參數資料
型號: ISP1181DGG
廠商: NXP SEMICONDUCTORS
元件分類: 總線控制器
英文描述: INDUCTOR 4.7NH +-.3NH 0402 SMD
中文描述: UNIVERSAL SERIAL BUS CONTROLLER, PDSO48
封裝: 6.10 MM, PLASTIC, TSSOP-48
文件頁數: 9/69頁
文件大?。?/td> 1655K
代理商: ISP1181DGG
Philips Semiconductors
ISP1181
Full-speed USB interface
Objective specification
Rev. 01 — 13 March 2000
9 of 69
9397 750 06896
Philips Electronics N.V. 2000. All rights reserved.
7.7 Voltage regulator
A 5 V to 3.3 V voltage regulator is integrated on-chip to supply the analog transceiver
and internal logic. This voltage is available at pin V
reg(3.3)
to supply an external 1.5 k
pull-up resistor on the D
+
line. Alternatively, the ISP1181 provides SoftConnect
technology via an integrated 1.5 k
pull-up resistor (see
Section 7.4
).
7.8 PLL clock multiplier
A 6 MHz to 48 MHz clock multiplier Phase-Locked Loop (PLL) is integrated on-chip.
This allows for the use of a low-cost 6 MHz crystal, which also minimizes EMI. No
external components are required for the operation of the PLL.
7.9 Parallel I/O (PIO) and Direct Memory Access (DMA) interface
A generic PIO interface is defined for speed and ease-of-use. It also allows direct
interfacing to most microcontrollers. To a microcontroller, the ISP1181 appears as a
memory device with an 8/16-bit data bus and an 1-bit address bus. The ISP1181
supports both multiplexed and non-multiplexed address and data buses.
The ISP1181 can also be configured as a DMA slave device to allow more efficient
data transfer. One of the 14 endpoint FIFOs may directly transfer data to/from the
local shared memory. The DMA interface can be configured independently from the
PIO interface.
8.
Modes of operation
The ISP1181 has four bus configuration modes, selected via pins BUS_CONF1 and
BUSCONF0:
Mode 0
Mode 1
Mode 2
Mode 3
16-bit I/O port shared with 8-bit or 16-bit DMA port
separate 8-bit I/O port and 8-bit DMA port
8-bit I/O port shared with 8-bit or 16-bit DMA port
reserved.
The bus configurations for each of these modes are given in
Table 3
. Typical interface
circuits for each mode are given in
Section 20.1
.
Table 3:
Mode
Bus configuration modes
BUS_CONF[1:0]
PIO width
DMA width
Description
DMAWD = 0
D[7:0];
DMAWD = 1
D[15:0]
0
0
0
D[15:0]
multiplexed address/data on pin AD0;
bus is shared by 16-bit I/O port and 8-bit
or 16-bit DMA port
multiplexed address/data on pin AD0;
bus has separate I/O port (8-bit) and
DMA port (8-bit)
multiplexed address/data on pin AD0;
bus is shared by 8-bit I/O port and 8-bit
or 16-bit DMA port
reserved
1
0
1
D[7:0]
D[15:8]
illegal
2
1
0
D[7:0]
D[7:0]
D[15:0]
3
1
1
reserved
reserved
reserved
相關PDF資料
PDF描述
ISP1183 Low-power Universal Serial Bus interface device with DMA
ISP1183BS Low-power Universal Serial Bus interface device with DMA
ISP1301 Universal Serial Bus On-The-Go transceiver
ISP1301BS Universal Serial Bus On-The-Go transceiver
ISP1362 Single-chip Universal Serial Bus On-The-Go controller
相關代理商/技術參數
參數描述
ISP1183 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:Low-power Universal Serial Bus interface device with DMA
ISP1183BS 功能描述:IC USB HOST CTRL LOW-SPD 32HVQFN RoHS:是 類別:集成電路 (IC) >> 接口 - 專用 系列:- 標準包裝:3,000 系列:- 應用:PDA,便攜式音頻/視頻,智能電話 接口:I²C,2 線串口 電源電壓:1.65 V ~ 3.6 V 封裝/外殼:24-WQFN 裸露焊盤 供應商設備封裝:24-QFN 裸露焊盤(4x4) 包裝:帶卷 (TR) 安裝類型:表面貼裝 產品目錄頁面:1015 (CN2011-ZH PDF) 其它名稱:296-25223-2
ISP1183BS,118 功能描述:USB 接口集成電路 FULL-SPD USB2 DEVICE RoHS:否 制造商:Cypress Semiconductor 產品:USB 2.0 數據速率: 接口類型:SPI 工作電源電壓:3.15 V to 3.45 V 工作電源電流: 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:WLCSP-20
ISP1183BS,151 功能描述:USB 接口集成電路 FULL-SPD USB2 DEVICE RoHS:否 制造商:Cypress Semiconductor 產品:USB 2.0 數據速率: 接口類型:SPI 工作電源電壓:3.15 V to 3.45 V 工作電源電流: 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:WLCSP-20
ISP1183BS,157 功能描述:USB 接口集成電路 DO NOT USE ORDER -S OR -T PART RoHS:否 制造商:Cypress Semiconductor 產品:USB 2.0 數據速率: 接口類型:SPI 工作電源電壓:3.15 V to 3.45 V 工作電源電流: 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:WLCSP-20