參數資料
型號： ZPSD611(V)E1
英文描述： Field Programmable Microcontroller Peripherals with Embedded Micro--Cell(可編程邏輯，零功耗，4K位SRAM,26個可編程I/O,通用PLD有63個輸入)
中文描述： 現場可編程微控制器外圍設備和嵌入式微-細胞（可編程邏輯，零功耗，4K的位的SRAM，26余個可編程輸入/輸出，通用PLD的有63個輸入）
文件頁數： 55/98頁
文件大小： 484K
代理商： ZPSD611(V)E1
ZPSD6XX(V) Family
12-55
Bit 7
PIO_EN
Bit 6* Bit 5* Bit 4* Bit 3* Bit 2*
Bit 1
RD_EN
Bit 0
PSEN_EN
0 = disable
PIO mode
0 = RD access
SRAM, I/O
0 = PSEN access
EPROM only
1 = enable
PIO mode
1 = RD access
EPROM,
SRAM, I/O
1 = PSEN access
EPROM,
SRAM, I/O
Table 29. VM Register
*
Bit 6-2 are not used, set to “0”.
Memory Select for 8031 Microcontrollers
The 8031 family of microcontrollers, including 80C251 and 80C51XA, has a separate
address space for code memory (enabled by PSEN) and data memory (enabled by RD).
The ZPSD6XX(V) allows the EPROM and SRAM to reside in the program space, data
space or both. Three different configurations are possible:
J
Separate Space Mode
Code memory space is separated from data memory space. The PSEN signal is used
to access the program code from the EPROM, and the RD signal is used to access
data from the SRAM and I/O Ports. This is the default configuration.
J
Combined Space Mode
The program and data memory spaces are combined into one 64KB block space that
allows the EPROM or SRAM to be accessed by either PSEN or RD. The EPROM and
SRAM blocks address space must not overlap. This mode is enabled by the
microcontroller by setting the bits in the VM Register as shown in Table 29. If Bit 0
is “1”, either PSEN or RD can access the SRAM. If Bit 1 is a “1”, either RD or PSEN
can access the EPROM. Figure 27 shows the memory select logic for Combined
Space Mode.
J
Mixed Mode
Allows individual EPROM blocks to be configured in either Data Space or Program
Space. EPROM block chip selects must be qualified with the 8031 RD input in the
ES0–ES7 equations. An active low RD will select EPROM blocks in data space and
disable the blocks that are in program space. For EPROM blocks that reside in data
space, the access time is calculated from RD valid to data valid. This mode is set
automatically by PSDsoft whenever the RD signal is included in the EPROM chip
select equations.
Memory Blocks
(cont.)
相關PDF資料
PDF描述
ZPSD612(V)E1 Field Programmable Microcontroller Peripherals with Embedded Micro--Cell(可編程邏輯，零功耗，4K位SRAM,26個可編程I/O,通用PLD有63個輸入)
ZPSD613(V)E1 Field Programmable Microcontroller Peripherals with Embedded Micro--Cell(可編程邏輯，零功耗，4K位SRAM,26個可編程I/O,通用PLD有63個輸入)
ZPSD813F1V Flash In System Programmable Mirocomputer Peripherals(閃速，在系統可編程微控制器外圍器件，1M位閃速存儲器，256K位EEPROM，16K位SRAM)
ZR33771GC-40 Cell Rectifier Diodes
ZR33771GM-20 Cell Rectifier Diodes
相關代理商/技術參數
參數描述
ZPSD612E1-15L 制造商:WSI 功能描述:
ZPSD612E1V-20L 制造商:WSI 功能描述:
ZPSD613E1-15J 制造商:WSI 功能描述:
ZPSD613E1-15L 制造商:WSI 功能描述:
ZPSD613E1-70J 制造商:WSI 功能描述:
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*