參數(shù)資料
型號: PM2329
英文描述: Telecommunication IC
中文描述: 通信集成電路
文件頁數(shù): 24/162頁
文件大?。?/td> 1581K
代理商: PM2329
Proprietary and Confidential to PMC-Sierra, Inc and for its Customers
Internal Use
Document ID: PMC-2010146, Issue 4
27
PM2329 ClassiPI Network Classification Processor Datasheet
SOE*
U3
1
I
System Output Enable (Active Low)
This signal is driven active low by the Packet Processor
to enable PM2329 data onto the external bus when a
read operation is performed. This signal must be held
high during write cycle.
System Write Enable (Active Low)
SRW*
V2
1
I
If SyncBurst mode is selected, this signal can be tied
permanently low.
If ZBT mode is selected, this signal should be driven
low during a write cycle and held high during a read
cycle.
System Write High Enable (Active Low)
or System Address bit 2
SWHE* {SA[2]}
U4
1
I
In 64-bit mode, this signal is SWHE* and should be
asserted during write cycles to indicate write data
transfers on the upper 32 bits of the System Data Bus
(SD[63:32]).
In 32-bit mode, this signal is connected to the System
Address line #2 of the Packet Processor, and functions
as the SA[2] signal.
System Write Low Enable (Active Low)
SWLE* {SWE*}
W1
1
I
In 64-bit mode, this signal should be asserted during
write cycles to indicate write data transfers on the lower
32 bits of the System Data Bus (SD[31:0]).
In 32-bit mode, this signal should be asserted during
write cycle.
Packet Source Packet Direction
PSPD
E24
1
I
This signal can be used by the PS to indicate the
direction of packet movement (upstream/downstream)
to the PM2329. This signal should indicate the packet
direction during each cycle of packet data transfer after
PSPBA has been asserted. This signal is used in DMA
mode only and should be tied low otherwise.
Packet Source End of Packet
PSEOP
E26
1
I
PS asserts this signal to indicate that the current
packet transfer to the PM2329 is complete. The
PM2329 can now process the completed packet. This
signal is typically connected to the Terminal Count pin
of the DMA device.
This signal is used in DMA mode only and should be
tied low otherwise.
Table 2
System Interface Signals
Signal Name
Ball #
Size
I/O
Description
相關PDF資料
PDF描述
PM239P Analog Comparator
PM30RHC060 TRANSISTOR | IGBT POWER MODULE | 3-PH BRIDGE | 600V V(BR)CES | 30A I(C)
PM3321-QC DATA CROSS CONNECT|LDCC|84PIN|PLASTIC
PM355AJ Voltage-Feedback Operational Amplifier
PM355AZ Voltage-Feedback Operational Amplifier
相關代理商/技術參數(shù)
參數(shù)描述
PM233-155.52M 制造商:CONNOR-WINFIELD 制造商全稱:Connor-Winfield Corporation 功能描述:5.0x7.0mm Surface Mount LVPECL Clock Oscillator Series
PM2379-001 制造商:Delphi Corporation 功能描述:TAPE MARK WHT
PM238 制造商:PURDY 制造商全稱:PURDY 功能描述:AC Fans and Blowers
PM238-115-1751BT-4 制造商:INTERFAN 功能描述:Fan, AC, 115V, 172x150x51mm, Obround, 238CFM, 3100RPM, 55dBA, Terminal Block