- 您現在的位置：買賣IC網 > PDF目錄1900 > ADSP-BF547YBCZ-4A (Analog Devices Inc)IC DSP BLACKFIN 400MHZ 400CSPBGA PDF資料下載
參數資料
| 型號： | ADSP-BF547YBCZ-4A |
| 廠商： | Analog Devices Inc |
| 文件頁數： | 27/100頁 |
| 文件大小： | 0K |
| 描述： | IC DSP BLACKFIN 400MHZ 400CSPBGA |
| 標準包裝： | 1 |
| 系列： | Blackfin® |
| 類型： | 定點 |
| 接口： | SPI，SSP，TWI，UART，USB |
| 時鐘速率： | 400MHz |
| 非易失內存： | 外部 |
| 芯片上RAM： | 260kB |
| 電壓 - 輸入/輸出： | 2.50V，3.30V |
| 電壓 - 核心： | 1.25V |
| 工作溫度： | -40°C ~ 105°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 400-LFBGA，CSPBGA |
| 供應商設備封裝： | 400-CSPBGA（17x17） |
| 包裝： | 托盤 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁當前第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁
Rev. D
|
Page 32 of 100
|
May 2011
ADSP-BF542/ADSP-BF544/ADSP-BF547/ADSP-BF548/ADSP-BF549
Supplies
VDDINT
P
Internal Power Supply
VDDEXT
12
P
External Power Supply
VDDDDR
P
External DDR Power Supply
VDDUSB
P
External USB Power Supply
VDDRTC
P
RTC Clock Supply
VDDVR
13
P
Internal Voltage Regulator Power Supply (Connect to VDDEXT
when unused.)
GND
G
Ground
VDDMP
P
MXVR PLL Power Supply. (Must be driven to same level as VDDINT. Connect
to VDDINT when unused or when MXVR is not present.)
GNDMP
G
MXVR PLL Ground (Connect to GND when unused or when MXVR is not
present.)
1 I = Input, O = Output, P =Power, G = Ground, C = Crystal, A = Analog.
2 Refer to Table 62 on Page 86 through Table 71 on Page 87 for driver types.
3 To use the SPI memory boot, SPI0SCK should have a pulldown, SPI0MISO should have a pullup, and SPI0SEL1 is used as the CS with a pullup.
4 HWAIT/HWAITA should be pulled high or low to configure polarity. See Booting Modes on Page 18.
5 GPW functionality is available when MXVR is not present or unused.
6 This pin should not be used as GPIO if booting in mode 1.
7 This pin should always be enabled as ND_CE in software and pulled high with a resistor when using NAND flash.
8 This pin should always be enabled as BR in software and pulled high to enable asynchronous access.
9 This pin must be pulled low through a 10kOhm resistor if self-refresh mode is desired during hibernate state or deep-sleep mode.
10If the USB is used in device mode only, the USB_ID pin should be either pulled high or left unconnected.
11This pin is an output only during initialization of USB OTG session request pulses in peripheral mode. Therefore, host mode or OTG type A mode requires that an external
voltage source of 5 V, at 8 mA or more per the OTG specification, be applied to this pin. Other OTG modes require that this external voltage be disabled.
12To ensure proper operation, the power pins should be driven to their specified level even if the associated peripheral is not used in the application.
13This pin must always be connected. If the internal voltage regulator is not being used, this pin may be connected to V
DDEXT. Otherwise it should be powered according to the
VDDVR specification. For automotive grade models, the internal voltage regulator must not be used and this pin must be tied to VDDEXT.
Table 11. Pin Descriptions
(Continued)
Pin Name
I/O
1 Function (First/Second/Third/Fourth)
Driver
Type
2
相關PDF資料 |
PDF描述 |
|---|---|
| ADSP-BF592BCPZ | IC DSP CTRLR 64LFCSP |
| ADSP-TS101SAB1-100 | IC DSP CTRLR 128BIT BUS 625BGA |
| ADSP-TS201SYBP-050 | IC PROCESSOR 500MHZ 576-SBGA |
| ADSP-TS202SABPZ050 | IC PROCESSOR 500MHZ 576BGA |
| ADSP-TS203SABP-050 | IC DSP FLOAT/FIXED 500MHZ 576BGA |
相關代理商/技術參數 |
參數描述 |
|---|---|
| ADSP-BF548BBCZ | 制造商:Analog Devices 功能描述: |
| ADSP-BF548BBCZ-5A | 功能描述:IC DSP 16BIT 533MHZ 400CSBGA RoHS:是 類別:集成電路 (IC) >> 嵌入式 - DSP（數字式信號處理器） 系列:Blackfin® 標準包裝:40 系列:TMS320DM64x, DaVinci™ 類型:定點 接口:I²C，McASP，McBSP 時鐘速率:400MHz 非易失內存:外部 芯片上RAM:160kB 電壓 - 輸入/輸出:3.30V 電壓 - 核心:1.20V 工作溫度:0°C ~ 90°C 安裝類型:表面貼裝 封裝/外殼:548-BBGA，F(xiàn)CBGA 供應商設備封裝:548-FCBGA（27x27） 包裝:托盤 配用:TMDSDMK642-0E-ND - DEVELPER KIT W/NTSC CAMERA296-23038-ND - DSP STARTER KIT FOR TMS320C6416296-23059-ND - FLASHBURN PORTING KIT296-23058-ND - EVAL MODULE FOR DM642TMDSDMK642-ND - DEVELOPER KIT W/NTSC CAMERA |
| ADSP-BF548BBCZ-5AA | 功能描述:IC DSP 16BIT 533MHZ 400CSBGA 制造商:analog devices inc. 系列:Blackfin? 包裝:托盤 零件狀態:有效 類型:定點 接口:CAN，SPI，SSP，TWI，UART，USB 時鐘速率:533MHz 非易失性存儲器:外部 片載 RAM:260kB 電壓 - I/O:2.50V，3.30V 電壓 - 內核:1.25V 工作溫度:-40°C ~ 85°C（TA） 安裝類型:表面貼裝 封裝/外殼:400-LFBGA，CSPBGA 供應商器件封裝:400-CSPBGA（17x17） 標準包裝:1 |
| ADSP-BF548BBCZ-5X | 制造商:Analog Devices 功能描述:- Trays |
| ADSP-BF548MBBCZ-5M | 功能描述:IC DSP 533MHZ W/DDR 400CSPBGA RoHS:是 類別:集成電路 (IC) >> 嵌入式 - DSP（數字式信號處理器） 系列:Blackfin® 標準包裝:40 系列:TMS320DM64x, DaVinci™ 類型:定點 接口:I²C，McASP，McBSP 時鐘速率:400MHz 非易失內存:外部 芯片上RAM:160kB 電壓 - 輸入/輸出:3.30V 電壓 - 核心:1.20V 工作溫度:0°C ~ 90°C 安裝類型:表面貼裝 封裝/外殼:548-BBGA，F(xiàn)CBGA 供應商設備封裝:548-FCBGA（27x27） 包裝:托盤 配用:TMDSDMK642-0E-ND - DEVELPER KIT W/NTSC CAMERA296-23038-ND - DSP STARTER KIT FOR TMS320C6416296-23059-ND - FLASHBURN PORTING KIT296-23058-ND - EVAL MODULE FOR DM642TMDSDMK642-ND - DEVELOPER KIT W/NTSC CAMERA |
發布緊急采購，3分鐘左右您將得到回復。