![](http://datasheet.mmic.net.cn/370000/UPD703215_datasheet_16743812/UPD703215_38.png)
CHAPTER 1 INTRODUCTION
User’s Manual U16890EJ1V0UD
38
(h) Watch timer
This timer counts the reference time (0.5 seconds) for counting the clock from the subclock (32.768 kHz)
or f
BRG
(32.768 kHz) from the clock generator. At the same time, the watch timer can be used as an
interval timer.
(i) Watchdog timer
Two watchdog timer channels are provided on chip to detect program loops and system abnormalities.
Watchdog timer 1 can be used as an interval timer. When used as a watchdog timer, it generates a non-
maskable interrupt request signal (INTWDT1) or system reset signal (WDTRES1) after an overflow occurs.
When used as an interval timer, it generates a maskable interrupt request signal (INTWDTM1) after an
overflow occurs.
Watchdog timer 2 operates by default following reset release.
It generates a non-maskable interrupt request signal (INTWDT2) or system reset signal (WDTRES2) after
an overflow occurs.
(j) Serial interface (SIO)
The V850ES/KG1 includes four kinds of serial interfaces: an asynchronous serial interface (UARTn), a
clocked serial interface (CSI0n), a clocked serial interface with an automatic transmit/receive function
(CSIAn), and an I
70F3214H, and 70F3215H can simultaneously use up to six channels, and the
μ
PD703212Y, 703213Y,
703214Y, 703215Y, 70F3214Y, 70F3214HY, and 70F3215HY up to seven channels.
For UARTn, data is transferred via the TXDn and RXDn pins.
For CSI0n, data is transferred via the SO0n, SI0n, and SCK0n pins.
For CSIAn, data is transferred via the SOAn, SIAn, and SCKAn pins.
For I
I
70F3215HY.
2
C bus interface (I
2
C0). The
μ
PD703212, 703213, 703214, 703215, 70F3214,
2
C0, data is transferred via the SDA0 and SCL0 pins.
2
C0 is provided only in the
μ
PD703212Y, 703213Y, 703214Y, 703215Y, 70F3214Y, 70F3214HY, and
Remark
n = 0, 1
(k) A/D converter
This high-speed, high-resolution 10-bit A/D converter includes 8 analog input pins. Conversion is
performed using the successive approximation method.
(l) D/A converter
Two 8-bit resolution D/A converter channels are included on chip. The D/A converter uses the R-2R
ladder method.
(m) ROM correction
This function is used to replace part of a program in the mask ROM with that contained in the internal
RAM. Up to four correction addresses can be specified.
(n) Key interrupt function
A key interrupt request signal (INTKR) can be generated by inputting a falling edge to the eight key input
pins.