參數資料
型號: UPD72042
廠商: NEC Corp.
英文描述: LSI DEVICES FOR Inter Equipment BusTM (IEBusTM) PROTOCOL CONTROL
中文描述: LSI器件間設備BusTM(IEBusTM)協議控制
文件頁數: 10/92頁
文件大?。?/td> 373K
代理商: UPD72042
μ
PD72042
10
Data Sheet S14870EJ1V0DS00
2.2.1 Bus Mastership Determination (Arbitration)
Before devices connected to the IEBus can control other devices, they must first acquire the bus. This operation
is called arbitration.
When more than one unit starts transmission at the same time, arbitration determines which of those units is allowed
to use the bus.
When arbitration results in only one device being granted bus mastership, the following bus mastership priority
conditions are used:
Remark
Those devices that are defeated in arbitration can automatically enter retransmission mode. (For the
μ
PD72042, the number of retransmissions can be set by specifying a value between 0 and 7 in the MCR
register.)
(1) Priority by communication type
Broadcast (one-unit-to-multiple-units communication) takes priority over ordinary communication (one-unit-to-
one-unit communication).
(2) Priority by master address
If the communication type is the same, the smallest master address value has the highest priority.
Example
Each master address consists of 12 bits. A unit having master address 000H has the highest priority,
while a unit having master address FFFH has the lowest priority.
2.2.2 Communication Mode
The IEBus supports two communication modes, each having a different transmission speed. Table 2-1 lists the
transmission speed for each communication mode and the maximum number of bytes transmitted within one
communication frame.
Table 2-1
Transmission Speed and Maximum Number of Transmission
Bytes in Each Communication Mode
Communication mode
Maximum number of transmission
bytes (bytes/frame)
Effective transmission speed
(Kbps)
0
16
Approx. 3.9
1
32
Approx. 17
Note
Effective transmission speed at which the maximum transfer rate is achieved
Caution Before devices connected to the IEBus can perform communication, an appropriate commun-
ication mode must be set. Note that if a master unit and an associated unit (slave unit) have
different communication modes, they will not be able to communicate properly.
Note
相關PDF資料
PDF描述
UPD72042GT LSI DEVICES FOR Inter Equipment BusTM (IEBusTM) PROTOCOL CONTROL
uPD72107GC-3B9 LAP-B CONTROLLER(Link Access Procedure Balanced mode)
UPD72107 LAP-B CONTROLLER(Link Access Procedure Balanced mode)
uPD72107CW LAP-B CONTROLLER(Link Access Procedure Balanced mode)
uPD72107L LAP-B CONTROLLER(Link Access Procedure Balanced mode)
相關代理商/技術參數
參數描述
UPD72042BGT-A 制造商:Renesas Electronics 功能描述:LSI Device 16-Pin SOP 制造商:Renesas Electronics 功能描述:LSI Device 16-Pin SOP Cut Tape
UPD72042GT(A) 制造商:Renesas Electronics Corporation 功能描述:
UPD720902AF5-667-JF2-E3-A 功能描述:IC ADVANCED MEMORY BUFFER D1 RoHS:是 類別:集成電路 (IC) >> 接口 - 專用 系列:* 標準包裝:90 系列:- 應用:PCI 至 PCI 橋 接口:PCI 電源電壓:3 V ~ 3.6 V 封裝/外殼:257-LFBGA 供應商設備封裝:257-BGA MICROSTAR(16x16) 包裝:托盤 安裝類型:表面貼裝 產品目錄頁面:882 (CN2011-ZH PDF) 其它名稱:296-19316
UPD72255YF1-GA5-A 制造商:Renesas Electronics Corporation 功能描述:
UPD7225G 制造商:Panasonic Industrial Company 功能描述:IC