REV. 1.2.2 UNIVERSAL (3.3V AND 5V) PCI BUS QUAD UART 39 Interrupt Generation: LSR is by any of the LSR bits 1, 2, 3 and 4. RXRDY " />
參數資料
型號： XR17D154CV-0A-EVB
廠商： Exar Corporation
文件頁數： 33/69頁
文件大?。?/td> 0K
描述： EVAL BOARD FOR XR17D154 144TQFP
標準包裝： 1
系列： *
xr
XR17D154
REV. 1.2.2
UNIVERSAL (3.3V AND 5V) PCI BUS QUAD UART
39
Interrupt Generation:
LSR is by any of the LSR bits 1, 2, 3 and 4.
RXRDY is by RX trigger level.
RXRDY Time-out is by the a 4-char plus 12 bits delay timer if the RX FIFO level is less than the RX trigger
level.
TXRDY is by LSR bit-5 (or bit-6 in auto RS485 control).
MSR is by any of the MSR bits, 0, 1, 2 and 3.
Receive Xon/Xoff/Special character is by detection of a Xon, Xoff or Special character.
CTS#/DSR# is by a change of state on the input pin (from LOW to HIGH) with auto flow control enabled,
EFR bit-7, and depending on selection of MCR bit-2.
RTS#/DTR# is when its receiver changes the state of the output pin (from LOW to HIGH) during auto RTS/
DTR flow control enabled by EFR bit-6 and selection of MCR bit-2.
Wake-up Indicator: when the UART comes out of sleep mode.
Interrupt Clearing:
LSR interrupt is cleared by a read to the LSR register.
RXRDY is cleared by reading data until FIFO falls below the trigger level.
RXRDY Time-out is cleared by reading data until the RX FIFO is empty.
TXRDY interrupt is cleared by a read to the ISR register.
MSR interrupt is cleared by a read to the MSR register.
Xon or Xoff character interrupt is cleared by a read to ISR register.
Special character interrupt is cleared by a read to ISR register or after the next character is received.
RTS#/DTR# and CTS#/DSR# status change interrupts are cleared by a read to the MSR register.
Wake-up Indicator is cleared by a read to the INT0 register.
]
ISR[0]: Interrupt Status
Logic 0 = An interrupt is pending and the ISR contents may be used as a pointer to the appropriate interrupt
service routine.
Logic 1 = No interrupt pending (default condition).
ISR[3:1]: Interrupt Status
These bits indicate the source for a pending interrupt at interrupt priority levels 1, 2, 3 and 4 (See Interrupt
Source Table 14).
TABLE 14: INTERRUPT SOURCE AND PRIORITY LEVEL
PRIORITY
ISR REGISTER STATUS BITS
SOURCE OF THE INTERRUPT
LEVEL
BIT-5
BIT-4
BIT-3
BIT-2
BIT-1
BIT-0
1
0
1
0
LSR (Receiver Line Status Register)
2
0
1
0
RXRDY (Received Data Ready)
3
0
1
0
RXRDY (Receive Data Time-out)
4
0
1
0
TXRDY (Transmitter Holding Register Empty)
5
0
MSR (Modem Status Register)
6
0
1
0
RXRDY (Received Xon/Xoff or Special character)
7
1
0
CTS#/DSR#, RTS#/DTR# change of state
X
0
1
None (default)
相關PDF資料
PDF描述
ECM22DCST CONN EDGECARD 44POS DIP .156 SLD
5349565-9 FOMM50 LEAD 2.5 TZ SC/PC-SC/PC
CM322522-R22ML INDUCTOR 220NH 360MA SMD
2-6374659-0 C/A LC TO LC MM 2.0MM 20M1
CDRH125/LDNP-330MC POWER INDUCTOR 33UH 2.6A SMD
相關代理商/技術參數
參數描述
XR17D154CV-F 功能描述:UART 接口集成電路 3.3V-5V 64B FIFO temp 0C to 70C; UART RoHS:否 制造商:Texas Instruments 通道數量:2 數據速率:3 Mbps 電源電壓-最大:3.6 V 電源電壓-最小:2.7 V 電源電流:20 mA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 封裝 / 箱體:LQFP-48 封裝:Reel
XR17D154CVTR-F 制造商:Exar Corporation 功能描述:UART 4-CH 64Byte FIFO 3.3V/5V 144-Pin LQFP T/R 制造商:Exar Corporation 功能描述:XR17D154CVTR-F
XR17D154IV 功能描述:UART 接口集成電路 UART RoHS:否 制造商:Texas Instruments 通道數量:2 數據速率:3 Mbps 電源電壓-最大:3.6 V 電源電壓-最小:2.7 V 電源電流:20 mA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 封裝 / 箱體:LQFP-48 封裝:Reel
XR17D154IV-F 功能描述:UART 接口集成電路 3.3V-5V 64B FIFO temp -45 to 85C;UART RoHS:否 制造商:Texas Instruments 通道數量:2 數據速率:3 Mbps 電源電壓-最大:3.6 V 電源電壓-最小:2.7 V 電源電流:20 mA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 封裝 / 箱體:LQFP-48 封裝:Reel
XR17D154IVTR-F 制造商:Exar Corporation 功能描述:UART 4-CH 64Byte FIFO 3.3V/5V 144-Pin LQFP T/R 制造商:Exar Corporation 功能描述:XR17D154IVTR-F
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*