, the HCD must not assume that a reserved field contains logic 0.
Furthermore, the HCD must always preserve the values of the reserved field. When a
R/W register is modified, the HCD must first read the register, modify the bits desired,
and then write the register with the reserved bits still containing the original value.
Alternatively, the HCD can maintain an in-memory copy of previously written values
that can be modified and then written to the HC register. When a ‘write to set’ or ‘clear
the register’ is performed, bits written to reserved fields must be logic 0.
As shown in
Table 7
, the addresses (the commands for accessing registers) of these
32-bit Operational registers are similar the offsets defined in the OHCI specification
with the addresses being equal to offset divided by 4.
相關PDF資料 |
PDF描述 |
|---|---|
| ISP1161 | Full-speed Universal Serial Bus single-chip host and device controller |
| ISP1161A1 | Universal Serial Bus single-chip host and device controller |
| ISP1161A1BD | Universal Serial Bus single-chip host and device controller |
| ISP1161A1BM | Universal Serial Bus single-chip host and device controller |
| ISP1161BD | Full-speed Universal Serial Bus single-chip host and device controller |
相關代理商/技術參數 |
參數描述 |
|---|---|
| ISP1161ABM,518 | 功能描述:USB 接口集成電路 DO NOT USE ORDER ISP1161A1BM RoHS:否 制造商:Cypress Semiconductor 產品:USB 2.0 數據速率: 接口類型:SPI 工作電源電壓:3.15 V to 3.45 V 工作電源電流: 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:WLCSP-20 |
| ISP1161ABM,551 | 功能描述:USB 接口集成電路 DO NOT USE ORDER ISP1161A1BM RoHS:否 制造商:Cypress Semiconductor 產品:USB 2.0 數據速率: 接口類型:SPI 工作電源電壓:3.15 V to 3.45 V 工作電源電流: 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:WLCSP-20 |
| ISP1161ABM,557 | 功能描述:USB 接口集成電路 DO NOT USE ORDER ISP1161A1BM RoHS:否 制造商:Cypress Semiconductor 產品:USB 2.0 數據速率: 接口類型:SPI 工作電源電壓:3.15 V to 3.45 V 工作電源電流: 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:WLCSP-20 |
| ISP1161ABM-S | 功能描述:IC USB HOST CTRL FULL-SPD 64LQFP RoHS:是 類別:集成電路 (IC) >> 接口 - 控制器 系列:- 標準包裝:4,900 系列:- 控制器類型:USB 2.0 控制器 接口:串行 電源電壓:3 V ~ 3.6 V 電流 - 電源:135mA 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:36-VFQFN 裸露焊盤 供應商設備封裝:36-QFN（6x6） 包裝:* 其它名稱:Q6396337A |
| ISP1161ABM-T | 功能描述:IC USB HOST CTRL FULL-SPD 64LQFP RoHS:是 類別:集成電路 (IC) >> 接口 - 控制器 系列:- 標準包裝:4,900 系列:- 控制器類型:USB 2.0 控制器 接口:串行 電源電壓:3 V ~ 3.6 V 電流 - 電源:135mA 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:36-VFQFN 裸露焊盤 供應商設備封裝:36-QFN（6x6） 包裝:* 其它名稱:Q6396337A |
發布緊急采購，3分鐘左右您將得到回復。