參數資料
型號： M37754S4CGP
廠商： Mitsubishi Electric Corporation
英文描述： SINGLE-CHIP 16BIT CMOS MICROCOMPUTER
中文描述： 單芯片16位微機的CMOS
文件頁數： 23/114頁
文件大?。?/td> 1116K
代理商： M37754S4CGP
23
PRELIMINARY
Notice: This is not a final specification.
Some parametric limits are subject to change.
MITSUBISHI MICROCOMPUTERS
M37754M8C-XXXGP, M37754M8C-XXXHP
M37754S4CGP, M37754S4CHP
SINGLE-CHIP 16-BIT CMOS MICROCOMPUTER
TIMER
There are eight 16-bit timers. They are divided by type into timer A(5)
and timer B(3).
The timer I/O pins are multiplexed with I/O pins for port P5 and P6.
To use these pins as timer input pins, the data direction register bit
corresponding to the pin must be cleared to “0” to specify input mode.
TIMER A
Figure 17 shows a block diagram of timer A.
Timer A has four modes: timer mode, event counter mode, one-shot
pulse mode, and pulse width modulation mode. The mode is se-
lected with bits 0 and 1 of the timer Ai mode register (i = 0 to 4). Each
of these modes is described below.
(1) Timer mode [00]
Figure 18 shows the bit configuration of the timer Ai mode register
during timer mode. Bits 0 and 1 of the timer Ai mode register must be
“0” in timer mode. Bits 3, 4, and 5 are used to select the gate func-
tion. Bits 4 and 5 must be “0” when not selecting the gate function.
Bit 3 is ignored if bit 4 is “0”.
Bits 6 and 7 are used to select the timer counter source.
The counting of the selected clock starts when the count start bit is
“1” and stops when it is “0”.
Figure 19 shows the bit configuration of the count start bit. The
counter is decremented, an interrupt is caused and the interrupt re-
quest bit in the timer Ai interrupt control register is set when the con-
tents becomes 0000
16
. At the same time, the contents of the reload
register is transferred to the counter and count is continued.
When data is written to timer Ai register with timer Ai halted, the same
data is also written to the reload register and the counter. When data
is written to timer Ai which is busy, the data is written to the reload
register, but not to the counter. The new data is reloaded from the re-
load register to the counter at the next reload time and counting con-
tinues. The contents of the counter can be read at any time.
When the value set in the timer Ai register is n, the timer frequency
dividing ratio is 1/(n+1).
Fig. 17 Block diagram of timer A
Timer
One-shot
Pulse width modulation
Count start bit
(40
16
)
Down count
Data bus (odd)
Data bus (even)
Reload register(16)
Counter(16)
(Lower 8 bits)
(Higher 8 bits)
Always decremented
except in event count mode
Timer A0 47
16
46
16
Timer A1 49
16
48
16
Timer A2 4B
16
4A
16
Timer A3 4D
16
4C
16
Timer A4 4F
16
4E
16
Up/Down
Toggle flip-flop
Up-down bit
(44
16
)
Polarity
selection
A
ddresses
External trigger
Event counter
TAi
IN
(i = 0–4)
TAi
OUT
(i = 0–4)
Timer(gate function)
Clock source selection
Pulse output
Pf
2
Pf
16
Pf
64
Pf
512
Note:
Perform write and read to/from timer Ai register in the condition of 16-bit data length : data length flag (m) = “0”.
相關PDF資料
PDF描述
M37754S4CHP SINGLE-CHIP 16BIT CMOS MICROCOMPUTER
M37754 SINGLE-CHIP 16BIT CMOS MICROCOMPUTER
M37754M8C Single Chip 16 Bits CMOS Microcomputer(16位單片機)
M37902F8CHP DIODE SCHOTTKY DUAL COMMON-ANODE 25V 200mW 0.32V-vf 200mA-IFM 1mA-IF 2uA-IR SOT-23 3K/REEL
M37902FGCGP SINGLE-CHIP 16-BIT CMOS MICROCOMPUTER
相關代理商/技術參數
參數描述
M37754S4CHP 制造商:RENESAS 制造商全稱:Renesas Technology Corp 功能描述:SINGLE-CHIP 16-BIT CMOS MICROCOMPUTER
M3775PR-H400CL 制造商:Bonitron 功能描述:OVERVOLTAGE BRAKING RESISTOR
M3775RK-0.75A 制造商:Bonitron 功能描述:OVERVOLTAGE BRAKING RESISTOR
M3775RK-C0.50A 制造商:Bonitron 功能描述:OVERVOLTAGE BRAKING RESISTOR
M3775RK-C0.50B 制造商:Bonitron 功能描述:OVERVOLTAGE BRAKING RESISTOR
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*