![](http://datasheet.mmic.net.cn/Atmel/AT32AP7000-CTUR_datasheet_96418/AT32AP7000-CTUR_288.png)
288
2545T–AVR–05/11
ATmega48/88/168
Note:
1. The default value of SUT1..0 results in maximum start-up time for the default clock source.
2. The default setting of CKSEL3..0 results in internal RC oscillator @ 8MHz. See
Table 9-8 onThe status of the fuse bits is not affected by chip erase. Note that the fuse bits are locked if lock
bit1 (LB1) is programmed. Program the fuse bits before programming the lock bits.
28.2.1
Latching of fuses
The fuse values are latched when the device enters programming mode and changes of the
fuse values will have no effect until the part leaves Programming mode. This does not apply to
the EESAVE Fuse which will take effect once it is programmed. The fuses are also latched on
Power-up in Normal mode.
28.3
Signature bytes
All Atmel microcontrollers have a three-byte signature code which identifies the device. This
code can be read in both serial and parallel mode, also when the device is locked. The three
bytes reside in a separate address space. For the Atmel ATmega48/88/168 the signature bytes
28.4
Calibration byte
The ATmega48/88/168 has a byte calibration value for the internal RC Oscillator. This byte
resides in the high byte of address 0x000 in the signature address space. During reset, this byte
is automatically written into the OSCCAL Register to ensure correct frequency of the calibrated
RC Oscillator.
Table 28-7.
Fuse low byte.
Low fuse byte
Bit no.
Description
Default value
7
Divide clock by 8
0 (programmed)
6
Clock output
1 (unprogrammed)
SUT1
5
Select start-up time
SUT0
4
Select start-up time
CKSEL3
3
Select clock source
CKSEL2
2
Select clock source
CKSEL1
1
Select clock source
CKSEL0
0
Select clock source
Table 28-8.
Device ID.
Part
Signature bytes address
0x000
0x001
0x002
ATmega48
0x1E
0x92
0x05
ATmega88
0x1E
0x93
0x0A
ATmega168
0x1E
0x94
0x06