參數資料
型號： TMS320VC5409PGE100
廠商： Texas Instruments
文件頁數： 11/93頁
文件大小： 0K
描述： IC DIG SIG PROCESSOR 144-LQFP
標準包裝： 60
系列： TMS320C54x
類型： 定點
接口： 主機接口，McBSP
時鐘速率： 100MHz
非易失內存： ROM（32 kB）
芯片上RAM： 64kB
電壓 - 輸入/輸出： 3.30V
電壓 - 核心： 1.80V
工作溫度： -40°C ~ 100°C
安裝類型： 表面貼裝
封裝/外殼： 144-LQFP
供應商設備封裝： 144-LQFP（20x20）
包裝： 托盤
配用： 296-31413-ND - XDS560 CLASS HIGH SPEED EMULATOR
296-23043-ND - BLACKHAWK XDS560 USB EMULATOR
296-15829-ND - DSP STARTER KIT FOR TMS320C5416
其它名稱： 296-10764
296-10764-5
296-10764-5-ND
Introduction
19
April 1999 Revised October 2008
SPRS082F
Table 22. Terminal Functions (Continued)
TERMINAL
NAME
DESCRIPTION
I/O
INTERNAL
TERMINAL
NAME
DESCRIPTION
I/O
PIN STATE
HOST-PORT INTERFACE SIGNALS (CONTINUED)
HCNTL0
HCNTL1
Pullup
resistor
I
Control. HCNTL0 and HCNTL1 select a host access to one of the three HPI registers. The control
inputs have internal pullup resistors that are only enabled when HPIENA = 0.
HBIL
Pullup
resistor
I
Byte identification. HBIL identifies the first or second byte of transfer. The HBIL input has an internal
pullup resistor that is only enabled when HPIENA = 0.
HCS
Schmitt
trigger/pullup
resistor
I
Chip select. HCS is the select input for the HPI and must be driven low during accesses. The
chip-select input has an internal pullup resistor that is only enabled when HPIENA = 0.
HDS1
HDS2
Schmitt
trigger/pullup
resistor
I
Data strobe. HDS1 and HDS2 are driven by the host read and write strobes to control transfers. The
strobe inputs have internal pullup resistors that are only enabled when HPIENA = 0.
HAS
Schmitt
trigger/pullup
resistor
I
Address strobe. Hosts with multiplexed address and data pins require HAS to latch the address in
the HPIA register. HAS has an internal pullup resistor that is only enabled when HPIENA = 0.
HR/W
Pullup
resistor
I
Read/write. HR/W controls the direction of an HPI transfer. R/W has an internal pullup resistor that
is only enabled when HPIENA = 0.
HRDY
O/Z
Ready. The ready output informs the host when the HPI is ready for the next transfer. HRDY goes
into the high-impedance state when OFF is low.
HINT
O/Z
Interrupt. This output is used to interrupt the host. When the DSP is in reset, HINT is driven high
.
The signal goes into the high-impedance state when OFF is low.
HPIENA
Pulldown
resistor
I
HPI module select. HPIENA must be driven high during reset to enable the HPI. An internal
pulldown resistor is always active and the HPIENA pin is sampled on the rising edge of RS. If
HPIENA is left open or is driven low during reset, the HPI module is disabled. Once the HPI is
disabled, the HPIENA pin has no effect until the 5409 is reset.
HPI16
Pulldown
resistor
I
HPI 16-bit select pin (internal pulldown, default HPI8). HPI16 = 1 selects the non-multiplexed mode.
The non-multiplexed mode allows hosts with separate address/data buses to access the HPI
address range via the 16 address pins (A15–A0). 16-bit data is also accessible through pins D0
through D15. Host-to-DSP and DSP-to-Host interrupts are not supported. There are no HPIC and
HPIA register accesses in the non-multiplexed mode.
The HPI16 pin is sampled at RESET. The user should never change the value of the HPI16 pin while
the RESET signal is HIGH.
SUPPLY PINS
CVDD
S
+VDD. Dedicated 1.8-V power supply for the core CPU
DVDD
S
+VDD. Dedicated 3.3-V power supply for the I/O pins
VSS
S
Ground
I = Input, O = Output, Z = High-impedance, S = Supply
Although this pin includes an internal pulldown resistor, a 470- external pulldown is required. If the TRST pin is connected to multiple DSPs,
a buffer is recommended to ensure the VIL and VIH specifications are met.
相關PDF資料
PDF描述
B530C-13-F DIODE SCHOTTKY 30V 5A SMC
TPSR106K006R3000 CAP TANT 10UF 6.3V 10% 0805
HBM10DRXN CONN EDGECARD 20POS DIP .156 SLD
T491C225K035AH CAP TANT 2.2UF 35V 10% 2312
AP1086K33L-U IC REG LDO 3.3V 1.5A TO-263
相關代理商/技術參數
參數描述
TMS320VC5409PGE100 制造商:Texas Instruments 功能描述:Digital Signal Processor IC
TMS320VC5409PGE-80 功能描述:數字信號處理器和控制器 - DSP, DSC Fixed-Pt Dig Signal Proc RoHS:否 制造商:Microchip Technology 核心:dsPIC 數據總線寬度:16 bit 程序存儲器大小:16 KB 數據 RAM 大小:2 KB 最大時鐘頻率:40 MHz 可編程輸入/輸出端數量:35 定時器數量:3 設備每秒兆指令數:50 MIPs 工作電源電壓:3.3 V 最大工作溫度:+ 85 C 封裝 / 箱體:TQFP-44 安裝風格:SMD/SMT
TMS320VC5409ZGU100 功能描述:數字信號處理器和控制器 - DSP, DSC Fixed-Pt Dig Signal Proc RoHS:否 制造商:Microchip Technology 核心:dsPIC 數據總線寬度:16 bit 程序存儲器大小:16 KB 數據 RAM 大小:2 KB 最大時鐘頻率:40 MHz 可編程輸入/輸出端數量:35 定時器數量:3 設備每秒兆指令數:50 MIPs 工作電源電壓:3.3 V 最大工作溫度:+ 85 C 封裝 / 箱體:TQFP-44 安裝風格:SMD/SMT
TMS320VC5409ZGU-80 功能描述:數字信號處理器和控制器 - DSP, DSC Fixed-Pt Dig Signal Proc RoHS:否 制造商:Microchip Technology 核心:dsPIC 數據總線寬度:16 bit 程序存儲器大小:16 KB 數據 RAM 大小:2 KB 最大時鐘頻率:40 MHz 可編程輸入/輸出端數量:35 定時器數量:3 設備每秒兆指令數:50 MIPs 工作電源電壓:3.3 V 最大工作溫度:+ 85 C 封裝 / 箱體:TQFP-44 安裝風格:SMD/SMT
TMS320VC5410AGGU1 制造商:Rochester Electronics LLC 功能描述:- Bulk 制造商:Texas Instruments 功能描述:
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*