- 您現在的位置：買賣IC網 > PDF目錄299927 > SST49LF008C-33-4C-NHE 1M X 8 FLASH 3V PROM, 11 ns, PQCC32 PDF資料下載
參數資料
| 型號： | SST49LF008C-33-4C-NHE |
| 元件分類： | PROM |
| 英文描述： | 1M X 8 FLASH 3V PROM, 11 ns, PQCC32 |
| 封裝： | ROHS COMPLIANT, PLASTIC, MS-016AE, LCC-32 |
| 文件頁數： | 14/36頁 |
| 文件大?。?/td> | 509K |
| 代理商： | SST49LF008C-33-4C-NHE |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁當前第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁
Advance Information
4 Mbit / 8 Mbit LPC Serial Flash
SST49LF004C / SST49LF008C
21
200 Silicon Storage Technology, Inc.
S71292-00-000
1/06
REGISTERS
There are five types of registers available on the
SST49LF00xC, the multi-byte Read/Write configuration
registers, General Purpose Inputs registers, Block Locking
registers, Security ID register, and the JEDEC ID registers.
These registers appear at their respective address location
in the 4 GByte system memory map. Unused register loca-
tions will read as 00H. Any attempt to read or write any reg-
ister during an internal Write operation will be ignored.
Read or write access to the register during an internal Pro-
gram/Erase operation will be completed as follows:
Multi-byte Read/Write Configuration registers,
General Purpose Inputs register, and Block Lock-
ing registers can be accessed normally
Security ID register and the JEDEC ID registers
can not be accessed (reading these registers will
return unused register data 00H).
Multi-Byte Read/Write Configuration Reg-
isters (Firmware Memory Cycle)
The multi-byte read/write configuration (MBR) registers are
four 8-bit read-only registers located at addresses
FFBC0005-FFBC0008 for boot configured device (see
Table 13). These registers are accessible using Firmware
Memory Read cycle only. These registers contain informa-
tion about multi-byte read and write access sizes that will
be accepted for Firmware Memory multi-byte Read com-
mands. The registers are not available in AAI mode.
In case of multi-byte Firmware Memory register reads, the
device will return register data for the addressed register
until the command finishes, or is aborted.
General Purpose Inputs Register
The General Purpose Inputs register (GPI_REG) passes
the state of GPI[4:0] pins on the SST49LF00xC. It is rec-
ommended that the GPI[4:0] pins be in the desired state
before LFRAME# is brought low for the beginning of the
bus cycle, and remain in that state until the end of the cycle.
There is no default value since this is a pass-through regis-
ter. The GPI_REG register for the boot device appears at
FFBC0100H in the 4 GByte system memory map, and will
appear elsewhere if the device is not the boot device (see
Table 12). This register is not available to be read when the
device is in an Erase/Program operation. In case of multi-
byte Firmware Memory cycle register reads, the device will
return register data for the addressed register until the com-
mand finishes, or is aborted.
TABLE 12: GENERAL PURPOSE REGISTER
Register
Register Address1
1. Address shown in this column is for boot device only.
Address locations should appear elsewhere in the 4
GByte system memory map depending on ID strapping
values on ID[3:0] pins according with multiple device
selection mechanism.
Default
Value
Access
GPI_REG
FFBC 0100H
N/A
R
T12.0 1292
TABLE 13: MULTI-BYTE READ/WRITE CONFIGURATION REGISTERS
Register
Register Address1
1. Address shown in this column is for boot device only. Address locations should appear elsewhere in the 4 GByte system memory
map depending on ID strapping values on ID[3:0] pins when multiple LPC memory devices are used in a system.
Data
Access
Description
MULTI_BYTE_READ_L
FFBC 0005H
0100 1011b
R
Device supports 1,2,4, 16, 128 Byte reads
MULTI_BYTE_READ_H
FFBC 0006H
0000 0000b
R
Future Expansion for Read
MULTI_BYTE_WRITE_L
FFBC 0007H
0000 0011b
R
Device supports 1, 2, 4 Byte Write
MULTI_BYTE_WRITE_H
FFBC 0008H
0000 0000b
R
Future Expansion for Write
T13.0 1292
相關PDF資料 |
PDF描述 |
|---|---|
| SSU-131MAT | SLIDE SWITCH, SP3T, LATCHED, 0.3A, 4VDC, SURFACE MOUNT-RIGHT ANGLE |
| SSU-121ART | SLIDE SWITCH, SPDT, LATCHED, 0.3A, 4VDC, SURFACE MOUNT-RIGHT ANGLE |
| SSW-102-22-F-D-VS | 4 CONTACT(S), FEMALE, STRAIGHT TWO PART BOARD CONNECTOR, SURFACE MOUNT, SOCKET |
| SSW-102-22-F-S-VS | 2 CONTACT(S), FEMALE, STRAIGHT TWO PART BOARD CONNECTOR, SURFACE MOUNT, SOCKET |
| SSW-102-22-G-D-VS | 4 CONTACT(S), FEMALE, STRAIGHT TWO PART BOARD CONNECTOR, SURFACE MOUNT, SOCKET |
相關代理商/技術參數 |
參數描述 |
|---|---|
| SST49LF008C-33-4C-WHE | 制造商:SST 制造商全稱:Silicon Storage Technology, Inc 功能描述:4 Mbit / 8 Mbit LPC Serial Flash |
| SST49LF016C | 制造商:SST 制造商全稱:Silicon Storage Technology, Inc 功能描述:16 Mbit LPC Serial Flash |
| SST49LF016C-33-4C-EIE | 功能描述:閃存 16M (2Mx8) 33MHz 3.0-3.6V Commercial RoHS:否 制造商:ON Semiconductor 數據總線寬度:1 bit 存儲類型:Flash 存儲容量:2 MB 結構:256 K x 8 定時類型: 接口類型:SPI 訪問時間: 電源電壓-最大:3.6 V 電源電壓-最小:2.3 V 最大工作電流:15 mA 工作溫度:- 40 C to + 85 C 安裝風格:SMD/SMT 封裝 / 箱體: 封裝:Reel |
| SST49LF016C-33-4C-EIE-T | 功能描述:閃存 3.0 to 3.6V 16Mbit LPC Firmware 閃存 RoHS:否 制造商:ON Semiconductor 數據總線寬度:1 bit 存儲類型:Flash 存儲容量:2 MB 結構:256 K x 8 定時類型: 接口類型:SPI 訪問時間: 電源電壓-最大:3.6 V 電源電壓-最小:2.3 V 最大工作電流:15 mA 工作溫度:- 40 C to + 85 C 安裝風格:SMD/SMT 封裝 / 箱體: 封裝:Reel |
| SST49LF016C-33-4C-NHE | 功能描述:閃存 16M (2Mx8) 33MHz 3.0-3.6V Commercial RoHS:否 制造商:ON Semiconductor 數據總線寬度:1 bit 存儲類型:Flash 存儲容量:2 MB 結構:256 K x 8 定時類型: 接口類型:SPI 訪問時間: 電源電壓-最大:3.6 V 電源電壓-最小:2.3 V 最大工作電流:15 mA 工作溫度:- 40 C to + 85 C 安裝風格:SMD/SMT 封裝 / 箱體: 封裝:Reel |
發布緊急采購，3分鐘左右您將得到回復。