- 您現在的位置：買賣IC網 > PDF目錄1900 > ADUC812BSZ-REEL (Analog Devices Inc)IC MCU FLASH 12BIT ADC 52MQFP PDF資料下載
參數資料
| 型號： | ADUC812BSZ-REEL |
| 廠商： | Analog Devices Inc |
| 文件頁數： | 18/57頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC MCU FLASH 12BIT ADC 52MQFP |
| 標準包裝： | 800 |
| 系列： | MicroConverter® ADuC8xx |
| 核心處理器： | 8052 |
| 芯體尺寸： | 8-位 |
| 速度： | 16MHz |
| 連通性： | I²C，SPI，UART/USART |
| 外圍設備： | PSM，溫度傳感器，WDT |
| 輸入/輸出數： | 34 |
| 程序存儲器容量： | 8KB（8K x 8） |
| 程序存儲器類型： | 閃存 |
| EEPROM 大?。?/td> | 640 x 8 |
| RAM 容量： | 256 x 8 |
| 電壓 - 電源 (Vcc/Vdd)： | 2.7 V ~ 5.5 V |
| 數據轉換器： | A/D 8x12b，D/A 2x12b |
| 振蕩器型： | 內部 |
| 工作溫度： | -40°C ~ 85°C |
| 封裝/外殼： | 52-QFP |
| 包裝： | 帶卷 (TR) |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁當前第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁
REV.
ADuC812
–25–
Power Supply Monitor
PSMCON
Control Register
SFR Address
DFH
Power-On Default Value
DCH
Bit Addressable
No
—P
M
CI
M
S
P2
P
T1
P
T0
P
TF
S
PN
E
M
S
P
Table X. PSMCON SFR Bit Designations
Bit
Name
Description
7
—
Not Used.
6
CMP
AVDD and DVDD Comparator Bit.
This is a read-only bit and directly reflects the state of the AVDD and DVDD comparators.
Read “1” indicates that both the AVDD and DVDD supplies are above their selected trip points.
Read “0” indicates that either the AVDD or DVDD supply is below its selected trip point.
5
PSMI
Power Supply Monitor Interrupt Bit.
This bit will be set high by the MicroConverter if CMP is low, indicating low analog or digital
supply. The PSMI bit can be used to interrupt the processor. Once CMPD and/or CMP return
(and remain) high, a 256 ms counter is started. When this counter times out, the PSMI interrupt
is cleared. PSMI can also be written by the user. However, if either comparator output is low,
it is not possible for the user to clear PSMI.
4
TP2
VDD Trip Point Selection Bits.
3
TP1
2
TP0
These bits select the AVDD and DVDD trip point voltage as follows:
TP2
TP1
TP0
Selected DVDD Trip Point (V)
0
4.63
0
1
4.37
0
1
0
3.08
0
1
2.93
1
0
2.63
1
PSF
AVDD/DVDD Fault Indicator.
Read “1” indicates that the AVDD supply caused the fault condition.
Read “0” indicates that the DVDD supply caused the fault condition.
0
PSMEN
Power Supply Monitor Enable Bit.
Set to “1” by the user to enable the Power Supply Monitor Circuit.
Cleared to “0” by the user to disable the Power Supply Monitor Circuit.
Example
To configure the PSM for a trip point of 4.37 V, the following
code would be used:
MOV
PSMCON,#005h
;enable PSM with
;4.37V threshold
SETB
EA
;enable interrupts
MOV
IE2,#002h
;enable PSM
;interrupt
If the supply voltage falls below this level, the PC would vector
to the ISR.
ORG
0043h
;PSM ISR
CHECK:MOV
A,PSMCON
;PSMCON.5 is the
;PSM interrupt
;bit..
JB
ACC.5,CHECK
;..it is cleared
;only when Vdd
;has remained
;above the trip
;point for 256ms
;or more.
