參數資料
型號： SI3019-F-GM
廠商： Silicon Laboratories Inc
文件頁數： 60/128頁
文件大?。?/td> 0K
描述： IC VOICE GLOBAL DAA PROGR 20QFN
標準包裝： 490
系列： *
Si3050 + Si3011/18/19
Rev. 1.5
37
f. Set the OH bit to return to an off-hook state.
Immediately after returning to an off-hook state,
the off-hook counter must be allowed to expire.
This allows the line voltage to settle before
transmitting or receiving data. After 8 ms normal
data transmission and reception can begin. If a
non-compliant parallel device is present, then a
reply tone is not sent by the host tone generator
and the CO does not send the CID data. If all
devices on the line are Type II CID compliant,
then the host must mute its upstream data output
to avoid the propagation of its reply tone and the
subsequent CID data. When muting its upstream
data output, the host processor should return an
acknowledgement (ACK) tone to the CO
requesting transmission of CID data.
3. The CO then responds with CID data after receiving
the CID data, the host processor unmutes the
upstream data output and continues with normal
operation.
4. The muting of the upstream data path by the host
processor mutes the handset in a telephone
application so the user cannot hear the
acknowledgement tone and CID data being sent.
5. The CALD and the RCALD bits can be cleared to
re-enable the automatic calibrations when going
off-hook. The FOH[1:0] bits also can be programmed
to 01 to restore the default off-hook counter time.
Because of the nature of the low-power ADC, the data
presented on DTX can have up to a 10% dc offset. The
caller ID decoder must either use a high-pass or a
band-pass filter to accurately retrieve the caller ID data.
Figure 26. Implementing Type II Caller ID on the Si3050+Si3011/19
5.26. Overload Detection
The Si3050 can be programmed to detect an overload
condition that exceeds the normal operating power
range of the DAA circuit. To use the overload detection
feature, the following steps should be followed:
1. Set the OH bit (Register 5, bit 0) to go off-hook, and
wait 25 ms to allow line transients to settle.
2. Enable overload detection by then setting the OPE
bit (Register 17, bit 3).
If the DAA senses an overload situation it automatically
presents an 800
impedance to the line to reduce the
hookswitch current. At this time, the DAA also sets the
OPD bit (Register 19, bit 0) to indicate that an overload
condition exists. The line current detector within the
DAA has a threshold that is dependent on the ILIM bit
(Register 26). When ILIM = 0, the overload detection
threshold equals 160 mA. When ILIM = 1, the overload
detection threshold equals 60 mA. The OPE bit should
always be cleared before going off-hook.
Notes:
1. The off-hook counter and calibrations prevent transmission or reception of data for 402.75 ms (default) for the line
voltage to settle.
2.
The caller alert signal (CAS) tone transmits from the CO to signal an incoming call.
3.
The device is taken on-hook to read the line voltage in the LVS bits to detect parallel handsets. In this mode, no data is
transmitted on the DTX pin.
4.
When the device returns off-hook, the normal off-hook counter is reduced to 8 ms. If the CALD and RCALD bits are set,
then the automatic calibrations are not performed.
5.
After allowing the off-hook counter to expire (8 ms), normal transmission and reception can continue. If CID data
reception is required, send the appropriate signal to the CO at this time.
LINE
FOH[1] Bit
RCALD
Bit
CALD Bit
1
23
4
5
OH Bit
FOH[0] Bit
On-Hook
Off-H ook C ounter
and C alibration
(402.75 ms nominally)
Of f -Hook
CA S Tone
Rec eiv ed
On-Hook
Off-Hook Counter
(8 ms)
Of f -Hook
A ck
相關PDF資料
PDF描述
SI3063-F-FS IC DAA ENH GLOB LINE-SIDE 16SOIC
SI3066-B-FS IC DAA ENH FCC LINE-SIDE 8SOIC
SI3068-B-FS IC FCC+ EMBEDDED DAA 8SOIC
SI3200-BS IC LINEFEED INTRFC 100V 16SOIC
SI3211-KT IC SLIC/CODEC PROG 1CH 38TSSOP
相關代理商/技術參數
參數描述
SI3019-F-GMR 制造商:Silicon Laboratories Inc 功能描述:SI3050 ENHANCED GLOBAL VOICE DAA LINE-SIDE - LEAD-FREE - Tape and Reel 制造商:Silicon Laboratories Inc 功能描述:IC VOICE GLOBAL DAA PROGR 20QFN
Si3019-F-GS 功能描述:電信線路管理 IC Si3050 Enhncd Global Voice DAA Line-Side RoHS:否 制造商:STMicroelectronics 產品:PHY 接口類型:UART 電源電壓-最大:18 V 電源電壓-最小:8 V 電源電流:30 mA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 安裝風格:SMD/SMT 封裝 / 箱體:VFQFPN-48 封裝:Tray
SI3019-F-GSR 功能描述:電信線路管理 IC Enhanced Global Voice DAA Line-Side RoHS:否 制造商:STMicroelectronics 產品:PHY 接口類型:UART 電源電壓-最大:18 V 電源電壓-最小:8 V 電源電流:30 mA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 安裝風格:SMD/SMT 封裝 / 箱體:VFQFPN-48 封裝:Tray
Si3019-F-GT 功能描述:電信線路管理 IC Si3050 Enhncd Global Voice DAA Line-Side RoHS:否 制造商:STMicroelectronics 產品:PHY 接口類型:UART 電源電壓-最大:18 V 電源電壓-最小:8 V 電源電流:30 mA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 安裝風格:SMD/SMT 封裝 / 箱體:VFQFPN-48 封裝:Tray
SI3019-F-GTR 制造商:Silicon Laboratories Inc 功能描述:SI3050 ENHANCED GLOBAL VOICE DAA LINE-SIDE - LEAD-FREE - Tape and Reel
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*