- 您現在的位置：買賣IC網 > PDF目錄1909 > CS8952-IQZ (Cirrus Logic Inc)IC TXRX 100/10 PHY 100TQFP PDF資料下載
參數資料
| 型號： | CS8952-IQZ |
| 廠商： | Cirrus Logic Inc |
| 文件頁數： | 66/81頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC TXRX 100/10 PHY 100TQFP |
| 標準包裝： | 90 |
| 類型： | 收發器 |
| 規程： | MII |
| 電源電壓： | 4.75 V ~ 5.25 V |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 100-LQFP |
| 供應商設備封裝： | 100-TQFP（14x14） |
| 包裝： | 托盤 |
| 產品目錄頁面： | 759 (CN2011-ZH PDF) |
| 其它名稱： | 598-1208 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁當前第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁
CS8952
CrystalLAN 100BASE-X and 10BASE-T Transceiver
69
DS206F1
In order to conform with Annex 22B of the IEEE 802.3u specification, the MII_DRV pin should be pulled
high during power-up or reset, and the RX_CLK pin should have an external 33
series resistor. For
systems not required to drive external connectors and cables as described in the IEEE802.3u
specification, the external series resistor may not be necessary.
RX_DV/MII_DRV - Receive Data Valid/MII Drive Strength. Input/Tri-State Output, Pin 33.
Asserted high to indicate valid data nibbles are present on RXD[3:0].
At power-up or at reset, this pin is used as an input to determine the drive strength of the MII output
drivers. When the pin is low, all MII output drivers will be standard 4 mA CMOS drivers. When high,
additional drive strength will be added to the MII output drivers. This pin includes a weak internal pull-
down (> 20 k
), or the value may be set by an external 4.7 k pull-up or pull-down resistor.
In order to conform with Annex 22B of the IEEE 802.3u specification, this pin should be pulled high
during power-up or reset and should have an external 33
series resistor. For systems not required to
drive external connectors and cables as described in the IEEE802.3u specification, it may be possible to
reduce overall power consumption by pulling the pin low at power-up or reset, and the external series
resistor may not be necessary.
RX_EN - Receive Enable. Input, Pin 14.
When high, signals RXD[3:0], RX_CLK, RX_DV, and RX_ER are enabled. When low, these signals are
tri-stated. RX_EN allows the received data signals of multiple PHY transceivers to share the same MII
bus.
This pin includes a weak internal pull-up (> 150 k
), or the value may be set by an external 10 k pull-
up or pull-down resistor.
相關PDF資料 |
PDF描述 |
|---|---|
| CY8CLED04DOCD1-56LTXI | IC POWERPSOC DEBUG 4CH 1A 56VQFN |
| CYG2217 | IC MOD PHONE LINE WIRE 1.07" PCB |
| DAC312ER | IC DAC 12BIT MULT HS 20-CDIP |
| DAC8143FPZ | IC DAC 12BIT DAISYCHAIN 16DIP |
| DAC8228FSZ | IC DAC 8BIT DUAL V-OUT 20SOIC |
相關代理商/技術參數 |
參數描述 |
|---|---|
| CS8952-IQZR | 功能描述:以太網 IC IC 100BASE-TX and 10BASE-T Transceiver RoHS:否 制造商:Micrel 產品:Ethernet Switches 收發器數量:2 數據速率:10 Mb/s, 100 Mb/s 電源電壓-最大:1.25 V, 3.45 V 電源電壓-最小:1.15 V, 3.15 V 最大工作溫度:+ 85 C 封裝 / 箱體:QFN-64 封裝:Tray |
| CS8952T | 制造商:CIRRUS 制造商全稱:Cirrus Logic 功能描述:100BASE E-X AND 10BASE-T TRANSCEIVER |
| CS8952T-CQ | 制造商:CIRRUS 制造商全稱:Cirrus Logic 功能描述:100BASE E-X AND 10BASE-T TRANSCEIVER |
| CS8952T-IQ | 制造商:CIRRUS 制造商全稱:Cirrus Logic 功能描述:100BASE E-X AND 10BASE-T TRANSCEIVER |
| CS8952T-IQR | 制造商:Cirrus Logic 功能描述:ETHERNET TXRX SGL CHIP 1-PORT 5V 10MBPS/100MBPS 100TQFP - Tape and Reel |
發布緊急采購，3分鐘左右您將得到回復。