參數資料
型號: ML60851DTB
廠商: LAPIS SEMICONDUCTOR CO LTD
元件分類: 總線控制器
英文描述: UNIVERSAL SERIAL BUS CONTROLLER, PQFP44
封裝: 10 X 10 MM, 0.80 MM PITCH, PLASTIC, TQFP-44
文件頁數: 74/84頁
文件大?。?/td> 394K
代理商: ML60851DTB
FEDL60851D-01
1Semiconductor
ML60851D
75/83
Packets and packet sizes
The ML60851D packs the transmit data into packets and unpacks (restores to the original form) the received data.
The packed data that is recognized by the software client is a set of data consisting of one or more packets, and
this is called an I/O request (IRP).
Among the several packets in an IRP, all the packets other than the last packet are transferred with the maximum
packet size. Only the last packet can be transferred as a "short packet", that is, a packet whose size is less than the
maximum packet size.
The ML60851D has payload registers corresponding to each end point, and it is possible to set the maximum
packet size for each end point in these registers. The maximum packet size should be within the capacity of the
corresponding FIFO, and can be set as follows:
(1) EP0 Receive packet size can be 8 bytes or less;
(2) EP0 Transmit packet size can be 8 bytes or less;
(3) EP1 Transmit/receive packet size can be 64 bytes or less;
(4) EP2 Transmit/receive packet size can be 64 bytes or less;
(5) EP3 Transmit packet size can be 8 bytes or less;
On the USB bus, the separation between successive packets is distinguished by appending a special signal
condition called EOP (End of Packet) at the end of each packet. The appending of EOP during transmission and
the detection and removal of EOP during reception are carried out by the ML60851D automatically.
(1) At the time of transmission, the packet is deemed to have ended when the local MCU has completed writing
the required number of bytes of data in the transmit FIFO and has then asserted the transmit ready status bit.
(The actual addition of EOP is executed at the time of transmitting the data over the USB bus after waiting for
the IN token from the host.) The packet will be a short packet if the transmit packet ready status bit is asserted
after writing data with less number of bytes than the maximum packet size. In particular, by asserting the
transmit packet ready status bit without writing any data, it is possible to form a null packet whose data length
is zero.
Packet
1
I/O Request Packet (IRP)
Maximum packet size
Packet
2
Packet
n-1
Packet
n
1 Packet
M Bytes
相關PDF資料
PDF描述
ML60852A UNIVERSAL SERIAL BUS CONTROLLER, PQFP44
ML63187-XXXGA 4-BIT, MROM, 2 MHz, MICROCONTROLLER, PQFP128
ML63193-XXXWA 4-BIT, MROM, 2 MHz, MICROCONTROLLER, UUC128
ML64168-XXX 4-BIT, MROM, 0.7 MHz, MICROCONTROLLER, UUC80
ML64P168-NGP 4-BIT, OTPROM, 0.7 MHz, MICROCONTROLLER, PQFP80
相關代理商/技術參數
參數描述
ML60851E 制造商:OKI 制造商全稱:OKI electronic componets 功能描述:USB Device Controller
ML60851EGA 制造商:OKI 制造商全稱:OKI electronic componets 功能描述:USB Device Controller
ML60851ETB 制造商:OKI 制造商全稱:OKI electronic componets 功能描述:USB Device Controller
ML60852 制造商:OKI 制造商全稱:OKI electronic componets 功能描述:USB Device Controller
ML60852A 制造商:OKI 制造商全稱:OKI electronic componets 功能描述:USB Device Controller