- 您現在的位置：買賣IC網 > PDF目錄383804 > SA2400A (NXP Semiconductors N.V.) Single chip transceiver for 2.45 GHz ISM band PDF資料下載
參數資料
| 型號： | SA2400A |
| 廠商： | NXP Semiconductors N.V. |
| 英文描述： | Single chip transceiver for 2.45 GHz ISM band |
| 中文描述： | 單為2.45 GHz的ISM頻帶收發器芯片 |
| 文件頁數： | 17/34頁 |
| 文件大?。?/td> | 325K |
| 代理商： | SA2400A |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁當前第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁
Philips Semiconductors
Product data
SA2400A
Single chip transceiver for 2.45 GHz ISM band
2002 Nov 04
17
12.4 Main output charge pumps and fractional
compensation currents (see Figure 7)
The main charge pumps on pin CP are driven by the main phase
detector and the charge pump current value is determined by bit CP
(Synthesizer Register C). The fractional compensation is derived
from the contents of the fractional accumulator FRD and by the
program value of the FDAC. The timing for the fractional
compensation is derived from the main divider. The charge pumps
will enter speed-up mode after sending a Synthesizer Register A
word and stays active until a different word is sent.
12.5 Principle of fractional compensation
The fractional compensation is designed into the circuit as a means
of reducing or eliminating fractional spurs that are caused by the
fractional phase ripple of the main divider. If I
COMP
is the
compensation current and I
PUMP
is the pump current:
I
PUMP_TOTAL
= I
PUMP
+ I
COMP
.
The compensation is done by sourcing a small current, I
COMP
, see
Figure 8, that is proportional to the fractional error phase. For proper
fractional compensation, the area of the fractional compensation
current pulse must be equal to the area of the fractional charge
pump ripple. The width of the fractional compensation pulse is fixed
to 128 VCO cycles, the amplitude is proportional to the fractional
accumulator value and is adjusted by FDAC values (bits FC7–0 in
Synthesizer B). The fractional compensation current is derived from
the main charge pump in that it follows all the current scaling through
programming or speed-up operation. For a given charge pump,
I
COMP
= (I
PUMP
/ 128) * (FDAC / 5*128) * FRD
FRD is the fractional accumulator value.
The target values for FDAC are: 128 for FM = 1 (modulo 5) and
80 for FM = 0 (modulo 8).
12.6 Lock Detect
The output LOCK maintains a logic ‘1’ when main phase detector
indicates a lock condition. The lock condition is defined as a phase
difference of less than 1 period of the frequency at the input
XTAL_1, XTAL_2. Out of lock (logic ‘0’) is indicated when the
synthesizer is powered down.
12.7 Power-down mode
The power-on signal is defined by the bit ON in Synthesizer Register
B. If ON = ‘1’, the synthesizer section is powered on/off as defined
by the chip mode (register 0x04). If ON = ‘0’, it is defined as inverted
to the chip mode. When the synthesizer is reactivated after
power-down, the main and reference dividers are synchronized to
avoid possibility of random phase errors on power-up.
SR01416
REF. DIVIDER
OUTPUT R
MAIN DIVIDER
OUTPUT M
DETECTOR
OUTPUT
ACCUMULATOR
FRACTIONAL
COMPENSATION
CURRENT
OUTPUT ON
PUMP
N
N
N+1
N
N+1
2
4
1
3
0
PULSE
WIDTH
MODULATION
PULSE LEVEL
MODULATION
mA
μ
A
NOTE:
For a proper fractional compensation, the area of the fractional compensation current pulse must be equal to the area of the charge pump ripple output.
Figure 7.
Waveforms for NF = 2 Modulo 5
→
fraction =
2
/
5
SR01800
f
RF
MAIN DIVIDER
FRACTIONAL
ACCUMULATOR
f
REF
I
COMP
I
PUMP
LOOP FILTER
& VCO
Σ
Figure 8.
Current Injection Concept
相關PDF資料 |
PDF描述 |
|---|---|
| SA2400ABE | Single chip transceiver for 2.45 GHz ISM band |
| SA5522 | 1.4 GHz I2C-bus controlled synthesizer |
| SA572F | Programmable analog compandor |
| SAA2013HB-S | Digital Audio Tape Circuit |
| SAA2500GP | Video Processing/ENDEC for MPEG |
相關代理商/技術參數 |
參數描述 |
|---|---|
| SA2400ABE | 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:Single chip transceiver for 2.45 GHz ISM band |
| SA2403 | 功能描述:標準環形連接器 CIRCULAR MALE CONN 3 POLE RoHS:否 制造商:Hirose Connector 系列:EM-W 產品類型:Accessories 位置/觸點數量:1 觸點類型: 觸點電鍍: 安裝風格:Cable 外殼材質: 端接類型:Clamp 電壓額定值: |
| SA2403(3POLE) | 制造商:BULGIN 制造商全稱:BULGIN 功能描述:Plugs and Sockets (3 & 4 pole) |
| SA2404 | 功能描述:標準環形連接器 CIRCULAR FEMALE CONN OUTLET 3 POLE RoHS:否 制造商:Hirose Connector 系列:EM-W 產品類型:Accessories 位置/觸點數量:1 觸點類型: 觸點電鍍: 安裝風格:Cable 外殼材質: 端接類型:Clamp 電壓額定值: |
| SA2404(3POLE) | 制造商:BULGIN 制造商全稱:BULGIN 功能描述:Plugs and Sockets (3 & 4 pole) |
發布緊急采購，3分鐘左右您將得到回復。