- 您現在的位置：買賣IC網 > PDF目錄10230 > AD7655ASTZRL (Analog Devices Inc)IC ADC 16BIT 4CHAN 48LQFP PDF資料下載
參數資料
| 型號： | AD7655ASTZRL |
| 廠商： | Analog Devices Inc |
| 文件頁數： | 8/28頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC ADC 16BIT 4CHAN 48LQFP |
| 標準包裝： | 2,000 |
| 系列： | PulSAR® |
| 位數： | 16 |
| 采樣率（每秒）： | 1M |
| 數據接口： | 串行，并聯 |
| 轉換器數目： | 1 |
| 功率耗散（最大）： | 135mW |
| 電壓電源： | 模擬和數字 |
| 工作溫度： | -40°C ~ 85°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 48-LQFP |
| 供應商設備封裝： | 48-LQFP（7x7） |
| 包裝： | 帶卷 (TR) |
| 輸入數目和類型： | 2 個差分，單極 |
| 配用： | EVAL-AD7655CBZ-ND - BOARD EVALUATION FOR AD7655 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁當前第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁
AD7655
Rev. B | Page 16 of 28
TYPICAL CONNECTION DIAGRAM
Figure 17 shows a typical connection diagram for the AD7655.
Some of the circuitry shown in this diagram is optional and is
discussed in the following sections.
ANALOG INPUTS
Figure 18 shows a simplified analog input section of the
AD7655.
INA1
RA
INB2
CS
AGND
AVDD
INA2
INAN
INBN
INB1
RB
03536-018
A0
A0 = L
A0 = H
Figure 18. Simplified Analog Input
The diodes shown in Figure 18 provide ESD protection for
the inputs. Care must be taken to ensure that the analog input
signal never exceeds the absolute ratings on these inputs.
This causes the diodes to become forward biased and start
conducting current. These diodes can handle a forward-biased
current of 120 mA maximum. This condition can occur when
the input buffer (U1) or (U2) supplies are different from AVDD.
In such a case, an input buffer with a short-circuit current
limitation can be used to protect the part.
This analog input structure allows the sampling of the
differential signal between INx and INxN. Unlike other
converters, the INxN is sampled at the same time as the INx
input. By using differential inputs, small signals common to
both inputs are rejected.
During the acquisition phase, for ac signals, the AD7655
behaves like a one-pole RC filter consisting of the equivalent
resistance RA, RB, and C
B
S
. The resistors RA and RB
B
are typically
500 Ω and are a lumped component made up of some serial
resistors and the on resistance of the switches. The CS capacitor
is typically 32 pF and is mainly the ADC sampling capacitor.
This one-pole filter with a typical 3 dB cutoff frequency of
10 MHz reduces undesirable aliasing effects and limits the
noise coming from the inputs.
Because the input impedance of the AD7655 is very high, the
AD7655 can be driven directly by a low impedance source
without gain error. To further improve the noise filtering of the
AD7655 analog input circuit, an external, one-pole RC filter
between the amplifier output and the ADC input, as shown in
Figure 17, can be used. However, the source impedance has to
be kept low because it affects the ac performance, especially the
total harmonic distortion. The maximum source impedance
depends on the amount of total harmonic distortion (THD)
that can be tolerated. The THD degrades when the source
impedance increases.
INPUT CHANNEL MULTIPLEXER
The AD7655 allows the choice of simultaneously sampling the
inputs pairs INA1/INB1 or INA2/INB2 with the A0 multiplexer
input. When A0 is low, the input pairs INA1/INB1 are selected,
and when A0 is high, the input pairs INA2/INB2 are selected.
Note that INAx is always converted before INBx regardless of
the state of the digital interface channel selection A/B pin.
Also note that the channel selection control, A0, should not be
changed during the acquisition phase of the converter. Refer to
the Conversion Control section and Figure 21 for timing details.
DRIVER AMPLIFIER CHOICE
Although the AD7655 is easy to drive, the driver amplifier
needs to meet at least the following requirements:
The noise generated by the driver amplifier needs to be
kept as low as possible to preserve the SNR and transition
noise performance of the AD7655. The noise coming from
the driver is filtered by the AD7655 analog input circuit
one-pole, low-pass filter made by RA, RB, and C
B
S
or by an
external filter, if one is used.
The driver needs to have a THD performance suitable to
that of the AD7655.
