- 您現在的位置：買賣IC網 > PDF目錄385432 > HYB18L128160BF (QIMONDA) DRAMs for Mobile Applications 128-Mbit Mobile-RAM PDF資料下載
參數資料
| 型號： | HYB18L128160BF |
| 廠商： | QIMONDA |
| 英文描述： | DRAMs for Mobile Applications 128-Mbit Mobile-RAM |
| 中文描述： | 針對移動應用的DRAM 128 - Mbit的移動RAM |
| 文件頁數： | 11/55頁 |
| 文件大?。?/td> | 1399K |
| 代理商： | HYB18L128160BF |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁當前第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁
Data Sheet
11
Rev. 1.71, 2007-01
05282004-NZNK-8T0D
HY[B/E]18L128160B[C/F]-7.5
128-Mbit Mobile-RAM
Functional DescriptionRegister Definition
5. Whenever a boundary of the block is reached within a given sequence, the following access wraps within the
block.
2.2.1.2
Burst Type
Accesses within a given burst may be programmed to be either sequential or interleaved; this is referred to as the
burst type and is selected via bit A3. The ordering of accesses within a burst is determined by the burst length, the
burst type and the starting column address, as shown in
Table 6
.
2.2.1.3
Read Latency
The Read latency, or CAS latency, is the delay, in clock cycles, between the registration of a READ command and
the availability of the first piece of output data. The latency can be programmed to 2 or 3 clocks.
If a READ command is registered at clock edge n, and the latency is m clocks, the data will be available with clock
edge n
+
m (for details please refer to the READ command description).
2.2.1.4
Write Burst Mode
When A9 = 0, the burst length programmed via A0-A2 applies to both read and write bursts; when A9 = 1, write
accesses consist of single data elements only.
2.2.1.5
Extended Mode Register
The Extended Mode Register controls additional low power features of the device. These include the Partial Array
Self Refresh (PASR, bits A0-A2)), the Temperature Compensated Self Refresh (TCSR, bits A3-A4)) and the drive
strength selection for the DQs (bits A5-A6). The Extended Mode Register is programmed via the MODE
REGISTER SET command (with BA0 = 0 and BA1 = 1) and will retain the stored information until it is programmed
again or the device loses power.
The Extended Mode Register must be loaded when all banks are idle, and the controller must wait the specified
time before initiating any subsequent operation. Violating either of these requirements result in unspecified
operation.
Reserved states should not be used, as unknown operation or incompatibility with future versions may result.
Field
DS
Bits
[6:5]
Type
w
Description
Selectable Drive Strength
00
B
Full Drive Strength
01
B
Half Drive Strength (default)
Note:All other bit combinations are RESERVED.
Temperature Compensated Self Refresh
XX
B
Superseded by on-chip temperature sensor (see text)
TCSR
[4:3]
w
-0",
"!
" !
!
!
!
!
!
!
!
!
!
!
!
!
7"
0 !32
$3
4#32
相關PDF資料 |
PDF描述 |
|---|---|
| HYB18L256160B | DRAMs for Mobile Applications 256-Mbit Mobile-RAM |
| HYMP112S64LMP8-C4 | DDR2 SDRAM SO-DIMM |
| HYMP112S64LMP8-C5 | DDR2 SDRAM SO-DIMM |
| HYMP112S64LMP8-E3 | BNC FEMALE TO RCA MALE COUPLER |
| HYMP112S64LMP8-E4 | DDR2 SDRAM SO-DIMM |
相關代理商/技術參數 |
參數描述 |
|---|---|
| HYB18L128160BF-7.5 | 制造商:INFINEON 制造商全稱:Infineon Technologies AG 功能描述:BJAWBMSpecialty DRAMs Mobile-RAM |
| HYB18L128160BF-75 | 制造商:INFINEON 制造商全稱:Infineon Technologies AG 功能描述:DRAMs for Mobile Applications |
| HYB18L256160B | 制造商:QIMONDA 制造商全稱:QIMONDA 功能描述:DRAMs for Mobile Applications 256-Mbit Mobile-RAM |
| HYB18L256160BC-7.5 | 制造商:INFINEON 制造商全稱:Infineon Technologies AG 功能描述:BJAWBMSpecialty DRAMs Mobile-RAM |
| HYB18L256160BC-75 | 制造商:INFINEON 制造商全稱:Infineon Technologies AG 功能描述:DRAMs for Mobile Applications |
發布緊急采購，3分鐘左右您將得到回復。