- 您現在的位置：買賣IC網 > PDF目錄17112 > EVAL-ADUC834QSZ (Analog Devices Inc)KIT DEV QUICK START ADUC834 PDF資料下載
參數資料
| 型號： | EVAL-ADUC834QSZ |
| 廠商： | Analog Devices Inc |
| 文件頁數： | 48/80頁 |
| 文件大?。?/td> | 0K |
| 描述： | KIT DEV QUICK START ADUC834 |
| 標準包裝： | 1 |
| 系列： | QuickStart™ 套件 |
| 類型： | MCU |
| 適用于相關產品： | ADuC834 |
| 所含物品： | 評估板，線纜，電源，軟件和文檔 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁當前第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁
REV. A
–52–
ADuC834
TIMERS/COUNTERS
The ADuC834 has three 16-bit Timer/Counters: Timer 0,
Timer 1, and Timer 2. The Timer/Counter hardware has been
included on-chip to relieve the processor core of the overhead
inherent in implementing timer/counter functionality in soft-
ware. Each Timer/Counter consists of two 8-bit registers THx
and TLx (x = 0, 1 and 2). All three can be configured to oper-
ate either as timers or event counters.
In ‘Timer’ function, the TLx Register is incremented every
machine cycle. Thus it can be viewed as counting machine
cycles. Since a machine cycle consists of 12 core clock periods,
the maximum count rate is 1/12 of the core clock frequency.
In ‘Counter’ function, the TLx Register is incremented by a
1-to-0 transition at its corresponding external input pin, T0,
T1, or T2. In this function, the external input is sampled during
S5P2 of every machine cycle. When the samples show a high in
one cycle and a low in the next cycle, the count is incremented.
The new count value appears in the register during S3P1 of the
cycle following the one in which the transition was detected.
Since it takes two machine cycles (16 core clock periods) to
recognize a 1-to-0 transition, the maximum count rate is 1/16 of
the core clock frequency. There are no restrictions on the duty
cycle of the external input signal, but to ensure that a given level
is sampled at least once before it changes, it must be held for a
minimum of one full machine cycle. Remember that the core
clock frequency is programmed via the CD0–2 selection bits in
the PLLCON SFR.
User configuration and control of the timers is achieved via
three main SFRs. TMOD and TCON control the configuration
of Timers 0 and 1 while T2CON configures Timer 2.
TMOD
Timer/Counter 0 and 1 Mode Register
SFR Address
89H
Power-On Default Value
00H
Bit Addressable
No
Table XXVI. TMOD SFR Bit Designations
Bit
Name
Description
7
Gate
Timer 1 Gating Control.
Set by software to enable timer/counter 1 only while
INT1 pin is high and TR1 control bit is set.
Cleared by software to enable Timer 1 whenever TR1 control bit is set.
6C/
T
Timer 1 Timer or Counter Select Bit.
Set by software to select counter operation (input from T1 pin).
Cleared by software to select timer operation (input from internal system clock).
5M1Timer 1 Mode Select Bit 1 (used with M0 Bit)
4M0Timer 1 Mode Select Bit 0.
M1
M0
00
TH1 operates as an 8-bit timer/counter. TL1 serves as 5-bit prescaler.
01
16-Bit Timer/Counter. TH1 and TL1 are cascaded; there is no prescaler.
10
8-Bit Auto-Reload Timer/Counter. TH1 holds a value that is to be
reloaded into TL1 each time it overflows.
11Timer/Counter 1 Stopped.
3
Gate
Timer 0 Gating Control.
Set by software to enable timer/counter 0 only while
INT0 pin is high and TR0 control bit is set.
Cleared by software to enable Timer 0 whenever TR0 control bit is set.
2C/
T
Timer 0 Timer or Counter Select Bit.
Set by software to select counter operation (input from T0 pin).
Cleared by software to select timer operation (input from internal system clock).
1M1Timer 0 Mode Select Bit 1
0M0Timer 0 Mode Select Bit 0.
M1
M0
00
TH0 operates as an 8-bit timer/counter. TL0 serves as 5-bit prescaler.
01
16-Bit Timer/Counter. TH0 and TL0 are cascaded; there is no prescaler
108-Bit Auto-Reload Timer/Counter. TH0 holds a value that is to be
reloaded into TL0 each time it overflows.
11
TL0 is an 8-bit timer/counter controlled by the standard timer 0 control
bits. TH0 is an 8-bit timer only, controlled by Timer 1 control bits.
相關PDF資料 |
PDF描述 |
|---|---|
| EVAL-ADUC847QSZ | KIT DEV QUICK START FOR ADUC847 |
| GBM24DTKT | CONN EDGECARD 48POS DIP .156 SLD |
| EVAL-ADUC7026QSZ | KIT DEV FOR ADUC7026/7027 |
| GEM36DSXS | CONN EDGECARD 72POS DIP .156 SLD |
| GBM18DSAI | CONN EDGECARD 36POS R/A .156 SLD |
相關代理商/技術參數 |
參數描述 |
|---|---|
| EVAL-ADUC836QS | 制造商:Analog Devices 功能描述:MCU 8BIT 8052 CISC 62KB+4KB FLASH 3.6V 48LQFP - Bulk 制造商:Analog Devices 功能描述:KIT- ADUC836 DEV SYSTEM |
| EVAL-ADUC841QS | 制造商:AD 制造商全稱:Analog Devices 功能描述:MicroConverter 12-Bit ADCs and DACs with Embedded High Speed 62-kB Flash MCU |
| EVAL-ADUC841QSP2 | 制造商:AD 制造商全稱:Analog Devices 功能描述:MicroConverter 12-Bit ADCs and DACs with Embedded High Speed 62-kB Flash MCU |
| EVAL-ADUC841QSPZ | 功能描述:KIT DEV QUICK START ADUC841 RoHS:是 類別:編程器，開發系統 >> 通用嵌入式開發板和套件（MCU、DSP、FPGA、CPLD等） 系列:QuickStart™ PLUS 套件 標準包裝:1 系列:PICDEM™ 類型:MCU 適用于相關產品:PIC10F206，PIC16F690，PIC16F819 所含物品:板，線纜，元件，CD，PICkit 編程器 產品目錄頁面:659 (CN2011-ZH PDF) |
| EVAL-ADUC841QSPZ | 制造商:Analog Devices 功能描述:Silicon Manufacturer:Analog Devices C |
發布緊急采購，3分鐘左右您將得到回復。