參數資料
型號： 935230900112
廠商： NXP SEMICONDUCTORS
元件分類： 微控制器/微處理器
英文描述： 2 CHANNEL(S), 1M bps, LOCAL AREA NETWORK CONTROLLER, PDIP28
封裝： 0.600 INCH, PLASTIC, DIP-28
文件頁數： 32/68頁
文件大小： 234K
代理商： 935230900112
2000 Jan 04
38
Philips Semiconductors
Product specication
Stand-alone CAN controller
SJA1000
Table 22 Bit interpretation of the error warning limit register (EWLR); CAN address 13
6.4.11
RX ERROR COUNTER REGISTER (RXERR)
The RX error counter register reflects the current value of the receive error counter. After a hardware reset this register
is initialized to logic 0. In operating mode this register appears to the CPU as a read only memory. A write access to this
register is possible only in reset mode.
If a bus-off event occurs, the RX error counter is initialized to logic 0. The time bus-off is valid, writing to this register has
no effect.
Note, that a CPU-forced content change of the RX error counter is only possible, if the reset mode was entered
previously. An error status change (see status register; Table 14), an error warning or an error passive interrupt forced
by the new register content will not occur, until the reset mode is cancelled again.
Table 23 Bit interpretation of the RX error counter register (RXERR); CAN address 14
6.4.12
TX ERROR COUNTER REGISTER (TXERR)
The TX error counter register reflects the current value of the transmit error counter.
In operating mode this register appears to the CPU as a read only memory. A write access to this register is possible
only in reset mode. After a hardware reset this register is initialized to logic 0. If a bus-off event occurs, the TX error
counter is initialized to 127 to count the minimum protocol-defined time (128 occurrences of the bus-free signal). Reading
the TX error counter during this time gives information about the status of the bus-off recovery.
If bus-off is active, a write access to TXERR in the range from 0 to 254 clears the bus-off flag and the controller will wait
for one occurrence of 11 consecutive recessive bits (bus-free) after the reset mode has been cleared.
Table 24 Bit interpretation of the TX error counter register (TXERR); CAN address 15
Writing 255 to TXERR allows to initiate a CPU-driven bus-off event. It should be noted that a CPU-forced content change
of the TX error counter is only possible, if the reset mode was entered previously. An error or bus status change (see
status register; Table 14), an error warning or an error passive interrupt forced by the new register content will not occur
until the reset mode is cancelled again. After leaving the reset mode, the new TX counter content is interpreted and the
bus-off event is performed in the same way, as if it was forced by a bus error event. That means, that the reset mode is
entered again, the TX error counter is initialized to 127, the RX counter is cleared and all concerned status and interrupt
register bits are set.
Clearing of reset mode now will perform the protocol-defined bus-off recovery sequence (waiting for 128 occurrences of
the bus-free signal).
If the reset mode is entered again before the end of bus-off recovery (TXERR > 0), bus-off keeps active and TXERR is
frozen.
BIT 7
BIT 6
BIT 5
BIT 4
BIT 3
BIT 2
BIT 1
BIT 0
EWL.7
EWL.6
EWL.5
EWL.4
EWL.3
EWL.2
EWL.1
EWL.0
BIT 7
BIT 6
BIT 5
BIT 4
BIT 3
BIT 2
BIT 1
BIT 0
RXERR.7
RXERR.6
RXERR.5
RXERR.4
RXERR.3
RXERR.2
RXERR.1
RXERR.0
BIT 7
BIT 6
BIT 5
BIT 4
BIT 3
BIT 2
BIT 1
BIT 0
TXERR.7
TXERR.6
TXERR.5
TXERR.4
TXERR.3
TXERR.2
TXERR.1
TXERR.0
相關PDF資料
PDF描述
06NU06NU INNENGEWINDE BSP DREHB G 0.38
08NU06NU INNENGEWINDE BSP DREHB G G 0.38X0.5ZOLL
08NU08NU INNENGEWINDE BSP DREHB G 0.5
08NU10NU INNENGEWINDE BSP DREHB G 0.5X0.63ZOLL
08NU12NU INNENGEWINDE BSP DREHB G0.5X0.75ZOLL
相關代理商/技術參數
參數描述
9352370001 功能描述:HEAT SHRINK SLEEVE RoHS:是 類別:線纜，導線 - 管理 >> 標簽，標記 系列:HT-SCE 標準包裝:250 系列:CM-SCE 標簽類型:標準 標簽尺寸:2.00" x 0.25"（50.8mm x 6.4mm） 顏色:白 材質:聚烯烴 適用于相關產品:點陣打印機 包裝:* 工作溫度:-55°C ~ 135°C 其它名稱:A105291CM-SCE-TP-1/4-4H-9
935241-0001 制造商: 功能描述: 制造商:DIGITRAN 功能描述: 制造商:undefined 功能描述:
935241-1 制造商:DIGITRAN 功能描述: 制造商:DTRAN 功能描述:
935245650125 制造商:NXP Semiconductors 功能描述:Inverter 1-Element CMOS 5-Pin TSSOP T/R
935248-90 制造商:JANCO 功能描述:935248-90
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*