參數資料
型號: MC705L16CFUE
廠商: Freescale Semiconductor
文件頁數: 116/146頁
文件大?。?/td> 0K
描述: IC MCU 8BIT EPROM 80-QFP
標準包裝: 84
系列: HC05
核心處理器: HC05
芯體尺寸: 8-位
速度: 2.1MHz
連通性: SPI
外圍設備: LCD,POR,WDT
輸入/輸出數: 16
程序存儲器容量: 16KB(16K x 8)
程序存儲器類型: OTP
RAM 容量: 512 x 8
電壓 - 電源 (Vcc/Vdd): 3 V ~ 5.5 V
振蕩器型: 內部
工作溫度: -40°C ~ 85°C
封裝/外殼: 80-QFP
包裝: 托盤
Signal Descriptions
MC68HC05L16 MC68HC705L16 Data Sheet, Rev. 4.1
Freescale Semiconductor
71
8.4.1 Control
This block is an interface to the HC05 internal bus and generates a start signal when a write to the SPDR
is detected in master mode. It also generates an interrupt request to the CPU.
8.4.2 SPDR
This serial peripheral data register (SPDR) is an 8-bit shift register. The DORD bit in the SPCR determines
the bus connection between the internal data bus and SPDR. This register can be read and written by the
CPU.
8.4.3 SPCR
Bits in the serial peripheral control register (SPCR) control SSPI functions.
8.4.4 SPSR
The serial peripheral status register (SPSR) mainly sets flags such as SPIF and DCOL.
8.4.5 CLKGEN
In master mode, this block generates SCK when the CPU writes to the data register (SPDR) and the clock
rate is selected by the SPR bit in the control register.
In slave mode, the external clock from the SCK pin is used instead of the master mode clock, and SPR
has no affect.
This clock generator includes a 3-bit clock counter. Overflow of this counter sets SPIF.
8.5 Signal Descriptions
Three basic signals — SDI, SDO, and SCK — are described in the following subsections. The relationship
among SCK, SDI, and SDO is shown in Figure 8-3.
8.5.1 SSPI Data I/O (SDI and SDO)
The two serial data lines — SDI for input and SDO for output — are connected to PC0 and PC1,
respectively, when SSPI is enabled (SPE = 1).
At the falling edge of SCK, a serial data bit is transmitted out of the SDO pin. At the rising edge of SCK,
a serial data bit on the SDI pin is sampled internally.
When data is transmitted to other devices via the SDO line, the receiving data is shifted into the shift
register through the SDI pin. This implies full- duplex transmission with both data-out and data-in
synchronized with the same clock signal. Thus, the byte transmitted is replaced by the byte received and
eliminates the need for separate transmit-empty and receiver-full status bits. A single status bit, SPIF, is
used to signify the completion of data transfer.
相關PDF資料
PDF描述
MC705X32VFUE IC MCU 8BIT 32K FLASH 64-QFP
MC711P2CFNE3 IC MCU 8BIT 84-PLCC
MC7410VU450NE IC MPU RISC 32BIT 360-FCCBGA
MC7447AVU1333LB IC MPU RISC 32BIT 360-BGA
MC7448VS600ND IC MPU RISC 600MHZ 360-FCCLGA
相關代理商/技術參數
參數描述
MC705P6ACDWE 功能描述:8位微控制器 -MCU MCU 176 BYTES RAM A/D RoHS:否 制造商:Silicon Labs 核心:8051 處理器系列:C8051F39x 數據總線寬度:8 bit 最大時鐘頻率:50 MHz 程序存儲器大小:16 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:1.8 V to 3.6 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:QFN-20 安裝風格:SMD/SMT
MC705P6ACDWE 制造商:Freescale Semiconductor 功能描述:8-Bit Microcontroller IC
MC705P6ACDWER 功能描述:IC MCU 8BIT EPROM 28-SOIC RoHS:是 類別:集成電路 (IC) >> 嵌入式 - 微控制器, 系列:HC05 標準包裝:1 系列:AVR® ATmega 核心處理器:AVR 芯體尺寸:8-位 速度:16MHz 連通性:I²C,SPI,UART/USART 外圍設備:欠壓檢測/復位,POR,PWM,WDT 輸入/輸出數:32 程序存儲器容量:32KB(16K x 16) 程序存儲器類型:閃存 EEPROM 大小:1K x 8 RAM 容量:2K x 8 電壓 - 電源 (Vcc/Vdd):2.7 V ~ 5.5 V 數據轉換器:A/D 8x10b 振蕩器型:內部 工作溫度:-40°C ~ 125°C 封裝/外殼:44-TQFP 包裝:剪切帶 (CT) 其它名稱:ATMEGA324P-B15AZCT
MC705P6ACPE 功能描述:8位微控制器 -MCU HC705P6A 176 BYTES RAM RoHS:否 制造商:Silicon Labs 核心:8051 處理器系列:C8051F39x 數據總線寬度:8 bit 最大時鐘頻率:50 MHz 程序存儲器大小:16 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:1.8 V to 3.6 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:QFN-20 安裝風格:SMD/SMT
MC705P6AMDWE 功能描述:8位微控制器 -MCU MCU 176 BYTES RAM EPP RoHS:否 制造商:Silicon Labs 核心:8051 處理器系列:C8051F39x 數據總線寬度:8 bit 最大時鐘頻率:50 MHz 程序存儲器大小:16 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:1.8 V to 3.6 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:QFN-20 安裝風格:SMD/SMT