- 您現在的位置：買賣IC網 > PDF目錄17112 > EVAL-ADUC834QSZ (Analog Devices Inc)KIT DEV QUICK START ADUC834 PDF資料下載
參數資料
| 型號： | EVAL-ADUC834QSZ |
| 廠商： | Analog Devices Inc |
| 文件頁數： | 64/80頁 |
| 文件大?。?/td> | 0K |
| 描述： | KIT DEV QUICK START ADUC834 |
| 標準包裝： | 1 |
| 系列： | QuickStart™ 套件 |
| 類型： | MCU |
| 適用于相關產品： | ADuC834 |
| 所含物品： | 評估板，線纜，電源，軟件和文檔 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁當前第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁
REV. A
ADuC834
–67–
OTHER HARDWARE CONSIDERATIONS
In-Circuit Serial Download Access
Nearly all ADuC834 designs will want to take advantage of the
in-circuit reprogrammability of the chip. This is accomplished
by a connection to the ADuC834’s UART, which requires an
external RS-232 chip for level translation if downloading code
from a PC. Basic configuration of an RS-232 connection is
illustrated in Figure 66 with a simple ADM3202-based circuit.
If users would rather not include an RS-232 chip onto the target
board, refer to the application note uC006–A 4-Wire UART-to-PC
Interface available at www.analog.com/microconverter, for a
simple (and zero-cost-per-board) method of gaining in-circuit
serial download access to the ADuC834.
In addition to the basic UART connections, users will also need
a way to trigger the chip into Download mode. This is accom-
plished via a 1 k
pull-down resistor that can be jumpered onto
the
PSEN pin, as shown in Figure 66. To get the ADuC834 into
Download mode, simply connect this jumper and power-cycle
the device (or manually reset the device, if a manual reset button
is available) and it will be ready to receive a new program serially.
With the jumper removed, the device will power-on in Normal
mode (and run the program) whenever power is cycled or RESET
is toggled.
Note that
PSEN is normally an output (as described in the
External Memory Interface section) and it is sampled as an input
only on the falling edge of RESET (i.e., at power-up or upon an
external manual reset). Note also that if any external circuitry
unintentionally pulls
PSEN low during power-up or reset events,
it could cause the chip to enter Download Mode and therefore
fail to begin user code execution as it should. To prevent this,
ensure that no external signals are capable of pulling the
PSEN
pin low, except for the external
PSEN jumper itself.
Embedded Serial Port Debugger
From a hardware perspective, entry to Serial Port Debug mode
is identical to the serial download entry sequence described
above. In fact, both Serial Download and Serial Port Debug
modes can be thought of as essentially one mode of operation
used in two different ways.
Note that the serial port debugger is fully contained on the
ADuC834 device, (unlike “ROM monitor” type debuggers) and
therefore no external memory is needed to enable in-system
debug sessions.
Single-Pin Emulation Mode
Also built into the ADuC834 is a dedicated controller for single-
pin in-circuit emulation (ICE) using standard production ADuC834
devices. In this mode, emulation access is gained by connection
to a single pin, the
EA pin. Normally, this pin is hard-wired
either high or low to select execution from internal or external
program memory space, as described earlier. To enable single-pin
emulation mode, however, users will need to pull the
EA pin
high through a 1 k
resistor as shown in Figure 66. The emulator
will then connect to the 2-pin header also shown in Figure 66.
To be compatible with the standard connector that comes
with the single-pin emulator available from Accutron Limited
(www.accutron.com), use a 2-pin 0.1-inch pitch Friction Lock
header from Molex (www.molex.com) such as their part number
22-27-2021. Be sure to observe the polarity of this header. As
represented in Figure 66, when the Friction Lock tab is at the
right, the ground pin should be the lower of the two pins (when
viewed from the top).
相關PDF資料 |
PDF描述 |
|---|---|
| EVAL-ADUC847QSZ | KIT DEV QUICK START FOR ADUC847 |
| GBM24DTKT | CONN EDGECARD 48POS DIP .156 SLD |
| EVAL-ADUC7026QSZ | KIT DEV FOR ADUC7026/7027 |
| GEM36DSXS | CONN EDGECARD 72POS DIP .156 SLD |
| GBM18DSAI | CONN EDGECARD 36POS R/A .156 SLD |
相關代理商/技術參數 |
參數描述 |
|---|---|
| EVAL-ADUC836QS | 制造商:Analog Devices 功能描述:MCU 8BIT 8052 CISC 62KB+4KB FLASH 3.6V 48LQFP - Bulk 制造商:Analog Devices 功能描述:KIT- ADUC836 DEV SYSTEM |
| EVAL-ADUC841QS | 制造商:AD 制造商全稱:Analog Devices 功能描述:MicroConverter 12-Bit ADCs and DACs with Embedded High Speed 62-kB Flash MCU |
| EVAL-ADUC841QSP2 | 制造商:AD 制造商全稱:Analog Devices 功能描述:MicroConverter 12-Bit ADCs and DACs with Embedded High Speed 62-kB Flash MCU |
| EVAL-ADUC841QSPZ | 功能描述:KIT DEV QUICK START ADUC841 RoHS:是 類別:編程器，開發系統 >> 通用嵌入式開發板和套件（MCU、DSP、FPGA、CPLD等） 系列:QuickStart™ PLUS 套件 標準包裝:1 系列:PICDEM™ 類型:MCU 適用于相關產品:PIC10F206，PIC16F690，PIC16F819 所含物品:板，線纜，元件，CD，PICkit 編程器 產品目錄頁面:659 (CN2011-ZH PDF) |
| EVAL-ADUC841QSPZ | 制造商:Analog Devices 功能描述:Silicon Manufacturer:Analog Devices C |
發布緊急采購，3分鐘左右您將得到回復。