參數資料
型號： MC705L16CFUE
廠商： Freescale Semiconductor
文件頁數： 124/146頁
文件大?。?/td> 0K
描述： IC MCU 8BIT EPROM 80-QFP
標準包裝： 84
系列： HC05
核心處理器： HC05
芯體尺寸： 8-位
速度： 2.1MHz
連通性： SPI
外圍設備： LCD，POR，WDT
輸入/輸出數： 16
程序存儲器容量： 16KB（16K x 8）
程序存儲器類型： OTP
RAM 容量： 512 x 8
電壓 - 電源 (Vcc/Vdd)： 3 V ~ 5.5 V
振蕩器型： 內部
工作溫度： -40°C ~ 85°C
封裝/外殼： 80-QFP
包裝： 托盤
Timer 1
MC68HC05L16 MC68HC705L16 Data Sheet, Rev. 4.1
Freescale Semiconductor
79
9.2.1 Counter
The key element in the programmable timer is a 16-bit, free-running counter or counter register preceded
by a prescaler that divides the internal processor clock by four. The prescaler gives the timer a resolution
of 2.0 microseconds if the internal bus clock is 2.0 MHz. The counter is incremented during the low portion
of the internal bus clock. Software can read the counter at any time without affecting its value.
The double-byte, free-running counter can be read from either of two locations: $18–$19 (counter
register) or $1A–$1B (counter alternate register). A read from only the least significant byte (LSB) of the
free-running counter ($19, $1B) receives the count value at the time of the read. If a read of the
free-running counter or counter alternate register first addresses the most significant byte (MSB) ($18,
$1A), the LSB ($19, $1B) is transferred to a buffer. This buffer value remains fixed after the first MSB read,
even if the user reads the MSB several times. This buffer is accessed when reading the free-running
counter or counter alternate register LSB ($19 or $1B) and, thus, completes a read sequence of the total
counter value. In reading either the free-running counter or counter alternate register, if the MSB is read,
the LSB must also be read to complete the sequence.
The counter alternate register differs from the counter register in one respect: A read of the counter
register MSB can clear the timer overflow flag (TOF). Therefore, the counter alternate register can be read
at any time without the possibility of missing timer overflow interrupts due to clearing of the TOF.
The free-running counter is configured to $FFFC during reset and is always a read-only register. During
a power-on reset, the counter is also preset to $FFFC and begins running after the oscillator startup delay.
Because the free-running counter is 16 bits preceded by a fixed divided-by-4 prescaler, the value in the
free-running counter repeats every 262,144 internal bus clock cycles. When the counter rolls over from
$FFFF to $0000, the TOF bit is set. An interrupt also can be enabled when counter roll over occurs by
setting its interrupt enable bit (TOIE).
9.2.2 Output Compare Register
The 16-bit output compare register is made up of two 8-bit registers at locations $16 (MSB) and $17
(LSB). The output compare register is used for several purposes, such as indicating when a period of time
has elapsed. All bits are readable and writable and are not altered by the timer hardware or reset. If the
compare function is not needed, the two bytes of the output compare register can be used as storage
locations.
The output compare register contents are compared with the contents of the free-running counter
continually, and if a match is found, the corresponding output compare flag (OCF) bit is set. The output
compare register values should be changed after each successful comparison to establish a new elapsed
timeout. An interrupt also can accompany a successful output compare, provided the corresponding
interrupt enable bit (OCIE) is set.
After a processor write cycle to the output compare register containing the MSB ($16), the output compare
function is inhibited until the LSB ($17) also is written. The user must write both bytes (locations) if the
MSB is written first. A write made only to the LSB ($17) will not inhibit the compare function. The
free-running counter is updated every four internal bus clock cycles. The minimum time required to update
the output compare register is a function of the program rather than the internal hardware.
The processor can write to either byte of the output compare register without affecting the other byte.
相關PDF資料
PDF描述
MC705X32VFUE IC MCU 8BIT 32K FLASH 64-QFP
MC711P2CFNE3 IC MCU 8BIT 84-PLCC
MC7410VU450NE IC MPU RISC 32BIT 360-FCCBGA
MC7447AVU1333LB IC MPU RISC 32BIT 360-BGA
MC7448VS600ND IC MPU RISC 600MHZ 360-FCCLGA
相關代理商/技術參數
參數描述
MC705P6ACDWE 功能描述:8位微控制器 -MCU MCU 176 BYTES RAM A/D RoHS:否 制造商:Silicon Labs 核心:8051 處理器系列:C8051F39x 數據總線寬度:8 bit 最大時鐘頻率:50 MHz 程序存儲器大小:16 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:1.8 V to 3.6 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:QFN-20 安裝風格:SMD/SMT
MC705P6ACDWE 制造商:Freescale Semiconductor 功能描述:8-Bit Microcontroller IC
MC705P6ACDWER 功能描述:IC MCU 8BIT EPROM 28-SOIC RoHS:是 類別:集成電路 (IC) >> 嵌入式 - 微控制器， 系列:HC05 標準包裝:1 系列:AVR® ATmega 核心處理器:AVR 芯體尺寸:8-位 速度:16MHz 連通性:I²C，SPI，UART/USART 外圍設備:欠壓檢測/復位，POR，PWM，WDT 輸入/輸出數:32 程序存儲器容量:32KB（16K x 16） 程序存儲器類型:閃存 EEPROM 大小:1K x 8 RAM 容量:2K x 8 電壓 - 電源 (Vcc/Vdd):2.7 V ~ 5.5 V 數據轉換器:A/D 8x10b 振蕩器型:內部 工作溫度:-40°C ~ 125°C 封裝/外殼:44-TQFP 包裝:剪切帶 (CT) 其它名稱:ATMEGA324P-B15AZCT
MC705P6ACPE 功能描述:8位微控制器 -MCU HC705P6A 176 BYTES RAM RoHS:否 制造商:Silicon Labs 核心:8051 處理器系列:C8051F39x 數據總線寬度:8 bit 最大時鐘頻率:50 MHz 程序存儲器大小:16 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:1.8 V to 3.6 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:QFN-20 安裝風格:SMD/SMT
MC705P6AMDWE 功能描述:8位微控制器 -MCU MCU 176 BYTES RAM EPP RoHS:否 制造商:Silicon Labs 核心:8051 處理器系列:C8051F39x 數據總線寬度:8 bit 最大時鐘頻率:50 MHz 程序存儲器大小:16 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:1.8 V to 3.6 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:QFN-20 安裝風格:SMD/SMT
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*