![](http://datasheet.mmic.net.cn/Exar-Corporation/XRT83VSH38IB_datasheet_107269/XRT83VSH38IB_54.png)
XRT83VSH38
51
8-CHANNEL T1/E1/J1 SHORT-HAUL LINE INTERFACE UNIT
REV. 1.1.0
TABLE 21: MICROPROCESSOR REGISTER 0X00H BIT DESCRIPTION
CHANNEL 0-7 (0X00H-0X70H)
BIT
NAME
FUNCTION
Register
Type
Default
Value
(HW reset)
D7
QRSS/
PRBS
QRSS/PRBS Select Bits
These bits are used to select between QRSS and PRBS.
1 = QRSS
0 = PRBS
R/W
0
D6
PRBS_Rx/
Tx
PRBS Receive/Transmit Select:
This bit is used to select where the output of the PRBS Generator
is directed if PRBS generation is enabled.
0 = Normal Operation - PRBS generator is output on TTIP and
TRING if PRBS generation is enabled.
1 = PRBS Generator is output on RPOS; RNEG is internally
grounded, if PRBS generation is enabled.
NOTE: If PRBS generation is disabled, user should set this bit to ’0’
for normal operation.
R/W
0
D5
RxON
Receiver ON/OFF
Upon power up, the receiver is powered OFF. RxON is used to
turn the receiver ON or OFF if the hardware pin RxON is pulled
"High". If the hardware pin is pulled "Low", all receivers are turned
off.
0 = Receiver is Powered Off
1 = Receiver is Powered On
R/W
0
D4
D3
D2
D1
D0
EQC4
EQC3
EQC2
EQC1
EQC0
Cable Length Setting
The equalizer control bits are shown in
R/W
0
PBRS
Generator
Tx
TTIP
TRING
+
-
Bit 6 = "0"
PBRS
Generator
Rx
RPOS
RNEG
+
-
Bit 6 = "1"