參數資料
型號: S25FL004AOLMAI001
廠商: Spansion Inc.
英文描述: 4-Megabit CMOS 3.0 Volt Flash Memory with 50 Mhz SPI Bus Interface
中文描述: 4兆位閃存的CMOS 3.0伏,50赫茲SPI總線接口內存
文件頁數: 26/39頁
文件大小: 945K
代理商: S25FL004AOLMAI001
24
S25FL Family (Serial Peripheral Interface) S25FL004A
S25FL004A_00_A1 March 28, 2005
A d v a n c e I n f o r m a t i o n
Figure 13. Sector Erase (SE) Instruction Sequence
Bulk Erase (BE)
The Bulk Erase (BE) instruction sets to
1
(FFh) all bits inside the entire memory.
Before it can be accepted, a Write Enable (WREN) instruction must previously
have been executed. After the Write Enable (WREN) instruction is decoded, the
device sets the Write Enable Latch (WEL).
The Bulk Erase (BE) instruction is entered by driving Chip Select (CS#) Low, fol-
lowed by the instruction code, on Serial Data Input (SI). No address is required
for the Bulk Erase (BE) instruction. Chip Select (CS#) must be driven Low for the
entire sequence duration.
The instruction sequence is shown in
Figure 14, on page 25
.
Chip Select (CS#) must be driven High after the eighth bit of the last address byte
is latched in, otherwise the Bulk Erase (BE) instruction is not executed.
As soon as Chip Select (CS#) is driven High, the self-timed Bulk Erase cycle
(whose duration is t
BE
) is initiated. While the Bulk Erase cycle is in progress, the
Status Register may be read to check the value of the Write In Progress (WIP)
bit. The Write In Progress (WIP) bit is 1 during the self-timed Bulk Erase cycle,
and is 0 when it is completed. At some unspecified time before the cycle is com-
pleted, the Write Enable Latch (WEL) bit is reset.
A Bulk Erase (BE) instruction is executed only if all the Block Protect (BP2, BP1,
BP0) bits (see
Table 2, on page 11
) are set to 0. The Bulk Erase (BE) instruction
is ignored if one or more sectors are protected.
CS#
SCK
SI
MSB
Instruction
24 Bit Address
0
1
2
3
4
5
6
7
8
9
10
28
29
30
31
23 22
21
3
2
1
0
相關PDF資料
PDF描述
S25FL004AOLMAI002 4-Megabit CMOS 3.0 Volt Flash Memory with 50 Mhz SPI Bus Interface
S25FL004AOLMAI003 4-Megabit CMOS 3.0 Volt Flash Memory with 50 Mhz SPI Bus Interface
S25FL004AOLMFI000 4-Megabit CMOS 3.0 Volt Flash Memory with 50 Mhz SPI Bus Interface
S25FL004AOLMFI001 4-Megabit CMOS 3.0 Volt Flash Memory with 50 Mhz SPI Bus Interface
S25FL004AOLMFI002 4-Megabit CMOS 3.0 Volt Flash Memory with 50 Mhz SPI Bus Interface
相關代理商/技術參數
參數描述
S25FL004AOLMAI002 制造商:SPANSION 制造商全稱:SPANSION 功能描述:4-Megabit CMOS 3.0 Volt Flash Memory with 50 Mhz SPI Bus Interface
S25FL004AOLMAI003 制造商:SPANSION 制造商全稱:SPANSION 功能描述:4-Megabit CMOS 3.0 Volt Flash Memory with 50 Mhz SPI Bus Interface
S25FL004AOLMFI000 制造商:SPANSION 制造商全稱:SPANSION 功能描述:4-Megabit CMOS 3.0 Volt Flash Memory with 50 Mhz SPI Bus Interface
S25FL004AOLMFI001 制造商:SPANSION 制造商全稱:SPANSION 功能描述:4-Megabit CMOS 3.0 Volt Flash Memory with 50 Mhz SPI Bus Interface
S25FL004AOLMFI002 制造商:SPANSION 制造商全稱:SPANSION 功能描述:4-Megabit CMOS 3.0 Volt Flash Memory with 50 Mhz SPI Bus Interface