Advance Information Page 44 of 114 DEC 2009 REVISION 1.02 3.1 ADDRESS RANGES PI7C8154A uses the" />
參數資料
型號: PI7C8154ANAE
廠商: Pericom
文件頁數: 54/114頁
文件大小: 0K
描述: IC PCI-PCI BRIDGE ASYNC 304-PBGA
標準包裝: 27
系列: *
應用: *
接口: *
電源電壓: *
封裝/外殼: 304-BBGA
供應商設備封裝: 304-PBGA(31x31)
包裝: 管件
安裝類型: 表面貼裝
PI7C8154A
ASYNCHRONOUS 2-PORT
PCI-to-PCI BRIDGE
Advance Information
Page 44 of 114
DEC 2009 REVISION 1.02
3.1
ADDRESS RANGES
PI7C8154A uses the following address ranges that determine which I/O and memory transactions
are forwarded from the primary PCI bus to the secondary PCI bus, and from the secondary bus to
the primary bus:
Two 32-bit I/O address ranges
Two 32-bit memory-mapped I/O (non-prefetchable memory) ranges
Two 32-bit prefetchable memory address ranges
Transactions falling within these ranges are forwarded downstream from the primary PCI bus to the
secondary PCI bus. Transactions falling outside these ranges are forwarded upstream from the
secondary PCI bus to the primary PCI bus.
No address translation is required in PI7C8154A. The addresses that are not marked for
downstream are always forwarded upstream.
3.2
I/O ADDRESS DECODING
PI7C8154A uses the following mechanisms that are defined in the configuration space to specify
the I/O address space for downstream and upstream forwarding:
I/O base and limit address registers
The ISA enable bit
The VGA mode bit
The VGA snoop bit
This section provides information on the I/O address registers and ISA mode Section 3.4 provides
information on the VGA modes.
To enable downstream forwarding of I/O transactions, the I/O enable bit must be set in the
command register in configuration space. All I/O transactions initiated on the primary bus will be
ignored if the I/O enable bit is not set. To enable upstream forwarding of I/O transactions, the
master enable bit must be set in the command register. If the master-enable bit is not set,
PI7C8154A ignores all I/O and memory transactions initiated on the secondary bus.
The master-enable bit also allows upstream forwarding of memory transactions if it is set.
CAUTION
If any configuration state affecting I/O transaction forwarding is changed by a configuration write
operation on the primary bus at the same time that I/O transactions are ongoing on the secondary
bus, PI7C8154A response to the secondary bus I/O transactions is not predictable. Configure the
I/O base and limit address registers, ISA enable bit, VGA mode bit, and VGA snoop bit before
setting I/O enable and master enable bits, and change them subsequently only when the primary
and secondary PCI buses are idle.
相關PDF資料
PDF描述
PI7C8154BNAIE IC PCI-PCI BRIDGE ASYNC 304-PBGA
PI7C9X110BNBE IC PCIE TO PCI REV BRG 160LFBGA
PI7C9X130DNDE IC PCIE-PCIX BRIDGE 1PORT 256BGA
PI7C9X20303SLCFDE IC PCIE PACKET SWITCH 128LQFP
PI7C9X20303ULAZPE IC PCIE PACKET SWITCH 132TQFN
相關代理商/技術參數
參數描述
PI7C8154ANAE-33 功能描述:外圍驅動器與原件 - PCI 64B/66MHz 2 Port PCI Bridge RoHS:否 制造商:PLX Technology 工作電源電壓: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:FCBGA-1156 封裝:Tray
PI7C8154B 制造商:PERICOM 制造商全稱:Pericom Semiconductor Corporation 功能描述:2 PORT 64 BIT 66MHZ PCI TO PCI BRIDGE
PI7C8154BNA 制造商:Pericom Semiconductor Corporation 功能描述:
PI7C8154BNAE 功能描述:外圍驅動器與原件 - PCI 64B/66MHz 2 Port PCI Bridge RoHS:否 制造商:PLX Technology 工作電源電壓: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:FCBGA-1156 封裝:Tray
PI7C8154BNAE-80 功能描述:外圍驅動器與原件 - PCI 64B/66MHz 2 Port PCI Bridge RoHS:否 制造商:PLX Technology 工作電源電壓: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:FCBGA-1156 封裝:Tray