- 您現在的位置：買賣IC網 > PDF目錄98068 > S1C6P466D0A0A00 MICROCONTROLLER, UUC140 PDF資料下載
參數資料
| 型號： | S1C6P466D0A0A00 |
| 元件分類： | 微控制器/微處理器 |
| 英文描述： | MICROCONTROLLER, UUC140 |
| 封裝： | DIE-140 |
| 文件頁數： | 9/174頁 |
| 文件大小： | 1582K |
| 代理商： | S1C6P466D0A0A00 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁當前第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁第115頁第116頁第117頁第118頁第119頁第120頁第121頁第122頁第123頁第124頁第125頁第126頁第127頁第128頁第129頁第130頁第131頁第132頁第133頁第134頁第135頁第136頁第137頁第138頁第139頁第140頁第141頁第142頁第143頁第144頁第145頁第146頁第147頁第148頁第149頁第150頁第151頁第152頁第153頁第154頁第155頁第156頁第157頁第158頁第159頁第160頁第161頁第162頁第163頁第164頁第165頁第166頁第167頁第168頁第169頁第170頁第171頁第172頁第173頁第174頁
96
EPSON
S1C6P466 TECHNICAL MANUAL
CHAPTER 5: PROM PROGRAMMING AND OPERATING MODE
CHAPTER
5 PROM PROGRAMMING AND
OPERATING MODE
The S1C6P466 has built-in Flash EEPROMs as the code PROM and the data PROM that allow the
developer to program the PROM data using the exclusive PROM writer (Universal ROM Writer II
(S5U1C88000W1)). This chapter explains the PROM programmer that controls data writing and the
writing mode.
5.1 Configuration of PROM Programmer
The configuration of the PROM programmer is shown in Figure 5.1.1.
Serial interface
controller
Code
PROM
Programming
control circuit
Parallel interface
controller
VDDF
VSS
RXD
TXD
SCLK
CLKIN
Address
Data
Control signal
SPRG
Data
PROM
PROM programmer
PROM block
From/to
exclusive
PROM writer
Fig. 5.1.1 Configuration of PROM programmer
The PROM programmer supports the following two writing modes.
1) Serial Programming
2) Parallel Programming
Serial programming mode uses the serial communication ports of the PROM writer and S1C6P466 to
write data. This mode enables on-board programming by designing the target board with a serial writing
function. In parallel programming mode, the on-chip PROM can be directly programmed using the
exclusive PROM writer with the adaptor socket installed. Refer to Section 5.2, "Operating Mode", for each
programming method.
Terminals
The S1C6P466 provides the following terminals for programming the Flash EEPROM.
VDDF
Power supply (+) terminal for Flash EEPROM (The VDDF terminal should be connected to VDD.)
SPRG
Flash programming control terminal (pull-up resistor built-in)
When set to High ..... Normal operation mode (The CPU executes the program in the Flash
EEPROM.)
When set to Low ...... Programming mode (for writing data to the Flash EEPROM)
SCLK
Serial transfer clock input/output terminal for Serial Programming (pull-up resistor built-in)
RXD
Serial data input terminal for Serial Programming (pull-up resistor built-in)
TXD
Serial data output terminal for Serial Programming
CLKIN PROM programmer clock input terminal (1 MHz; pull-up resistor built-in)
RSTOUTTest signal monitor terminal (Not used when writing; keep it open)
VEPEXT Test signal monitor terminal (Not used when writing; keep it open)
The eight terminals above are provided exclusively for the Flash EEPROM. The S1C63454, S1C63458
and S1C63466 do not have these terminals.
相關PDF資料 |
PDF描述 |
|---|---|
| S1C6S2L7D | 4-BIT, MROM, 0.032 MHz, MICROCONTROLLER, UUC58 |
| S1C6S2A7F | 4-BIT, MROM, 0.08 MHz, MICROCONTROLLER, PQFP60 |
| S1C6S2B7F | 4-BIT, MROM, 0.08 MHz, MICROCONTROLLER, PQFP60 |
| S1C6S2N7D | 4-BIT, MROM, 0.08 MHz, MICROCONTROLLER, UUC58 |
| S1C6S2N7F0A0100 | MICROCONTROLLER, PQFP60 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| S1C-6-S | 制造商:GRIPCO 功能描述: |
| S1C7309X | 制造商:SAMSUNG 制造商全稱:Samsung semiconductor 功能描述:B/W CCD PROCESSOR |
| S1C7309X01 | 制造商:SAMSUNG 制造商全稱:Samsung semiconductor 功能描述:B/W CCD PROCESSOR |
| S1C88349 | 制造商:EPSON 制造商全稱:EPSON 功能描述:8-bit Single Chip Microcomputer |
| S1C88649 | 制造商:EPSON 制造商全稱:EPSON 功能描述:8-bit Single Chip Microcomputer |
發布緊急采購，3分鐘左右您將得到回復。