- 您現在的位置：買賣IC網 > PDF目錄385869 > ST62E18C (意法半導體) 16-Bit Registered Transceivers With 3-State Outputs 56-SSOP -40 to 85 PDF資料下載
參數資料
| 型號： | ST62E18C |
| 廠商： | 意法半導體 |
| 英文描述： | 16-Bit Registered Transceivers With 3-State Outputs 56-SSOP -40 to 85 |
| 中文描述： | 8位單片機與微控制器/ D轉換器，自動重加載定時器，UART的秘書長辦公室，安全復位和20管腳封裝 |
| 文件頁數： | 13/82頁 |
| 文件大小： | 536K |
| 代理商： | ST62E18C |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁當前第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁
13/82
13
ST62T18C/E18C
1.4 PROGRAMMING MODES
1.4.1 Option Bytes
The two Option Bytes allow configuration capabili-
ty to the MCUs. Option byte’s content is automati-
cally read, and the selected options enabled,when
the chip reset is activated.
It can only be accessed during the programming
mode. This access is made either automatically
(copy from a master device) or by selecting the
OPTION BYTEPROGRAMMING modeof the pro-
grammer.
The option bytes are located in a non-user map.
No address has to be specified.
EPROM Code Option Byte (LSB)
EPROM Code Option Byte (MSB)
D15-D13.
Reserved. Must be cleared.
ADC SYNCHRO.
When set, an A/D conversion is
started upon WAIT instruction execution, in order
to reduce supply noise. When this bit is low, an A/
D conversion is started as soon as the STA bit of
the A/D Converter Control Register is set.
D11.
UART Frame.When set, UART transmission
and reception are based on a 11-bit frame. When
cleared, a 10-bit frame is used.
D10.
Reserved. This bit must be cleared
EXTCNTL.
External STOP MODE control
.
. When
EXTCNTL is high, STOP mode is available with
watchdog active by setting NMI pin to one. When
EXTCNTL is low, STOP mode is not available with
the watchdog active.
LVD.
LVDRESET enable.When this bit is set, safe
RESET is performed by MCU when the supply
voltage is too low. When this bit is cleared, only
power-on reset or external RESET are active.
PROTECT
. Readout Protection.This bit allowsthe
protection of the software contents against piracy.
When the bit PROTECT is set high, readout of the
OTP contents is prevented by hardware.. When
this bit is low, the user program can be read.
OSCIL
. Oscillator selection When this bit is low,
the oscillator must be controlled by a quartz crys-
tal, a ceramic resonator or an external frequency.
When itis high, the oscillator must be controlled by
an RC network, with only the resistor having to be
externally provided.
D5.
Port Pull. This bit must be set high to have
pull-up input state at reset on the I/O port. When
this bit is low, I/O ports are in input without pull-up
(high impedance state at reset).
D4.
Reserved. Must be set to 1.
NMI PULL.
NMI Pull-Up This bit must be set high
to configure the NMI pin with a pull-up resistor.
When it is low, no pull-up is provided
.
TIM PULL.
TIM Pull-Up This bit must be set high
to configure the TIMER pin with a pull-up resistor.
When it is low, no pull-up is provided
.
WDACT
. Thisbit controls the watchdog activation.
When it is high, hardware activation is selected.
The software activation is selected when WDACT
is low.
OSGEN
. Oscillator Safe Guard This bit must be
set high to enable the Oscillator Safe Guard.
When this bit is low, the OSG is disabled.
The Option byte is written during programming ei-
ther by using the PC menu (PC driven Mode) or
automatically (stand-alone mode).
7
0
PRO-
TECT
OSCIL
PORT
PULL
-
NMI
PULL
TIM
PULL
WDACT
OS-
GEN
15
8
-
-
-
ADC
SYNCHRO
UART
FRAME
-
EXTC-
NTL
LVD
相關PDF資料 |
PDF描述 |
|---|---|
| ST62T18C | 8-BIT MCUs WITH A/D CONVERTER, AUTO-RELOAD TIMER, UART, OSG, SAFE RESET AND 20-PIN PACKAGE |
| ST62E40B | The CAT24FC02 is a 2-kb Serial CMOS EEPROM internally organized as 256 words of 8 bits each |
| ST62T40B | The CAT24FC02 is a 2-kb Serial CMOS EEPROM internally organized as 256 words of 8 bits each |
| ST62T10 | 8-BIT OTP/EPROM MCUs WITH A/D CONVERTER |
| ST62T28C | 8-BIT MCUs WITH A/D CONVERTER, AUTO-RELOAD TIMER, UART, OSG, SAFE RESET AND 28-PIN PACKAGE |
相關代理商/技術參數 |
參數描述 |
|---|---|
| ST62E18CF1 | 功能描述:8位微控制器 -MCU UV EPROM 8K UART RoHS:否 制造商:Silicon Labs 核心:8051 處理器系列:C8051F39x 數據總線寬度:8 bit 最大時鐘頻率:50 MHz 程序存儲器大小:16 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:1.8 V to 3.6 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:QFN-20 安裝風格:SMD/SMT |
| ST62E18CG1 | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Microcontroller |
| ST62E20 | 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:GANG PROGRAMMERS FOR ST62 MCU FAMILY |
| ST62E20BB1/EPROM | 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:8-BIT MCUs WITH A/D CONVERTER, TWO TIMERS, OSCILLATOR SAFEGUARD & SAFE RESET |
| ST62E20BB3/EPROM | 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:8-BIT MCUs WITH A/D CONVERTER, TWO TIMERS, OSCILLATOR SAFEGUARD & SAFE RESET |
發布緊急采購，3分鐘左右您將得到回復。