- 您現在的位置：買賣IC網 > PDF目錄1909 > CS5376A-IQZ (Cirrus Logic Inc)IC FILTER DGTL MULTI-CH 64-TQFP PDF資料下載
參數資料
| 型號： | CS5376A-IQZ |
| 廠商： | Cirrus Logic Inc |
| 文件頁數： | 47/49頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC FILTER DGTL MULTI-CH 64-TQFP |
| 標準包裝： | 160 |
| 濾波器類型： | 數字 |
| 濾波器數： | 4 |
| 濾波器階數： | 2nd |
| 電源電壓： | 3 V ~ 5 V |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 64-LQFP |
| 供應商設備封裝： | 64-TQFP（10x10） |
| 包裝： | 管件 |
| 配用： | 598-1778-ND - EVALUATION BOARD FOR CS5376 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁當前第47頁第48頁第49頁
2008 Fairchild Semiconductor Corporation
www.fairchildsemi.com
FUSB2805 Rev. 1.0.3
7
F
USB2
8
0
5
—
USB2
.0
High
-S
pee
d
OTG
Tra
nsc
e
iv
e
rw
ith
UL
P
I
Inter
fac
e
Detailed Description of Pins
D0 to D7
D0 to D7 are bi-directional ULPI data bus pins. The
USB link controller must drive D0-D7 LOW when the
ULPI bus is idle (DIR is LOW). When the link has data
to transmit to the FUSB2805, it drives a non-zero value.
The data bus can be re-configured to carry different
data types. There are four modes of the data bus:
Synchronous mode: default is SDR mode
(3), with
the 8-bit data bytes being synchronous to the rising
edge of CLOCK.
Low-power mode: carries asynchronous line state
and
VBUS information.
3-pin serial mode: carries asynchronous 3-pin
FS/LS serial signaling.
6-pin serial mode: carries asynchronous 6-pin
FS/LS serial signaling.
Data
pins
can
also
be
three-stated
by
driving
chip_select_N HIGH.
Note:
3.
DDR is not supported by the FUSB2805.
VIO
VIO is the input power pin that sets the I/O voltage level.
VIO powers the on-chip pads of the following pins:
CLOCK
DIR
STP
NXT
D0-D7
RESET_N
CFG1
RREF
Resistor reference analog I/O pin. A 12 k
1% resistor
is required.
DP and DM
When in USB mode, the DP pin functions as USB data
plus line; the DM pin functions as USB data minus line.
The DP and DM pins should be connected to the D+
and D- pins of the USB receptacle.
FAULT
This input pin is used by an external SMPS or power
management IC to signal an over-current or over-
voltage fault condition. This is applicable in OTG host
where PSW is used to control driving VBUS or signaling
for
higher
charging
currents
to
an
OTG
SMPS
management IC, as shown in Figure 5.
ID
For OTG implementation, the ID (identification) pin is
connected to the ID pin of the mini-USB (or micro-USB)
receptacle. As defined in the OTG specification, the ID
pin dictates the initial role of the link controller. If ID is
detected as HIGH, the link controller must assume the
role of peripheral. If ID is detected as LOW, the link
controller must assume the host role. Roles can be
swapped later using Host Negotiation Protocol (HNP).
The FUSB2805 provides an internal pull-up resistor to
sense the value of the ID pin. The pull-up resistor, with
a value of 50 k
, must first be enabled by setting the
ID_PULLUP register bit to 1b. If the value on ID has
changed, the FUSB2805 sends an RX CMD or interrupt
to the link controller by time tID. If the link controller
does not receive any RX CMD or interrupt by tID, then
the ID value has not changed.
To avoid a floating ID pin, a 400 k
resistor pull-up is
switched in when ID_PULLUP register bit is set to 0b.
5V
USB Trans
PSW
VBUS
Digital over-current protection scheme
with external power switch
VBUS
OTG Host
Supply
Source
Switch with
External
Over-
Current
Detector
FAULT
100k
Figure 5. Digital Over-Current Detection Scheme
相關PDF資料 |
PDF描述 |
|---|---|
| CS61577-IL1Z | IC LINE INTERFACE T1/E1 28PLCC |
| CS61584A-IQ3Z | IC LINE INTERFACE T1/E1 64LQFP |
| CS61884-IRZ | IC LN INTERF T1/E1/J1 160-LFBGA |
| CS8130-CS | IC IR TRANSCEIVER 2-5V 20-SSOP |
| CS8190EDWF20G | IC TACH/SPEEDO DRVR PREC 20SOICW |
相關代理商/技術參數 |
參數描述 |
|---|---|
| CS5376A-IQZR | 功能描述:特殊用途放大器 LP Multi-Ch. Decimation Filter RoHS:否 制造商:Texas Instruments 通道數量:Single 共模抑制比（最小值）: 輸入補償電壓: 工作電源電壓:3 V to 5.5 V 電源電流:5 mA 最大功率耗散: 最大工作溫度:+ 70 C 最小工作溫度:- 40 C 安裝風格:SMD/SMT 封裝 / 箱體:QFN-20 封裝:Reel |
| CS5376-BQ | 制造商:Rochester Electronics LLC 功能描述:- Bulk |
| CS5378 | 制造商:CIRRUS 制造商全稱:Cirrus Logic 功能描述:Low-power Single-channel Decimation Filter |
| CS5378_08 | 制造商:CIRRUS 制造商全稱:Cirrus Logic 功能描述:Low-power Single-channel Decimation Filter |
| CS5378-IS | 功能描述:特殊用途放大器 IC LP Single-Ch Decimation Filter RoHS:否 制造商:Texas Instruments 通道數量:Single 共模抑制比（最小值）: 輸入補償電壓: 工作電源電壓:3 V to 5.5 V 電源電流:5 mA 最大功率耗散: 最大工作溫度:+ 70 C 最小工作溫度:- 40 C 安裝風格:SMD/SMT 封裝 / 箱體:QFN-20 封裝:Reel |
發布緊急采購，3分鐘左右您將得到回復。