RETI
; return only when "all's well"
SERIAL PERIPHERAL INTERFACE
The ADuC812 integrates a complete hardware Serial Peripheral
Interface (SPI) on-chip. SPI is an industry-standard synchronous
serial interface that allows eight bits of data to be synchronously
transmitted and received simultaneously, i.e., full duplex. It should
be noted that the SPI pins are shared with the I
2C interface, and
therefore the user can only enable one or the other interface at
any given time (see SPE in Table XI). The SPI Port can be con-
figured for Master or Slave operation and typically consists of
four pins, namely:
MISO (Master In, Slave Out Data I/O Pin)
The MISO (master in, slave out) pin is configured as an input
line in master mode and an output line in slave mode. The
MISO line on the master (data in) should be connected to the
MISO line in the slave device (data out). The data is transferred
as byte wide (8-bit) serial data, MSB first.
F
相關PDF資料 |
PDF描述 |
|---|---|
| ADUC814BRU | IC ADC 12BIT W/FLASH MCU 28TSSOP |
| ADUC816BCP | IC MCU 8K FLASH ADC/DAC 56LFCSP |
| ADUC824BSZ-REEL | IC MCU 8K FLASH ADC/DAC 52MQFP |
| ADUC831BCPZ | IC MCU 62K FLASH ADC/DAC 56LFCSP |
| ADUC832BSZ-REEL | IC MCU 62K FLASH ADC/DAC 52MQFP |
相關代理商/技術參數 |
參數描述 |
|---|---|
| ADUC813BS | 制造商:Analog Devices 功能描述:12-BIT ADC WITH EMBEDDED MCU I.C. - Trays |
| ADUC814 | 制造商:AD 制造商全稱:Analog Devices 功能描述:MicroConverter, Small Package 12-Bit ADC with Embedded Flash MCU |
| ADUC814_02 | 制造商:AD 制造商全稱:Analog Devices 功能描述:MicroConverter, Small Package 12-Bit ADC with Embedded FLASH MCU |
| ADUC814AN | 功能描述:8052 MicroConverter? ADuC8xx Microcontroller IC 8-Bit 16.78MHz 8KB (8K x 8) FLASH 制造商:analog devices inc. 系列:MicroConverter? ADuC8xx 包裝:- 零件狀態:上次購買時間 核心處理器:8052 核心尺寸:8-位 速度:16.78MHz 連接性:I2C，SPI，UART/USART 外設:POR，PSM，溫度傳感器，WDT I/O 數:- 程序存儲容量:8KB（8K x 8） 程序存儲器類型:閃存 EEPROM 容量:640 x 8 RAM 容量:256 x 8 電壓 - 電源（Vcc/Vdd）:2.7 V ~ 5.5 V 數據轉換器:* 振蕩器類型:內部 工作溫度:* 封裝/外殼:- 供應商器件封裝:- 標準包裝:1 |
| ADUC814ARU | 功能描述:IC ADC 12BIT W/FLASH MCU 28TSSOP RoHS:否 類別:集成電路 (IC) >> 嵌入式 - 微控制器， 系列:MicroConverter® ADuC8xx 標準包裝:38 系列:Encore!® XP® 核心處理器:eZ8 芯體尺寸:8-位 速度:5MHz 連通性:IrDA，UART/USART 外圍設備:欠壓檢測/復位，LED，POR，PWM，WDT 輸入/輸出數:16 程序存儲器容量:4KB（4K x 8） 程序存儲器類型:閃存 EEPROM 大小:- RAM 容量:1K x 8 電壓 - 電源 (Vcc/Vdd):2.7 V ~ 3.6 V 數據轉換器:- 振蕩器型:內部 工作溫度:-40°C ~ 105°C 封裝/外殼:20-SOIC（0.295"，7.50mm 寬） 包裝:管件 其它名稱:269-4116Z8F0413SH005EG-ND |
發布緊急采購，3分鐘左右您將得到回復。