- 您現在的位置：買賣IC網 > PDF目錄359289 > TEA5764HN (NXP SEMICONDUCTORS) FM radio + RDS PDF資料下載
參數資料
| 型號： | TEA5764HN |
| 廠商： | NXP SEMICONDUCTORS |
| 元件分類： | 接收器 |
| 英文描述： | FM radio + RDS |
| 中文描述： | FM, AUDIO SINGLE CHIP RECEIVER, PQCC40 |
| 封裝： | 6 X 6 MM, 0.85 MM HEIGHT, PLASTIC, MO-220, SOT-618-1, HVQFN-40 |
| 文件頁數： | 15/64頁 |
| 文件大?。?/td> | 287K |
| 代理商： | TEA5764HN |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁當前第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁
TEA5764HN_2
Koninklijke Philips Electronics N.V. 2005. All rights reserved.
Product data sheet
Rev. 02 — 9 August 2005
15 of 64
Philips Semiconductors
TEA5764HN
FM radio + RDS
The algorithm will finish with the FRRFLAG being set and an interrupt is generated. After
this interrupt the TEA5764HN will not measure the IF count for a period of 15 ms. 15 ms
after completing a RDS jump, a measurement of the IF count will start and hence the IF
count result and the IFFLAG will be updated 30.6 ms after completing the algorithm. The
level measurement will start immediately after the tuning algorithm, so the LEVFLAG will
be updated 500
μ
s after the algorithm. The state of the TEA5764HN can be checked by
reading registers INTFLAG, FRQCHKLSB, FRQCHKMSB, IFCHK and LEVCHK.
Table 5
shows the possible states after an auto search,
Figure 5
shows how the RDS is updated.
8.22.1
Muting during RDS update
An RDS update (AF jump) is always muted. There are two possibilities for leaving the
algorithm:
The tuner jumps to an alternative frequency which is not valid (according to the
specified SSL limit and fixed IF counter limits) and jumps back, then it will
automatically unmute
Or the tuner jumps to a valid alternative frequency and stays there. Now it does not
unmute. The microprocessor can unmute or it keeps the tuner muted and can check
for the presence of RDS data. The valid way to unmute is to apply a preset to the
current frequency (an IF count time of 15.6 ms is used at preset, which gives a more
accurate IF count result than the result obtained by the AF jump, where 2 ms is used)
[1]
This table is valid until 30.6 ms after an RDS update has completed. It shows the outcome of the flag
register when a read is done after pin INTX has gone LOW and on condition that only mask bit FRRMSK is
set.
Table 5:
IFFLAG BLFLAG
0
RDS update truth table
[1]
FRRFLAG Comment
0
0
if pin INTX is LOW and only IFMSK, FRRMSK and BLMSK were
set then this cannot occur
alternative frequency jump successful; radio is tuned to the
alternative frequency and stays muted
not a valid state
not a valid state
not a valid state
AF jump has occurred but the wanted channel fails the IF count;
the PLL will be set back to the old value
not a valid state
if pin INTX is LOW and only IFMSK, FRRMSK and BLMSK were
set then this cannot occur
0
0
1
0
0
1
1
1
1
0
0
0
1
0
1
1
1
1
1
0
1
相關PDF資料 |
PDF描述 |
|---|---|
| TEA5764UK | FM radio + RDS |
| TEF6700HL | Car radio tuner front-end for digital IF |
| TEF6701HL | Car radio tuner front-end for digital IF |
| TEMUX-84 | Ultraframer DS3/E3/DS2/E2/DS1/E1/DS0 |
| TFDT4000 | Integrated Transceiver |
相關代理商/技術參數 |
參數描述 |
|---|---|
| TEA5764HN2GE | 制造商:STMicroelectronics 功能描述: |
| TEA5764UK | 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:FM radio + RDS |
| TEA5764UK/N2,027 | 功能描述:調諧器 FM RADIO WITH RDS RoHS:否 制造商:NXP Semiconductors 功能: 噪聲系數: 工作電源電壓: 最小工作溫度: 最大工作溫度: |
| TEA5764UK-G | 功能描述:調諧器 FM RADIO WITH RDS RoHS:否 制造商:NXP Semiconductors 功能: 噪聲系數: 工作電源電壓: 最小工作溫度: 最大工作溫度: |
| TEA5766UK/N1,023 | 功能描述:調節器/解調器 FM RADIO + RDS RoHS:否 制造商:Texas Instruments 封裝 / 箱體:PVQFN-N24 封裝:Reel |
發布緊急采購，3分鐘左右您將得到回復。