參數資料
型號： XR17D152CM-F
廠商： Exar Corporation
文件頁數： 20/68頁
文件大?。?/td> 0K
描述： IC UART PCI BUS DUAL 100TQFP
產品培訓模塊： UART Product Overview
標準包裝： 90
特點： *
通道數： 2，DUART
FIFO's： 64 字節
規程： RS485
電源電壓： 3.3V，5V
帶自動流量控制功能： 是
帶IrDA 編碼器/解碼器： 是
帶故障啟動位檢測功能： 是
帶調制解調器控制功能： 是
安裝類型： 表面貼裝
封裝/外殼： 100-TQFP
供應商設備封裝： 100-TQFP（14x14）
包裝： 托盤
其它名稱： 1016-1288
á
XR17D152
REV. 1.2.0
UNIVERSAL (3.3V AND 5V) PCI BUS DUAL UART
27
5.2
Transmitter
The transmitter section comprises of 64 bytes of FIFO, a byte-wide Transmit Holding Register (THR) and an 8-
bit Transmit Shift Register (TSR). THR receives a data byte from the host (non-FIFO mode) or a data byte from
the FIFO when the FIFO is enabled by FCR bit-0. TSR shifts out every data bit with the 16X or 8X internal
clock. A bit time is 16 or 8 clock periods. The transmitter sends the start bit followed by the number of data bits,
inserts the proper parity bit if enable, and adds the stop bit(s). The status of the THR and TSR are reported in
the Line Status Register (LSR bit-5 and bit-6).
5.2.1
Transmit Holding Register (THR) - Write-Only
The Transmit Holding Register is an 8-bit register providing a data interface to the host processor. The host
writes transmit data byte to the THR to be converted into a serial data stream including start-bit, data bits,
parity-bit and stop-bit(s). The least-significant-bit (Bit-0) becomes first data bit to go out. The THR is also the
input register to the transmit FIFO of 64 bytes when FIFO operation is enabled by FCR bit-0. A THR empty
interrupt can be generated when it is enabled in IER bit-1.
5.2.2
Transmitter Operation in non-FIFO mode
The host loads transmit data to THR one character at a time. The THR empty flag (LSR bit-5) is set when the
data byte is transferred to TSR. THR flag can generate a transmit empty interrupt (ISR bit-1) when it is enabled
by IER bit-1. The TSR flag (LSR bit-6) is set when TSR becomes completely empty.
5.2.3
Transmitter Operation in FIFO mode
The host may fill the transmit FIFO with up to 64 bytes of transmit data. The THR empty flag (LSR bit-5) is set
whenever the FIFO is empty. The THR empty flag can generate a transmit empty interrupt (ISR bit-1) when the
amount of data in the FIFO falls below its programmed trigger level (see TXTRG register). The transmit empty
interrupt is enabled by IER bit-1. The TSR flag (LSR bit-6) is set when TSR becomes completely empty.
Furthermore, with the RS485 half-duplex direction control enabled (FCTR bit-5=1) the source of the transmit
empty interrupt changes to TSR empty instead of THR empty. This is to ensure the RTS# output is not
changed until the last stop bit of the last character is shifted out.
5.2.4
Auto RS485 Operation
The auto RS485 half-duplex direction control changes the behavior of the transmitter when enabled during
powerup or reset by the EN485# pin or in software by FCTR bit-5. While transmitting, the RTS# or DTR# signal
is HIGH. The RTS# or DTR# signal changes from a HIGH to a LOW after a specified delay indicated in
MSR[7:4] following the last stop bit of the last character that has been transmitted. This helps in turning around
the transceiver to receive the remote station’s response. The delay optimizes the time needed for the last
transmission to reach the farthest station on a long cable network before switching off the line driver. This delay
prevents undesirable line signal disturbance that causes signal degradation. It also changes the transmitter
empty interrupt to TSR empty instead of THR empty.
FIGURE 12. TRANSMITTER OPERATION IN NON-FIFO MODE
T rans m it
H o ld in g
R e g ister
(T HR)
T rans m it Shift R egis ter (T S R )
Da ta
By te
L
S
B
M
S
B
T H R In te r ru p t (IS R b it-1 )
E nabled by IE R bit-1
TXN O FIFO 1
16X or 8X
Clo c k
(8 X M O D E
R e g ister )
相關PDF資料
PDF描述
XR17D154CV-F IC UART PCI BUS QUAD 144LQFP
XR17D158IV-F IC UART PCI BUS OCTAL 144LQFP
XR17V252IM IC UART PCI BUS DUAL 100TQFP
XR17V254IV-F IC UART PCI BUS QUAD 144LQFP
XR17V258IV-F IC UART PCI BUS OCTAL 144LQFP
相關代理商/技術參數
參數描述
XR17D152CMTR-F 功能描述:UART 接口集成電路 UART RoHS:否 制造商:Texas Instruments 通道數量:2 數據速率:3 Mbps 電源電壓-最大:3.6 V 電源電壓-最小:2.7 V 電源電流:20 mA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 封裝 / 箱體:LQFP-48 封裝:Reel
XR17D152IM 制造商:EXAR 制造商全稱:EXAR 功能描述:UNIVERSAL (3.3V AND 5V) PCI BUS DUAL UART
XR17D152IM-F 功能描述:UART 接口集成電路 UART RoHS:否 制造商:Texas Instruments 通道數量:2 數據速率:3 Mbps 電源電壓-最大:3.6 V 電源電壓-最小:2.7 V 電源電流:20 mA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 封裝 / 箱體:LQFP-48 封裝:Reel
XR17D154 制造商:EXAR 制造商全稱:EXAR 功能描述:UNIVERSAL (3.3V AND 5V) PCI BUS QUAD UART
XR17D154CV 功能描述:UART 接口集成電路 UART RoHS:否 制造商:Texas Instruments 通道數量:2 數據速率:3 Mbps 電源電壓-最大:3.6 V 電源電壓-最小:2.7 V 電源電流:20 mA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 封裝 / 箱體:LQFP-48 封裝:Reel
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*