For multichannel, multiplexed applications, the driver
amplifier and the AD7655 analog input circuit together
must be able to settle for a full-scale step of the capacitor
array at a 16-bit level (0.0015%). In the data sheet for the
driver amplifier, the settling at 0.1% or 0.01% is more
commonly specified. This could differ significantly from
the settling time at a 16-bit level and should be verified
prior to driver selection.
The AD8021 meets these requirements and, for almost all
applications, is usually appropriate. The AD8021 needs an
external compensation capacitor of 10 pF. This capacitor should
have good linearity as an NPO ceramic or mica type. The
AD8022 can be used where a dual version is needed and a gain
of +1 is used.
The AD829 is another alternative where high frequency (above
100 kHz) performance is not required. In a gain of +1, it
requires an 82 pF NPO or mica type compensation capacitor.
The AD8610 is another option where low bias current is needed
in low frequency applications.
Refer to Table 8 for some recommended op amps.
相關PDF資料 |
PDF描述 |
|---|---|
| SP3232EBCA-L/TR | IC TXRX RS232 ESD TRUE 16SSOP |
| VI-22T-MX-F3 | CONVERTER MOD DC/DC 6.5V 75W |
| AD9220ARZ | IC ADC 12BIT 10MSPS 28-SOIC |
| VI-22T-MX-F2 | CONVERTER MOD DC/DC 6.5V 75W |
| VE-21M-IU-F2 | CONVERTER MOD DC/DC 10V 200W |
相關代理商/技術參數 |
參數描述 |
|---|---|
| AD7655SCP-EP-RL | 制造商:Analog Devices 功能描述:ADC Single SAR 1Msps 16-bit Parallel/Serial 48-Pin LFCSP EP T/R 制造商:Analog Devices 功能描述:LOW COST 4-CHANNEL 1 MSPS 16-BIT ADC - Tape and Reel 制造商:Rochester Electronics LLC 功能描述: 制造商:Analog Devices 功能描述:IC ADC 16B PAR/SRL 1MSPS 48LFCSP 制造商:Analog Devices 功能描述:Analog to Digital Converters - ADC 4Ch 1MSPS 16-Bit Low Cost 制造商:Analog Devices 功能描述:CONVERTER - ADC |
| AD7656 | 制造商:AD 制造商全稱:Analog Devices 功能描述:250 kSPS, 6-Channel,Simultaneous Sampling, Bipolar 12/14/16-Bit ADC |
| AD7656-1 | 制造商:AD 制造商全稱:Analog Devices 功能描述:250 kSPS, 6-Channel, Simultaneous Sampling, Bipolar, 16-/14-/12-Bit ADC |
| AD7656A-1BSTZ | 功能描述:16 Bit Analog to Digital Converter 6 Input 6 SAR 64-LQFP (10x10) 制造商:analog devices inc. 系列:iCMOS? 包裝:托盤 零件狀態:有效 位數:16 采樣率（每秒）:250k 輸入數:6 輸入類型:單端 數據接口:SPI，并聯，DSP 配置:S/H-ADC 無線電 - S/H:ADC:1:1 A/D 轉換器數:6 架構:SAR 參考類型:外部， 內部 電壓 - 電源，模擬:5V 電壓 - 電源，數字:5V 特性:仿真采樣，真正的雙極性 工作溫度:-40°C ~ 85°C 封裝/外殼:64-LQFP 供應商器件封裝:64-LQFP（10x10） 標準包裝:1 |
| AD7656A-1BSTZ-RL | 功能描述:16 Bit Analog to Digital Converter 6 Input 6 SAR 64-LQFP (10x10) 制造商:analog devices inc. 系列:iCMOS? 包裝:帶卷（TR） 零件狀態:有效 位數:16 采樣率（每秒）:250k 輸入數:6 輸入類型:單端 數據接口:SPI，并聯，DSP 配置:S/H-ADC 無線電 - S/H:ADC:1:1 A/D 轉換器數:6 架構:SAR 參考類型:外部， 內部 電壓 - 電源，模擬:5V 電壓 - 電源，數字:5V 特性:仿真采樣，真正的雙極性 工作溫度:-40°C ~ 85°C 封裝/外殼:64-LQFP 供應商器件封裝:64-LQFP（10x10） 標準包裝:1,500 |
發布緊急采購，3分鐘左右您將得到回復。