參數資料
型號: AD9995
廠商: Analog Devices, Inc.
英文描述: 12-Bit CCD Signal Processor with Precision Timing ⑩ Generator
中文描述: 12位CCD信號處理器與精密計時⑩發生器
文件頁數: 18/60頁
文件大小: 1593K
代理商: AD9995
AD9995
–18–
Vertical Sequences (VSEQ)
The vertical sequences are created by selecting one of the 10
V-pattern groups and adding repeats, start position, and hori-
zontal clamping and blanking information. Up to 10 V-sequences
can be programmed, each using the registers shown in Table VI.
Figure 17 shows how the different registers are used to generate
each V-sequence.
The VPATSEL register selects which V-pattern group will be
used in a given V-sequence. The basic V-pattern group can have
repetitions added, for high speed line shifts or line binning, by
using the VPATREPO and VPATREPE registers. Generally, the
same number of repetitions are programmed into both registers,
but if a different number of repetitions is required on odd and
even lines, separate values may be used for each register (see
the V-Sequence Line Alternation section). The VPATSTART
register specifies where in the line the V-pattern group will start.
The VMASK register is used in conjunction with the FREEZE/
RESUME registers to enable optional masking of the V-outputs.
Either or both of the FREEZE1/RESUME1 and FREEZE2/
RESUME2 registers can be enabled.
The line length (in pixels) is programmable using the HDLEN
registers. Each V-sequence can have a different line length to
accommodate various image readout techniques. The maximum
number of pixels per line is 4096. Note that the last line of the
field is separately programmable using the HDLAST register
located in the Field register section.
Table VI. V-Sequence Registers (see Tables III and IV for HBLK, CLPOB, PBLK Registers)
Length
Range
Description
4b
0–9 V-Pattern Group #
Selected V-Pattern Group for Each V-Sequence.
2b
0–3 Mask Mode
Enables the Masking of V1–V6 Outputs at the Locations Specified by
the FREEZE/RESUME Registers. 0 = No Mask, 1 = Enable
FREEZE1/RESUME1, 2 = Enable FREEZE2/RESUME2, 3 = Enable
both 1 and 2.
12b
0–4095 # of Repeats
Number of Repetitions for the V-Pattern Group for Odd Lines.
If no odd/even alternation is required, set to VPATREPE.
12b
0–4095 # of Repeats
Number of Repetitions for the V-Pattern Group for Even Lines.
If no odd/even alternation is required, set to VPATREPO.
12b
0–4095 Pixel Location
Start Position for the Selected V-Pattern Group.
12b
0–4095 # of Pixels
HD Line Length for Lines in Each V-Sequence.
Register
VPATSEL
VMASK
VPATREPO
VPATREPE
VPATSTART
HDLEN
VPAT REP 3
HD
V1–V6
PROGRAMMABLE SETTINGS FOR EACH V-SEQUENCE:
1. START POSITION IN THE LINE OF SELECTED V-PATTERN GROUP
2. HD LINE LENGTH
3. V-PATTERN SELECT (VPATSEL) TO SELECT ANY V-PATTERN GROUP
4. NUMBER OF REPETITIONS OF THE V-PATTERN GROUP (IF NEEDED)
5. START POLARITY AND TOGGLE POSITIONS FOR CLPOB AND PBLK SIGNALS
6. MASKING POLARITY AND TOGGLE POSITIONS FOR HBLK SIGNAL
V-PATTERN GROUP
1
3
CLPOB
PBLK
HBLK
2
4
4
VPAT REP 2
5
6
Figure 17. V-Sequence Programmability
REV. 0
相關PDF資料
PDF描述
ADA4000-2ARMZ-RL Low Cost, Precision JFET Input Operational Amplifiers
ADA4000-1 Low Cost, Precision JFET Input Operational Amplifiers
ADA4000-1_07 Low Cost, Precision JFET Input Operational Amplifiers
ADA4000-1ARZ Low Cost, Precision JFET Input Operational Amplifiers
ADA4000-1ARZ-R7 Low Cost, Precision JFET Input Operational Amplifiers
相關代理商/技術參數
參數描述
AD9995KCP 制造商:Analog Devices 功能描述:AFE Video 1ADC 12-Bit 3V 56-Pin LFCSP EP 制造商:Rochester Electronics LLC 功能描述:12 BIT 36 MSPS ANALOG FRONT END CONVERTE - Bulk
AD9995KCPRL 制造商:Analog Devices 功能描述:AFE Video 1ADC 12-Bit 3V 56-Pin LFCSP EP T/R 制造商:Rochester Electronics LLC 功能描述:- Bulk
AD9995KCPZ 功能描述:IC CCD SIGNAL PROCESSOR 56-LFCSP RoHS:是 類別:集成電路 (IC) >> 接口 - 傳感器和探測器接口 系列:- 其它有關文件:Automotive Product Guide 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:74 系列:- 類型:觸控式傳感器 輸入類型:數字 輸出類型:數字 接口:JTAG,串行 電流 - 電源:100µA 安裝類型:表面貼裝 封裝/外殼:20-TSSOP(0.173",4.40mm 寬) 供應商設備封裝:20-TSSOP 包裝:管件
AD9995KCPZRL 功能描述:IC CCD SIGNAL PROCESSOR 56-LFCSP RoHS:是 類別:集成電路 (IC) >> 接口 - 傳感器和探測器接口 系列:- 其它有關文件:Automotive Product Guide 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:74 系列:- 類型:觸控式傳感器 輸入類型:數字 輸出類型:數字 接口:JTAG,串行 電流 - 電源:100µA 安裝類型:表面貼裝 封裝/外殼:20-TSSOP(0.173",4.40mm 寬) 供應商設備封裝:20-TSSOP 包裝:管件
AD9995KCPZRL7 制造商:Rochester Electronics LLC 功能描述: 制造商:Analog Devices 功能描述: