- 您現在的位置：買賣IC網 > PDF目錄382721 > UDA1380 Stereo audio coder-decoder for MD, CD and MP3 PDF資料下載
參數資料
| 型號： | UDA1380 |
| 英文描述： | Stereo audio coder-decoder for MD, CD and MP3 |
| 中文描述： | 立體聲音頻編碼器，可用于MD，CD和MP3解碼器 |
| 文件頁數： | 20/68頁 |
| 文件大?。?/td> | 278K |
| 代理商： | UDA1380 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁當前第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁
2002 Sep 16
20
Philips Semiconductors
Product specification
Stereo audio coder-decoder
for MD, CD and MP3
UDA1380
8.13
Digital audio data input and output
The supported audio formats for the control modes are:
I
2
S-bus
MSB-justified
LSB-justified, 16 bits
LSB-justified, 18 bits
LSB-justified, 20 bits
LSB-justified, 24 bits (only for the output interface).
The bit clock BCK can be up to 128f
s
, or in other words the
BCK frequency is 128 times the WS frequency or less:
f
BCK
≤
128f
WS
Remark
: The WS edge must coincide with the negative
edge of the BCK at all times, for proper operation of the
digital I/O data interface. Figure 13 shows the interface
signals.
8.13.1
D
IGITAL AUDIO INPUT INTERFACE
The digital audio input interface is slave only, meaning the
system must provide the WSI and BCKI signals (next to
the DATAI signal).
Either the WSPLL locks onto the WSI signal and provides
the internal clocks for the interpolator and the FSDAC, or
a system clock must be applied which must be in
frequency lock to the digital data input interface signals.
8.13.2
D
IGITAL AUDIO OUTPUT INTERFACE
The digital audio output interface can be either master or
slave. The data source for the data output can be selected
from either the decimator (ADC front-end) or the digital
mixer output.
Remark:
The digital mixer output is only valid if both the
decimator and the interpolator run at the same clock:
In slave mode the signals on pins BCKO, WSO and
SYSCLK must be applied from the application (signals
must be in frequency lock) and the UDA1380 returns the
DATAO signal from the decimator. The applied signal
from pin BCKO can be for instance: 32f
s
, 48f
s
, 64f
s
,
96f
s
or 128f
s
In master mode the SYSCLK signal must be applied
from the system, but the UDA1380 returns with the
BCKO, WSO and the DATAO signals. For the BCKO
clock, there are 2 general rules:
– When the SYSCLK is either 256f
s
or 512f
s
, the BCKO
frequency is supposed to be 64f
s
– WhentheSYSCLKiseither384f
s
or 768f
s
,theBCKO
signal should be 48f
s
.
The slave and master modes can be selected by the
bit Serial Interface Mode (SIM) in the L3-bus or I
2
C-bus
interface.
9
L3-BUS INTERFACE DESCRIPTION
The UDA1380 has an L3-bus microcontroller
interface mode. Controllable system and digital sound
processing features are:
Software reset
System clock frequency (selection between 256f
s
,
384f
s
, 512f
s
and 768f
s
clock divider settings)
Clock mode setting, for instance, which block runs at
which clock, and clock enabling
Power control for the WSPLL
Data input and data output format control, for input and
output independently including data source selection for
the digital output interface
ADC features:
– Digital mute
– AGC enable and settings
– Polarity control
– Input line amplifier control (0 to 24 dB in steps of
3 dB)
– DC filtering control
– Digital gain control (+24 to
63 dB gain in steps of
0.5 dB) for left and right
– Power control
– VGA of the microphone input
– Selection of line or microphone input
DAC and headphone driver features:
– Power control FSDAC and headphone driver
– Polarity control
– Mixing control (only available when both decimator
and interpolator run at the same speed). This
includes the mixer volumes, mute and mixer position
switch
– De-emphasis control
– Master volume and balance control
– Flat/minimum/maximum settings for the bass boost
and treble
– Tone control: bass boost and treble
– Master mute control
– Headphone driver short-circuit protection status bits.
相關PDF資料 |
PDF描述 |
|---|---|
| UDA1380TT | Stereo audio coder-decoder for MD, CD and MP3 |
| UDA1384 | Multichannel audio coder-decoder |
| UDA1384H | Multichannel audio coder-decoder |
| UDN2878W-2 | 10A SCRS |
| UDZ2.4B | Low Current Operation at 250 ，Low Reverse Leakage,Low Noise Zener Diode |
相關代理商/技術參數 |
參數描述 |
|---|---|
| UDA1380HN | 制造商:ICS 制造商全稱:ICS 功能描述:Stereo audio coder-decoder for MD, CD and MP3 |
| UDA1380HN/N2 | 制造商:NXP Semiconductors 功能描述:IC CODEC AUDIO MINIDISC 32HVQFN 制造商:NXP Semiconductors 功能描述:IC, CODEC, AUDIO, MINIDISC, 32HVQFN |
| UDA1380HN/N2,118 | 功能描述:接口—CODEC STEREO AUDIO RoHS:否 制造商:Texas Instruments 類型: 分辨率: 轉換速率:48 kSPs 接口類型:I2C ADC 數量:2 DAC 數量:4 工作電源電壓:1.8 V, 2.1 V, 2.3 V to 5.5 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:DSBGA-81 封裝:Reel |
| UDA1380HN-T | 功能描述:接口—CODEC STEREO AUDIO CODER-DECODER RoHS:否 制造商:Texas Instruments 類型: 分辨率: 轉換速率:48 kSPs 接口類型:I2C ADC 數量:2 DAC 數量:4 工作電源電壓:1.8 V, 2.1 V, 2.3 V to 5.5 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:DSBGA-81 封裝:Reel |
| UDA1380TT | 功能描述:接口—CODEC SSA CODEC RoHS:否 制造商:Texas Instruments 類型: 分辨率: 轉換速率:48 kSPs 接口類型:I2C ADC 數量:2 DAC 數量:4 工作電源電壓:1.8 V, 2.1 V, 2.3 V to 5.5 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:DSBGA-81 封裝:Reel |
發布緊急采購，3分鐘左右您將得到回復。