- 您現在的位置：買賣IC網 > PDF目錄375240 > AD7856ARS (ANALOG DEVICES INC) 5 V Single Supply, 8-Channel 14-Bit 285 kSPS Sampling ADC PDF資料下載
參數資料
| 型號： | AD7856ARS |
| 廠商： | ANALOG DEVICES INC |
| 元件分類： | ADC |
| 英文描述： | 5 V Single Supply, 8-Channel 14-Bit 285 kSPS Sampling ADC |
| 中文描述： | 8-CH 14-BIT SUCCESSIVE APPROXIMATION ADC, SERIAL ACCESS, PDSO24 |
| 封裝： | SHRINK, SOP-24 |
| 文件頁數： | 30/32頁 |
| 文件大小： | 294K |
| 代理商： | AD7856ARS |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁當前第30頁第31頁第32頁
AD7856
–30–
REV. A
Avoid running digital lines under the device as these will couple
noise onto the die. The analog ground plane should be allowed
to run under the AD7856 to avoid noise coupling. The power
supply lines to the AD7856 should use as large a trace as pos-
sible to provide low impedance paths and reduce the effects of
glitches on the power supply line. Fast switching signals like
clocks should be shielded with digital ground to avoid radiating
noise to other sections of the board, and clock signals should
never be run near the analog inputs. Avoid crossover of digital
and analog signals. Traces on opposite sides of the board should
run at right angles to each other. This will reduce the effects of
feedthrough through the board. A microstrip technique is by far
the best, but is not always possible with a double-sided board.
In this technique, the component side of the board is dedicated
to ground planes while signals are placed on the solder side.
Good decoupling is also important. All analog supplies should
be decoupled with 10
μ
F tantalum in parallel with 0.1
μ
F ca-
pacitors to AGND. All digital supplies should have a 0.1
μ
F
disc ceramic capacitor to AGND. To achieve the best from
these decoupling components, they must be placed as close as
possible to the device, ideally right up against the device. In
systems where a common supply voltage is used to drive both
the AV
DD
and DV
DD
of the AD7856, it is recommended that
the system’s AV
DD
supply be used. In this case there should be a
10
resistor between the AV
DD
pin and DV
DD
pin. This supply
should have the recommended analog supply decoupling capaci-
tors between the AV
DD
pin of the AD7856 and AGND and the
recommended digital supply decoupling capacitor between the
DV
DD
pin of the AD7856 and DGND.
Evaluating the AD7856 Performance
The recommended layout for the AD7856 is outlined in the
evaluation board for the AD7856. The evaluation board pack-
age includes a fully assembled and tested evaluation board,
documentation and software for controlling the board from the
PC via the EVAL-CONTROL BOARD. The EVAL-CON-
TROL BOARD can be used in conjunction with the AD7856
Evaluation board, as well as many other Analog Devices evalua-
tion boards ending in the CB designator, to demonstrate/evalu-
ate the ac and dc performance of the AD7856.
The software allows the user to perform ac (fast Fourier trans-
form) and dc (histogram of codes) tests on the AD7856. It also
gives full access to all the AD7856 on-chip registers allowing for
various calibration and power-down options to be programmed.
AD785x Family
12 bits, 200kSPS, 3.0V to 5.5V:
AD7853 – Single-Channel Serial
AD7854 – Single-Channel Parallel
AD7858 – 8-Channel Serial
AD7859 – 8-Channel Parallel
14 bits, 333 kSPS, 4.75 V to 5.25 V:
AD7851 – Single-Channel Serial
相關PDF資料 |
PDF描述 |
|---|---|
| AD7856KR | 5 V Single Supply, 8-Channel 14-Bit 285 kSPS Sampling ADC |
| AD7856 | 8-Channel 14 Bit 285 kSPS Sampling ADC(單電源,8通道14位采樣A/D轉換器) |
| AD7858L | 3 V to 5 V Single Supply, 200 kSPS 8-Channel, 12-Bit Sampling ADC(單電源,200kSPS 8通道12位采樣A/D轉換器) |
| AD7858 | 3 V to 5 V Single Supply, 200 kSPS 8-Channel, 12-Bit Sampling ADC(單電源,200kSPS 8通道12位采樣A/D轉換器) |
| AD7859AP | 3 V to 5 V Single Supply, 200 kSPS 8-Channel, 12-Bit Sampling ADCs |
相關代理商/技術參數 |
參數描述 |
|---|---|
| AD7856ARS-REEL | 制造商:Analog Devices 功能描述:ADC Single SAR 285ksps 14-bit Serial 24-Pin SSOP T/R |
| AD7856ARS-REEL7 | 制造商:Analog Devices 功能描述:ADC Single SAR 285ksps 14-bit Serial 24-Pin SSOP T/R |
| AD7856ARSZ | 功能描述:IC ADC 14BIT 8CHAN 5V 24SSOP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 其它有關文件:TSA1204 View All Specifications 標準包裝:1 系列:- 位數:12 采樣率（每秒）:20M 數據接口:并聯 轉換器數目:2 功率耗散（最大）:155mW 電壓電源:模擬和數字 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:48-TQFP 供應商設備封裝:48-TQFP（7x7） 包裝:Digi-Reel® 輸入數目和類型:4 個單端，單極；2 個差分，單極 產品目錄頁面:1156 (CN2011-ZH PDF) 其它名稱:497-5435-6 |
| AD7856ARSZ-REEL7 | 功能描述:IC ADC 14BIT 8CHAN 5V 24SSOP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1,000 系列:- 位數:12 采樣率（每秒）:300k 數據接口:并聯 轉換器數目:1 功率耗散（最大）:75mW 電壓電源:單電源 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:24-SOIC（0.295"，7.50mm 寬） 供應商設備封裝:24-SOIC 包裝:帶卷 (TR) 輸入數目和類型:1 個單端，單極；1 個單端，雙極 |
| AD7856ARZ | 功能描述:IC ADC 14BIT 8CHAN 5V 24SOIC RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 其它有關文件:TSA1204 View All Specifications 標準包裝:1 系列:- 位數:12 采樣率（每秒）:20M 數據接口:并聯 轉換器數目:2 功率耗散（最大）:155mW 電壓電源:模擬和數字 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:48-TQFP 供應商設備封裝:48-TQFP（7x7） 包裝:Digi-Reel® 輸入數目和類型:4 個單端，單極；2 個差分，單極 產品目錄頁面:1156 (CN2011-ZH PDF) 其它名稱:497-5435-6 |
發布緊急采購，3分鐘左右您將得到回復。