- 您現在的位置：買賣IC網 > PDF目錄372308 > ST623X-KIT 8 MBIT (X8, BLOCK ERASE) FLASH MEMORY PDF資料下載
參數資料
| 型號： | ST623X-KIT |
| 英文描述： | 8 MBIT (X8, BLOCK ERASE) FLASH MEMORY |
| 中文描述： | 入門套件小冊子的ST6230 |
| 文件頁數： | 39/86頁 |
| 文件大?。?/td> | 531K |
| 代理商： | ST623X-KIT |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁當前第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁
39/86
ST62T30B ST62E30B
I/O PORTS
(Cont’d)
4.1.2 Safe I/O State Switching Sequence
Switching the I/O ports from one state to another
should be done in a sequence which ensures that
no unwanted side effects can occur. The recom-
mended safe transitionsare illustrated in Figure 2.
All other transitions are potentially risky and
should be avoided when changing the I/O operat-
ing mode, as itis most likely that undesirable side-
effects willbe experienced, such asspurious inter-
rupt generation or two pins shorted together by the
analog multiplexer.
Single bit instructions (SET, RES, INC and DEC)
should be used with great caution on Ports Data
registers, since theseinstructions make an implicit
read and write back of the entire register. In port
input mode, however, the data registerreads from
the input pins directly, and not from the data regis-
ter latches. Since data registerinformation in input
mode is used to set the characteristics of the input
pin (interrupt, pull-up, analog input), these may be
unintentionally reprogrammed depending on the
state of the input pins.As a general rule, itis better
to limit the use of single bit instructions on data
registers to when the whole (8-bit) port is in output
mode. In the case of inputs or of mixed inputs and
outputs, it is advisable to keep a copy of the data
register in RAM. Single bit instructions may then
be used on the RAM copy, after which the whole
copy register can be written to the port data regis-
ter:
SET bit, datacopy
LD a, datacopy
LD DRA, a
Warning:
Care must also be taken to not use in-
structions that act on a whole port register (INC,
DEC, or read operations) when all 8 bits are not
available on the device. Unavailable bits must be
masked by software (AND instruction).
The WAIT and STOP instructions allow the
ST62xx to be used in situations where low power
consumption is needed. The lowest power con-
sumption is achieved by configuring I/Os in input
mode with well-defined logic levels.
The user must take care not to switch outputs with
heavy loads during the conversion of one of the
analog inputs in order to avoid any disturbance to
the conversion.
Figure 22. Diagram showingSafe I/O State Transitions
Note *.
xxx = DDR, OR, DR Bits respectively
5 I/O PORTS
(Cont’d)
Table 14. I/O Port configuration for the ST62T30B/E30B
Note 1
. Provided the correct configuration has been selected.
I/O PORTS
(Cont’d)
5.0.1 ARTimer alternate functions
As long as PWMEN (resp. OVFEN) bitis kept low,
the PA3/PWM (resp. PA2/OVF) pin is used as
standard I/O pin and thereforecan beconfigured in
any mode through the DDR and OR registers.
Interrupt
pull-up
Output
Open Drain
Output
Push-pull
Input
pull-up (Reset
state)
Input
Analog
Output
Open Drain
Output
Push-pull
Input
010*
000
100
110
011
001
101
111
相關PDF資料 |
PDF描述 |
|---|---|
| ST62T32BB3 | 8-BIT MICROCONTROLLER |
| ST62T32BQ3 | 8-BIT MICROCONTROLLER |
| ST623X-DBE | D/A Converter (D-A) IC; Resolution (Bits):24; Update Rate:192kSPS; No. of DACs:6; Data Interface:Serial; Package/Case:48-LQFP; Leaded Process Compatible:No; No. of Bits:24; No. of Channels:6; Operating Temp. Max:85 C RoHS Compliant: Yes |
| ST623X-EMU2 | REAL TIME EMULATION DEVELOPMENT TOOLS FOR ST6 MCU FAMILY |
| ST62T65BB3 | 8-BIT MICROCONTROLLER |
相關代理商/技術參數 |
參數描述 |
|---|---|
| ST623X-KIT/110 | 功能描述:開發板和工具包 - 其他處理器 ST623X Starter Kit RoHS:否 制造商:Freescale Semiconductor 產品:Development Systems 工具用于評估:P3041 核心:e500mc 接口類型:I2C, SPI, USB 工作電源電壓: |
| ST623X-KIT/220 | 制造商:STMicroelectronics 功能描述:ST Development Kit, Including ST623X Starter Kit, Development Software CD-ROM, Parallel Cable, Power Supply, Window Development Devices ST62E30BF1, ST (More...) |
| ST623X-KIT/UK | 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:STARTER KIT AB 8K BYTE |
| ST-6-24 | 功能描述:XFRMR PWR 115V 12VAC 1.6A RoHS:是 類別:變壓器 >> 功率 系列:ST 標準包裝:1 系列:260 類型:標準 最大功率:65 VA 主線圈:雙 副線圈:三路，中心抽頭 在某電流時的串聯輸出電壓:500 VAC @ 85mA，5 VAC @ 2A，6.3 VAC @ 2A 在某電流時的并聯輸出電壓:- 安裝類型:底座安裝 尺寸/尺寸:102.36mm L x 67.31mm W 高度 - 座高（最大）:66.80mm 端接類型:導線引線 |
| ST6-24 | 制造商:SUPERWORLD 制造商全稱:Superworld Electronics 功能描述:POWER TRANSFORMER |
發布緊急采購，3分鐘左右您將得到回復。